ページ1に含まれる内容の要旨
Operator's Manual
Manuel d'utilisation
Libro de Instrucciones
U.S. Patent No. 6,105,192; No. 6,557,207; No. 6,760,947; No. 5,383,251; & Patents Pending
EN
READ THIS BOOK
English (2 - 27)
ES
LEA ESTE MANUAL Español (28 - 53)
FR
Français (54 - 79)
LISEZ CE MANUEL
This book has important information for the use and safe operation of this machine. Failure to read this
book prior to operating or attempting any service or maintenance procedure to your Clarke machine
could result in injury to you
ページ2に含まれる内容の要旨
ENGLISH EN Table of Contents Operator Safety Instructions ............................................................................................................................ 3 Introduction & Machine Specifications ............................................................................................................. 5 Procedures for Transporting Machine ............................................................................................................. 6 Symbols Used on B
ページ3に含まれる内容の要旨
ENGLISH EN OPERATOR SAFETY INSTRUCTIONS DANGER: Failure to read and observe all DANGER statements could result in severe bodily injury or death. Read and observe all DANGER statements found in your Owner's Manual and on your machine. WARNING: Failure to read and observe all WARNING statements could result in injury to you or to other personnel; property damage could occur as well. Read and observe all WARNING statements found in your Owner's Manual and on your machine. CAUTION: Failure to read
ページ4に含まれる内容の要旨
ENGLISH EN WARNING: Maintenance and repairs performed by unauthorized personnel could result in damage or injury. Maintenance and repairs must be performed by authorized Clarke personnel only. WARNING: Any alterations or modifications of this machine could result in damage to the machine or injury to the operator or other bystanders. Alterations or modifications not authorized by the manufacturer voids any and all warranties and liabilities. WARNING: Electrical components of this machine can "
ページ5に含まれる内容の要旨
ENGLISH EN Introduction & Machine Specifications Introduction & Machine Specifications Clarke’s newly designed BOOST 28 automatic scrubber is an efficient and superior floor cleaning machine. The BOOST 28 uses an orbital movement to scrub a path 28 inches wide. A squeegee wipes the floor while the vacuum motor removes the dirty solution from the floor - all in one pass. The BOOST 28 comes complete with four - 6 volt batteries, one battery charger, a brush or a pad, and one operator’s manual. S
ページ6に含まれる内容の要旨
ENGLISH EN Procedures For Transporting How to Put the Machine Into a Van or Truck WARNING: This machine is heavy. Get assistance before attempting to transport or move it. Use two able persons to move the machine on a ramp or incline. Always move slowly. Do not turn the machine on a ramp. Do not stop and leave the machine on a ramp or incline. The loading ramp must be a minimum of 32" Figure #1 wide. WARNING: Machines can topple over if guided over the edges of stairs or loading docks and
ページ7に含まれる内容の要旨
ENGLISH EN Procedures For Transpoting (cont.) 10. Fasten the machine to the vehicle. Clarke recommends a strap over the top of the machine and a strap to keep the machine from rolling forward or backwards. If this is not done, there is a possibility of the machine toppling over. Four tie down points (2 along each side of frame) are provided on machine for securing machine. How to Remove the Machine From a Van or Truck 1. Make sure there are no obstructions in the area. Figure #2 2. Make sure
ページ8に含まれる内容の要旨
ENGLISH EN SYMBOLS USED ON BOOST 28 Warning Solution Control Power Brush Up/Down Traverse Speed Control Warning Label Warning Label with parking without parking brake brake ® -8- Clarke Operator's Manual (EN) - BOOST 28
ページ9に含まれる内容の要旨
ENGLISH EN Machine Control Panel Circuit Breakers (See Fig 3, Items "E", "F", "G", & "H") The circuit breaker reset buttons are located on the Key Switch (See Figure 3, Item "A") rear cover. The breakers are located as follows: The key switch turns "ON" the power to the control Item E - Actuator Head (5 amp) panel. "O" is "OFF" and "I" is "ON". Item F - Vacuum Motor (30 amp) Item G - Brush Motor (30 amp) Forward Reverse Switch (See Figure 3, Item "B") Item H - Traverse Motor (25 amp) If a cir
ページ10に含まれる内容の要旨
ENGLISH EN Machine Controls and Features Squeegee Lift Handle, See Figures 4 and 5 The squeegee lift handle is located below the control handles in the center. It is used to raise or lower the squeegee. The vac motor is turned on when the handle is lowered to either the first or last position. Float Shut Off, See Figure 6 The shut-off switch for the vac motor is located in the recovery tank. It automatically turns off the vac motor when the recovery tank is full. NOTE: If excessive foaming
ページ11に含まれる内容の要旨
ENGLISH EN How To Prepare the Machine For Operation How To Install The Batteries This machine uses either two 12-volt batteries or four - 6 volt batteries. The batteries are located in the battery compartment under the recovery tank. To install the batteries, follow this procedure: 1. Turn machine off. Set brake (if equipped). 2. Make sure recovery tank is empty. 3. Tip up the recovery tank until it locks in the full open position. See figure 8A. CAUTION: Before raising the tank, be sure t
ページ12に含まれる内容の要旨
ENGLISH EN How To Prepare the Machine For Operation Battery Maintenance The electrical power to operate the machine comes from the storage batteries. Storage batteries need preventative maintenance. Correct Level WARNING: Working with batteries can be dangerous. Always wear eye protection and protective clothing when working near batteries. NO SMOKING! To maintain the batteries in good condition, follow these instructions: 1. Keep the electrolyte at the correct level. The Figure 10 correct l
ページ13に含まれる内容の要旨
ENGLISH EN How To Prepare the Machine For Operation How To Charge The Batteries (Remote Charger) WARNING: Charging the batteries in an area without adequate ventilation could result in an explosion. To prevent an explosion, charge the batteries only in an area with good ventilation. WARNING: Lead acid batteries generate gases which could explode. Keep sparks and flames away from batteries. NO SMOKING! To charge the batteries, follow this procedure: 1. Place the key switch is in the “OFF” posit
ページ14に含まれる内容の要旨
ENGLISH EN How To Prepare the Machine For Operation How To Charge The Batteries (On-Board Charger Option) WARNING: Charging the batteries in an area without adequate ventilation could result in an explosion. To prevent an explosion, charge the batteries only in an area with good ventilation. WARNING: Lead acid batteries generate gases which could explode. Keep sparks and flames away from batteries. NO SMOKING! To charge the batteries, follow this procedure: 1. Make sure the key switch is in t
ページ15に含まれる内容の要旨
ENGLISH EN How To Prepare the Machine For Operation How To Install The Brush Or Pad To install the brush or pad on the machine, follow this procedure: 1. Turn the key switch "ON". 2. Put the brush switch in the "Up" position. 3. Turn the key switch "OFF". 4. Go to the front of the machine. 5. Press on a brush or pad, under the flex plates. See figure 15. Figure 15 NOTE: When using a black pad, position pad on head. Lower head and operate momentarily to affix pad to pad driver (if you have dif
ページ16に含まれる内容の要旨
ENGLISH EN How To Operate The Machine How To Operate The Squeegee The squeegee wipes the floor while the vacuum motor removes the dirty solution from the floor. Use your hand to lower or raise the squeegee handle. To operate the squeegee, follow this procedure: 1. To lower the squeegee and start the vacuum motor, move the squeegee lever to the right and down. See figure 17. 2. To raise the squeegee, lift the squeegee lever up. See figure 18. NOTE: The center position lets the vacuum motor c
ページ17に含まれる内容の要旨
ENGLISH EN How To Operate The Machine WARNING: Water solutions or cleaning B materials used with this type of C machine can leave wet areas on the floor surface. These areas A A can cause a dangerous condition for the operator or other persons. Always put CAUTION signs near the area you are cleaning. WARNING: Machines can ignite flammable materials and vapors. Do not use with or near flammables such as gasoline, grain dust, solvents and thinners. Only use a cleaning concentration recommended
ページ18に含まれる内容の要旨
ENGLISH EN How To Operate The Machine (cont) How To Clean A Floor WARNING: Water solutions or cleaning materials used with this type of machine can leave wet areas on the floor surfaces. These areas can cause a dangerous condition for the operator or other persons. Always put CAUTION signs near the area you are cleaning. To clean a floor follow this procedure: 1. Set the parking brake (if equipped with machine.) 2. Put the water and a cleaning chemical in the clean solution tank. 3. Release
ページ19に含まれる内容の要旨
ENGLISH EN Maintenance WARNING: Maintenance and repairs must be done by authorized personnel only. WARNING: Always empty the solution tank and recovery tank before doing any maintenance. WARNING: Keep all fasteners tight. These Maintenance Procedures Must Be Done Every Day Keep the machine clean, it will need fewer repairs and have longer life. Figure 22 Do These Procedures When You Begin Your Work Period 1. Turn off key switch. 2. Disconnect AC power from battery charger (fol- low charger i
ページ20に含まれる内容の要旨
ENGLISH EN Maintenance Do These Procedures When You End Your Work 1. Drain the solution tank (Figure 25) and the recovery tank (Figure 26). To drain the tanks , follow this procedure: a. Turn the key switch “OFF”. b. Remove the drain hose from the back of the machine. c. Put the end of the hose over a drain or bucket. d. Recovery Tank: Figure 25 1.) Turn the valve handle to the left. Pull the handle out to open the drain (Figure 27). NOTE: Have the opening in the side of the valve
