ページ1に含まれる内容の要旨
Micro Audio System
with CD-R/RW Player,
AM/FM Stereo Tuner
and Remote Control
OWNER'S MANUAL
MS7618R
Visit our web site at www.emersonradio.com
MS7618R_062205.p65 24 22/6/2005, 15:09
ページ2に含まれる内容の要旨
CAUTION TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ! The lightning flash with arrow- The exclamation point within WARNING: TO REDUCE THE head symbol, within an equi- an equilateral triangle is in- RISK OF ELECTRIC SHOCK lateral triangle is inten
ページ3に含まれる内容の要旨
Thank you......... for purchasing this Emerson audio product. The Emerson brand is your assurance of quality, performance and value. Our engineers have included many useful and convenient features in this product. Please be sure to read this Owner’ s Manual completely to make sure you are getting the maximum benefit from each feature. This product was manufactured using the highest quality components and standards of workmanship. It was tested by Emerson inspectors and found to be in perfect wor
ページ4に含まれる内容の要旨
IMPORTANT NOTES • Avoid installing this unit in places • Operate controls and switches as exposed to direct sunlight or close to described in the manual. heat radiating appliances such as • Before turning ‘On’ the power, make electric heaters, on top of other stereo certain that power cord is properly equipment that radiates too much heat, installed. places lacking ventilation or dusty areas, • Store your CDs in a cool area to avoid places subject to constant vibration and/ damage from heat.
ページ5に含まれる内容の要旨
PREPARATION FOR USE Unpacking and Set Up • Carefully remove the unit from the carton and remove all packing materials from the unit. • Carefully remove any small strips of tape which may have been used to keep the CD door closed during shipment. • Open the CD compartment by lifting the “OPEN/CLOSE” tab on right side of CD door. Inside the CD compartment you will see a white transit card which is used to prevent the laser pick-up from moving during shipment. Carefully remove this card and c
ページ6に含まれる内容の要旨
R L + + Speaker Connection Connect each speaker to the corresponding speaker terminals on the back panel of the main unit. Make sure that: •The left speaker is connected to the (L) left pair of speaker terminals, and the right speaker to the (R) right pair of speaker terminals. Also make sure that the speaker wires are correctly connected: •That the Red wires are connected to the Red (+) terminals, and The Black wires to the Black (–) terminals. Depress the plastic lever to open the terminal,
ページ7に含まれる内容の要旨
Power Source This system is designed to operate on normal 120V 60Hz AC house current only. Attempting to operate this system from any other power source may cause damage to the system, and such damage is not covered by your warranty. Unwind the AC power cord and connect the AC plug to your AC outlet. Note: This unit has a polarized AC plug with one wide blade and one narrow blade. This plug will only fit into a matching polarized AC outlet. This is a safety feature to reduce the possibility of e
ページ8に含まれる内容の要旨
LOCATION OF CONTROLS AND INDICATORS 9 10 11 8 12 7 13 6 5 14 4 3 15 2 16 17 1 20 19 18 7 MS7618R_062205.p65 7 22/6/2005, 15:09
ページ9に含まれる内容の要旨
1.) PHONES Jack. 2.) SKIP/SEARCH REV. Button. 3.) Power ‘ On’ Indicator. 4.) PLAY / PAUSE Button. 5.) PLAY MODE Button. 6.) PROG. / CLOCK Button. 7.) REMOTE SENSOR. 8.) Multi-Function Display. 9.) CD Door. 10.) CD Door OPEN / CLOSE tab. 11.) BAND Button. 12.) TUNING Control. 13.) VOLUME + Button. 14.) VOLUME – Button. 15.) SKIP/SEARCH FWD. Button. 16.) External FM Wire Antenna. 17.) CD / TUNER Selector Button. 18.) AC Power Cord. 19.) STOP Button. 20.) POWER ‘ On/Off’ Button. 8
ページ10に含まれる内容の要旨
P L A Y / Remote Control (CD Operations Only) 3 STOP 1.) PLAY / PAUSE Button. SKIP SKIP FWD. REV. 2.) SKIP REV. Button. 4 2 3.) STOP Button. 4.) SKIP FWD. Button. 1 5.) Battery Compartment. (Back Cabinet) 5 Battery Installation 1.) Open the battery door on the back of the remote control by pressing on the battery door tab in the direction of the arrow and lift it up. 2.) Insert two “AAA” alkaline batteries (not included) into the battery compartment. Be sure the batteries are inserted acc
ページ11に含まれる内容の要旨
Battery Replacement When the batteries become too weak, the operating distance of the remote control is greatly reduced and you will need to replace the batteries. Using The Remote Control Correctly • Point the remote control at the REMOTE SENSOR. • The functions of the buttons on the remote control are the same as the corresponding controls on the main unit. • When there is a strong ambient light source, the performance of the infrared Remote Sensor may be degraded, causing unreliable ope
ページ12に含まれる内容の要旨
OPERATING INSTRUCTIONS Setting The Clock Note: The clock can only be set at when power is ‘Off ’. 1.) Press the PROG./CLOCK button on the front panel. The “12 H” will begin flashing in the display indicating that the clock is set for “American” 12-hour time. Press either the or button on the front panel or remote control to change the clock format to “European” 24-Hour time as desired. The display will change from “12H” to “24H”. 2.) Press the PROG./CLOCK button. The Hour digits will begin fla
ページ13に含まれる内容の要旨
Listening To The Radio Tuner Information This system features a normal AM/FM analog tuning system. Unlike a digital tuner it does not automatically lock in on the exact frequency of a station. However instead of a dial scale and a moving dial pointer we have included a digital frequency display to help you tune more accurately. Do not be concerned if you cannot easily tune the display to the exact frequency of your favorite stations, especially on the AM band. Slowly rotate the TUNING control un
ページ14に含まれる内容の要旨
Hints For Better Reception FM: The FM lead wire antenna on the back panel should be extended to its full length. You may also have to vary the direction of this antenna until you find the position that provides the best reception. AM: The AM bar antenna is inside the cabinet of the main unit. You may need to change the position of the main unit until you find the position that provides the best reception for your favorite AM stations. 13 MS7618R_062205.p65 13 22/6/2005, 15:09
ページ15に含まれる内容の要旨
Playing Compact Discs Note: Although this CD player can read CD-R and CD-RW discs, in addition to normal CDs, the playability of CD-R/RW discs may be affected by the type of software that was used to create the discs, as well as the quality and condition of the blank media you are using. 100% playability cannot be guaranteed. This is not an indication of a problem with the player. Normal Playback 1.) Press the POWER button on the front panel. The indicator and display light come ‘ On ’. 2.) If
ページ16に含まれる内容の要旨
5.) The player will read the Table of Contents and the display will show the total number of tracks on the disc. If the disc is damaged or up side down, display will show “ – – ”. 6.) Press the PLAY/PAUSE button to begin playback on Track “01”. The indicator lights up. 7.) Adjust the VOLUME control as desired. 8.) Playback will continue until the end of the disc. When the disc ends the display again shows the total number of tracks on the disc. You may also stop playback at any time by pressi
ページ17に含まれる内容の要旨
The player will move forward or backward at high speed as long as the or buttons are depressed. When you hear the desired passage release the buttons. Normal playback will resume at that point. Repeat Playback (On Front Panel Only) The Repeat function allows you to continuously repeat a single track, or the entire disc. The Repeat function can be activated during playback or while the player is stopped. To Repeat A Single Track Press the PLAY MODE button once. The REPEAT indicator flashes. The
ページ18に含まれる内容の要旨
Programmed Playback (On Front Panel Only) This feature allows you to program up to 20 tracks on a disc for playback in any desired order. You may also program a specific track to play several times within the same program. Note: You cannot program tracks while a disc is playing. If the disc is playing press the STOP button first before beginning the programming steps below: 1.) Press the CD/TUNER button to select the CD mode, insert your disc in the player, close the door, and wait until the to
ページ19に含まれる内容の要旨
6.) Repeat Step 5 until you have entered up to 20 tracks in the program memory. When the memory is full, the “ – – ” indicator flashes in the display. 7.) To begin programmed playback press the PLAY/PAUSE button. The display will show the first programmed track and playback will begin on that track. The MEMORY indicator remains ‘ On’ . After the last programmed track has played the player stops but the programmed tracks remain in the memory. To play the programmed tracks again, press the PROG.
ページ20に含まれる内容の要旨
PHONES Jack Connect a set of stereo headphones (not included) with a 3.5mm mini plug to the PHONES jack on front panel, for private listening without disturbing others. Before putting on the headphones reduce the VOLUME control to a low level, then put the headphones on and gradually increase the VOLUME control to a comfortable listening level. The speakers are automatically disconnected when headphones are connected to the PHONES jack. 19 MS7618R_062205.p65 19 22/6/2005, 15:09
