ページ1に含まれる内容の要旨
DVD/CD RECEIVER
DVD-/CD-RECEIVER
RECEPTEUR DVD/CD
DVD/CD-RECEIVER
KD-DV5101
For canceling the display demonstration, see page 11.
Zum Abbrechen der Displaydemonstration siehe Seite 11.
Pour annuler la démonstration des affichages, référez-vous à la page 11.
Zie bladzijde 11 voor het annuleren van de displaydemonstratie.
For installation and connections, refer to the separate manual.
Für den Einbau und die Anschlüsse siehe das eigenständige Handbuch.
Pour l’installation et les raccordements,
ページ2に含まれる内容の要旨
Thank you for purchasing a JVC product. Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit. IMPORTANT FOR LASER PRODUCTS 1. CLASS 1 LASER PRODUCT 2. CAUTION: Do not open the top cover. There are no user serviceable parts inside the unit; leave all servicing to qualified service personnel. 3. CAUTION: Visible and invisible laser radiation when open and interlock failed or defeated. Avoid direc
ページ3に含まれる内容の要旨
WARNINGS: This product incorporates copyright protection technology that is protected DO NOT install any receiver in by U.S. patents and other intellectual locations where; property rights. Use of this copyright – it may obstruct the steering wheel and protection technology must be authorized gearshift lever operations, as this may by Macrovision, and is intended for home result in a traffic accident. and other limited viewing uses only unless – it may obstruct the operation of saf
ページ4に含まれる内容の要旨
How to read this manual How to use the M MODE button The following methods are used to made the If you press M MODE, the receiver goes into explanations simple and easy-to-understand: functions mode, then the number buttons and Some related tips and notes are explained in 5/∞ buttons work as different function buttons. “More about this receiver” (see pages 46 – 49). Button operations are mainly explained with Ex.: When number button 2 works as the illustrations as follows: MO (monaural)
ページ5に含まれる内容の要旨
Contents How to reset your unit ........................... 2 On-Screen disc operations ............... 24 How to forcibly eject a disc ................... 2 Basic on-screen bar operations .............. 25 How to read this manual ........................ 4 Basic control screen operations ............. 27 How to use the M MODE button ........... 4 List screen operations ............................ 28 Introduction — Playable discs ............ 6 DVD setup menu ............................ 29 Bas
ページ6に含まれる内容の要旨
Introduction — Playable discs Discs you can play Caution for DualDisc playback You can play back the following discs (12 cm The Non-DVD side of a “DualDisc” does and 8 cm) on this receiver: not comply with the “Compact Disc Digital DVD Video: Recorded in PAL color system Audio” standard. Therefore, the use of Non- with Region Code “2” (see below). DVD side of a DualDisc on this product may – DVD-R/DVD-RW recorded in the DVD- not be recommended. Video format can also be played (see page
ページ7に含まれる内容の要旨
Control panel Parts identification Display window 1 5 (up) / ∞ (down) buttons Display window Function as Play / Stop buttons for DVD ; Disc information indicators— and VCDs. TAG (ID3 Tag), (folder), (track/file) 2 T/P TP/PTY (traffic programme/programme a Main display type) button s Source display / Volume level indicator 3 D DISP (display) button d EQ (equalizer) indicator 4 S SEL (select) button f Sound mode indicators—ROCK, 5 Control dial CLASSIC, POPS, HIP HOP, JAZZ, USER (stan
ページ8に含まれる内容の要旨
Remote controller — RM-RK230 Installing the lithium coin battery Main elements and features (CR2025) MONITOR CONTROL MODE ASPECT MENU DVD / RECEIVER CONTROL ZOOM ATT +10 SOURCE –100 +100 PRESET / TITLE BAND –10 / TITLE DUAL OSD 123 DISC+ VOL TOP M MENU 456 2nd VOL ENTER 78 9 – DISC SETUP RETURN 0 Before using the remote controller: SHIFT Aim the remote controller directly at the remote sensor on the receiver. Make sure RM-RK230 there is no obstacle in between. Remote sensor MONITOR CONTR
ページ9に含まれる内容の要旨
2 8 SETUP button* How to select a number 9 SHIFT button To select a number from 0 – 9: p Basic disc operation buttons: 7 (stop), 3 (play), 8 (pause) 3 (play) also function as ZOOM button when pressed with SHIFT button. q Advanced disc operation/tuner operation 5 buttons* For advanced disc operations: /TITLE 5 / ∞ To select a number greater than 9: – Select the titles (for DVD) or folders (for MP3/WMA). 4 / ¢ (reverse skip/forward skip) 1 / ¡ (reverse search/forward search)
ページ10に含まれる内容の要旨
Getting started Basic operations ~ ⁄ Adjust the volume. Ÿ Volume level appears. You cannot select some sources if they are not ready. Volume level indicator ! For FM/AM tuner only @ Adjust the sound as you want. (See pages 36 – 38.) To drop the volume in a moment (ATT) To restore the sound, press it again. To turn off the power 10 EN08-17_KD-DV5101[E]1.indd 10 EN08-17_KD-DV5101[E]1.indd 10 1 12/20/04 2:42:06 PM 2/20/04 2:42:06 PM ENGLISH
ページ11に含まれる内容の要旨
Canceling the display Setting the clock demonstrations 1 If no operations are done for about 20 seconds, display demonstration starts. [Initial: DEMO ON]—see page 39. 2 Set the hour and minute. 1 Select “CLOCK H” (hour), then 1 adjust the hour. 2 Select “CLOCK M” (minute), then adjust the minute. 3 Select “24H/12H” (minute), then 2 select “24H” (hour) or “12H” (hour). 3 3 Finish the procedure. 4 Finish the procedure. To check the current clock time when the power is turned off To a
ページ12に含まれる内容の要旨
Radio operations Listening to the radio To tune in to a station manually ~ In step ! on the left column... 1 Ÿ Selected band appears. 2 Select the desired station frequencies. Lights up when receiving an FM stereo broadcast with sufficient signal strength. ! Start searching for a station. When a station is received, searching stops. To stop searching, press the same button again. 12 EN08-17_KD-DV5101[E]1.indd 12 EN08-17_KD-DV5101[E]1.indd 12 1 12/20/04 9:41:34 AM 2/20/04 9:41:34 A
ページ13に含まれる内容の要旨
When an FM stereo broadcast is hard to Storing stations in memory receive 1 You can preset six stations for each band. FM station automatic presetting — SSM (Strong-station Sequential 2 Memory) 1 2 Select the FM band (FM1 – FM3) Lights up when monaural mode is activated. you want to store into. Reception improves, but stereo effect will be lost. To restore the stereo effect, repeat the same procedure. “MONO OFF” appears and the MO indicator goes off. 3 4 “SSM” flashes, then disappea
ページ14に含まれる内容の要旨
Manual presetting Listening to a preset station Ex.: Storing FM station of 92.5 MHz into the preset number 4 of the FM1 band. 1 1 2 2 3 Select the preset station (1 – 6) you want. 3 4 When using the remote controller.... or Preset number flashes for a while. To check the current clock time while listening to an FM (non-RDS) or AM station For FM RDS stations, see page 17. 14 EN08-17_KD-DV5101[E]1.indd 14 EN08-17_KD-DV5101[E]1.indd 14 12/20/04 2:42:36 PM 12/20/04 2:42:36 PM
ページ15に含まれる内容の要旨
FM RDS operations Searching for your favorite FM RDS programme You can tune in to a station broadcasting your favorite programme by searching for a PTY code. ! Start searching for your favorite To store your favorite programme, see page programme. 16. ~ If there is a station broadcasting a programme of the same PTY code as you have selected, that station is tuned The last selected PTY code appears. in. Ÿ Select one of your favorite programme type. PTY codes NEWS, AFFAIRS, INFO, SPORT,
ページ16に含まれる内容の要旨
3 Repeat steps 1 and 2 to store What you can do with RDS other PTY codes into other preset RDS (Radio Data System) allows FM numbers. stations to send an additional signal along with their regular programme signals. 4 Finish the procedure. By receiving the RDS data, this receiver can do the following: Programme Type (PTY) Search (see page 15) Temporarily switches to Traffic Announcement—TA Standby Reception. (See the right column.) Temporarily switches to your favorite Using the
ページ17に含まれる内容の要旨
PTY Standby Reception Tracking the same programme— PTY Standby Reception allows the receiver to switch temporarily to your favorite PTY Network-Tracking Reception programme from any source other than AM. When driving in an area where FM reception is not sufficient enough, this receiver To activate and select your favorite PTY automatically tunes in to another FM RDS code for PTY Standby Reception, see page station of the same network, possibly 40. broadcasting the same programme with st
ページ18に含まれる内容の要旨
Disc operations Playing a disc in the receiver The disc type is automatically detected, and Before performing any operations, make playback starts automatically (for DVD: sure the following.... automatic start depends on its internal program). Turn on the monitor for playing a DVD or VCD. If you turn on the monitor, you can also If the current disc is an audio CD, CD Text, control the audio CD, CD Text, and MP3/ MP3/WMA, or VCD without PBC, all tracks WMA playback by referring to the monito
ページ19に含まれる内容の要旨
When inserting a DVD disc: When inserting a VCD: Total title number Total playing time Total track number of the inserted disc of the inserted disc Elapsed playing time Elapsed playing time Current chapter number When inserting an MP3/WMA disc: When inserting a CD Text/audio CD: Total folder number Total playing time Total track number of the inserted disc of the inserted disc Total track number CD Text: Disc title/performer = Track title appears automatically Ex.: When an MP3 file
ページ20に含まれる内容の要旨
Basic operations Operations Display indication and/or next operation To stop play temporarily “PAUSE” illuminates on the display. A still picture appears. A Frame by frame playback B Slow motion playback No sound comes out during Slow Motion Playback. When playing a VCD, Reverse Slow Motion Playback is prohibited. To resume normal play: To replay the previous The playback position moves back about 10 seconds before scenes—One Touch Replay the current position. This function works only wi
