ページ1に含まれる内容の要旨
The Ultimate Portable
Garage Air Compressor
Operating Instructions and Parts Manual
WL6700 Series
Fa r na ç ie s : P age F- r 1
es Pa:loñ Página P s -1
MAKES IT EASY TO DO IT LIKE A PRO
Visit us at chpower.com
© 2009 Campbell Hausfeld/Scott Fetzer IN629500AV 4/09
ページ2に含まれる内容の要旨
Table of Contents Description 3 Grounding Instructions . . . . . . . . . . . . 11 Specifications 3 Wiring . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Safety Guidelines 4 Operation 12 Safety Symbols 4 Lubrication . . . . . . . . . . . . . .
ページ3に含まれる内容の要旨
Operating Instructions and Parts Manual The Ultimate Portable Garage Air Compressor Description Oilless compressors are designed for do-it-yourselfers with a variety of home and Specifications automotive jobs. These compressors power spray guns, impact wrenches and other tools. These units operate without oil. WL6700 Series Running HP: 1 7 (ISO 1217) Free Air CFM: 3 8 @ 90 psi (ISO 1217) Free Air CFM: 5 6 @ 40 psi (ISO 1217) Tank Capacity (gallons): 18, 22, 26, or 30 Volts, Phas
ページ4に含まれる内容の要旨
Operating Instructions and Parts Manual Important Safety Information In Stru Ct Ion S Pert AIn Ing to A rIS k o F FIre, eLeCtr IC Sho Ck, or Injury Safety Guidelines to Per Son S This manual contains information This manual contains important safety, operational and maintenance information. If that is very important to know and you have any questions, please call 1-800-543-6400 for customer assistance. understand. This information is provided for SAFETY and to PREVENT Since the air compres
ページ5に含まれる内容の要旨
WL6700 Series Important Safety Information (Continued) Work Are A eLeCtr ICAL SAFety Risk of electrical shock. Always a. Keep the work area clean and well lighted. Cluttered disconnect from power source before benches and dark areas increase the risks of electric shock, servicing. Servicing should be performed by authorized fire, and injury to persons. service center. b. Keep bystanders, children, and visitors away while uS e An D CAre operating. Distractions are able to result in the
ページ6に含まれる内容の要旨
Operating Instructions and Parts Manual Important Safety Information (Continued) SPr Ay Ing Pre CAut Ion S Do not spray flammable materials in vicinity of open flame or near ignition sources including the compressor unit. a. Do not smoke when spraying paint, insecticides, or other flammable substances. b. Use a face mask/respirator when spraying and spray in a well ventilated area to prevent health and fire hazards. c. Do not direct paint or other sprayed material at the compressor. Locate
ページ7に含まれる内容の要旨
WL6700 Series Unpacking After unpacking the unit, inspect carefully for any damage that may have occurred during transit. Check for loose, missing or damaged parts. Make sure to tighten fittings, bolts, etc., before putting unit into service. Check to be sure all supplied accessories are enclosed with the unit. In case of questions, damaged or missing parts, please call 1-800-543-6400 for customer assistance. Self-tapping screws u Do not operate unit if damaged during shipping, handl
ページ8に含まれる内容の要旨
Operating Instructions and Parts Manual Glossary Become familiar with these terms before operating the unit. AIR DEl IVERY - A combination of psi and SCFM. The air delivery required by a tool is stated as (number) SCFM at (number) psi. The combination of these figures determines what size unit is needed. AIR TANK CAPACITY - The volume of air stored in the tank and available for immediate use. A large tank allows the intermittent use of an air tool with an air requirement higher than the comp
ページ9に含まれる内容の要旨
WL6700 Series U Gn et pta in cg k iT no g Know Your Compressor r eCo MMen DeD uS eS For th IS Co MPre SSor Outlet (tool) u Auto maintenance pressure gauge u Auto restoration u Fastening u Home maintenance Click-to-set regulator u Inflation u Woodworking Power cord clip Coupler t oo L r eCo MMen DAt Ion For th IS Co MPre SSor Continuous u se — Inflation accessories Airbrush Power Foot pedal ON/OFF switch Air screwdrivers cord Brad nailers and Staplers Caulk guns Engine cleaners Finish nailer
ページ10に含まれる内容の要旨
Operating Instructions and Parts Manual Assembly t oo LS r equ Ire D For A SSeMbLy u Ratchet with 3/8 inch Socket u (2) Wrenches hA n DLe ASSeMbLy 1. Slide handle into shroud holes, making sure handle is on the outside of the bracket and the holes of the handle line up with the holes of the tank bracket. Figure 9 - handle assembly 2. Insert screws through handle and then the bracket. Using a ratchet with 3/8 inch socket, tighten screws to hold the handle in place. In FLAt Ion h o Se ASSe
ページ11に含まれる内容の要旨
WL6700 Series Installation Lo CAt Ion When assembled, the tank must sit level to allow the tank to drain properly. It is extremely important to install the compressor in a clean, well ventilated area where the surrounding air temperature will not be more than 100°F. Disengaged A minimum clearance of 18 inches between the compressor and a wall is required because objects could obstruct air flow. Do not locate the compressor air inlet near steam, paint spray, sandblast Engaged areas or any
ページ12に含まれる内容の要旨
Operating Instructions and Parts Manual Installation (Continued) WIr Ing Storage Trays Outlet (Tool) 1. Local electrical wiring codes differ from area to area. Source Pressure Gauge wiring, plug and protector must be rated for at least the amperage and voltage indicated on motor nameplate, and meet all electrical codes for this minimum. 2. Use a slow blow fuse or a circuit breaker. Overheating, short circuiting and fire damage will result from inadequate wiring, etc. NOTE: 120 volt, 15 am
ページ13に含まれる内容の要旨
WL6700 Series Operation (Continued) ASMe SAFety V ALVe r eassembly If you do turn the regulator knob too far past minimum Do not remove or attempt to adjust the safety valve! operation setting ( counterclockwise) and the knob does come off, use these steps to reassemble the regulator: This valve should be checked under pressure occasionally by pulling the ring by hand (See Figure 13). If air leaks after ring has 1. Align the spring into central position. been released, or valve is stuck an
ページ14に含まれる内容の要旨
Operating Instructions and Parts Manual Operation (Continued) rAPID In FLAt Ion t eChno Logy™ (r It ) When the compressor is used in the RIT mode, the air being produced from the compressor pump will go directly to the recoil hose which is attached to the bottom of the compressor (See Figure 15). This will eliminate waiting for the compressor tank to fill up, allowing for significantly faster inflation. Instant air hose will get hot while the compressor is on and during the inflation pro
ページ15に含まれる内容の要旨
WL6700 Series Operation (Continued) 4. Wearing safety glasses, drain tank of any remaining air pressure by pulling the ring on the safety valve. Use other hand to deflect any fast moving air that may be directed towards your face. 5. Store compressor in a cool, dry place. Maintenance Disconnect power source then release all pressure from the system before attempting to install, service, relocate or perform any maintenance. Service should be performed by an authorized service Figure 18 -
ページ16に含まれる内容の要旨
Operating Instructions and Parts Manual Maintenance (Continued) IMPORTANT: Unit should be located as far from spraying area as hose will allow to prevent over-spray from entering the pump. AIr FI Lter Check air filter to be sure it is clean. To service the air filter, tip the unit back, resting the wheels and handle on the floor (See Figure 20). Remove the filter housing cover. Remove filter and blow off dirt. Replace air filter if it can not be cleaned. Place filter back in the housing bas
ページ17に含まれる内容の要旨
WL6700 Series Service Record DAte MAInten An Ce Per For MeD r ePLACeMent Co MPonent S r equ Ire D www.chpower.com 17
ページ18に含まれる内容の要旨
Operating Instructions and Parts Manual Troubleshooting Guide Sy MPto M CAu Se So Lut Ion Compressor will not run 1. No electrical power 1. Plugged in? Switch on? Check fuse/breaker 2. Breaker open 2. Reset, determine cause of problem 3. Pressure switch bad 3. Replace 4. Motor over worked 4. Turn off, let cool, turn on. 5. Tank pressure above cut-in 5. Bleed tank pressure down to cut-in. Fuses blow/circuit breaker 1. Incorrect size fuse, circuit overloaded 1. Check for proper fuse, use time-del
ページ19に含まれる内容の要旨
WL6700 Series For Replacement Parts or Technical Assistance, Call 1-800-543-6400 Please provide following information: Address any correspondence to: - Model number Campbell Hausfeld - Serial number (if any) Attn: Customer Service - Part description and number as shown in parts list 100 Production Drive Harrison, OH 45030 U.S.A. 11 Replacement Parts List for Pump, Model WL390100 13 ref. Part no. Description no. qty. 1 Motor assembly kit 8 (Includes #2, 3, 6, 7, 10, 12, & 14)
ページ20に含まれる内容の要旨
Operating Instructions and Parts Manual For Replacement Parts or Technical Assistance, Call 1-800-543-6400 Please provide following information: Address any correspondence to: - Model number Campbell Hausfeld - Serial number (if any) Attn: Customer Service - Part description and number as shown in parts list 100 Production Drive Harrison, OH 45030 U.S.A. 20 24 19 18 23 57 22 29 28 25 27 56 21 55 26 53 31 30 17 1 52 47 45 4 48 46 50 49 51 44 16 39 38 33 27 28 54 3 28 43 20 28 12 7 27 11
