ページ1に含まれる内容の要旨
Personal CD-R/RW Player
with 60 Second Electronic
Anti-Skip Protection,
and AM/FM Stereo Radio
OWNER’S MANUAL
HD8115
Visit our web site at www.emersonradio.com
HD8115_B101205.p65 23 12/10/2005, 11:35
ページ2に含まれる内容の要旨
Thank you......... For purchasing this Emerson Personal CD Player with AM/FM Radio. The CD player has a 20 track programmable memory so you can listen to the songs on your favorite CD's in any order you choose. Or you can use the Shuffle playback feature and let the player randomly select the playback order for you. Use the 3-way Repeat feature to repeat a single track, the entire disc, or a programmed sequence of tracks, indefinitely. We've also included 60 second Electronic Anti-Skip Protectio
ページ3に含まれる内容の要旨
IMPORTANT NOTES WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. Avoid installing the unit in locations described below: • Places exposed to direct sunlight or • Dusty places. close to heat radiating appliances such • Places subject to constant as electric heaters. vibration. • Humid or moist places. CLASS 1 LASER PRODUCT CAUTION CLASS 1 LASER PRODUCT INVISIBLE LASER RADIATION APPAREIL Á LASER DE CLASSE 1 WHEN OPEN AND INTERLOCKS DEFEATED. PRODUCTO LASER DE
ページ4に含まれる内容の要旨
PREPARATION FOR USE Remove The Transit Card This personal CD player is shipped with a dummy CD ‘ transit card’ inside the CD compartment. The purpose of this card is to prevent the laser from moving during shipment of the product. This card must be removed before using the CD player. Slide the OPEN switch to the right to unlock the CD door. Remove the ‘ transit card’ from the player and discard it. TRACK 53 60 88 70 92 90 96 MIN SEC 110 100 BASS BOOST SYSTEM 140 104 171 108 x10 EQ MHz kHz FM AM
ページ5に含まれる内容の要旨
Connecting The Optional AC Adapter (Not Included) 1.) Connect the small female plug of the optional AC adapter to the DC 4.5V jack on the left side of the CD player. 2.) Connect the adapter housing to your 120V AC 60Hz outlet. NOTES: • Never connect or disconnect the adapter from the AC outlet while your hands are wet. • The housing of the AC adapter may become warm during operation. This is normal. • The female plug of the AC adapter must be completely disconnected from the CD player in o
ページ6に含まれる内容の要旨
Installing The Batteries 1.) Open the battery compartment door on the bottom cabinet by sliding it in the direction of the arrow and then lifting it open. To prevent loss, the door cannot be removed from the unit. 2.) Insert 2 "AA" batteries (not included) into the compartment. Use alkaline batteries for longest life. Follow the polarity markings inside the compartment. If the batteries are inserted incorrectly the unit will not work. 3.) Close the battery door. Note: In order to operate the pla
ページ7に含まれる内容の要旨
Connecting The Stereo Headphones Connect the plug of the supplied stereo headphones to the headphone jack on the right side of the cabinet. NOTE: Make sure the headphone plug is inserted into the headphone jack as far as it will go. If the plug is not fully inserted, you may only hear sound from one side of the headphones. TRACK 53 88 60 70 92 90 96 MIN SEC 110 100 BASS BOOST SYSTEM 140 104 171 108 EQ x10 MHz kHz FM AM STOP SEARCH / SKIP FWD. PLAY / PAUSE MODE SEARCH / SKIP REV. PROG. To Headp
ページ8に含まれる内容の要旨
LOCATION OF CONTROLS AND INDICATORS 4 5 3 6 7 2 TRACK 53 60 88 70 92 90 96 8 MIN SEC 110 100 BASS BOOST SYSTEM 140 104 171 108 x10 EQ MHz kHz AM FM 9 STOP 10 SEARCH / SKIP FWD. PLAY / PAUSE 11 MODE 12 1 SEARCH / SKIP REV. 13 PROG. 14 15 20 19 16 17 18 7 HD8115_B101205.p65 7 12/10/2005, 11:35
ページ9に含まれる内容の要旨
1.) HOLD Switch. 2.) DC 4.5V Input Jack – Connect an AC adapter (not included) to this jack to use 120V 60Hz house current. 3.) LCD Display – Shows Track number, Playing time, Anti-Skip status, Program, Repeat, Shuffle, and Intro modes. 4.) EQ Button – Press repeatedly to select SRR (Surround), ROCK, POP, Flat EQs. 5.) FM Dial Scale. 6.) AM Dial Scale. 7.) TUNING Control. 8.) Function (FM/AM/CD-RADIO OFF) Selector Switch. 9.) STOP Button. 10.) Headphone Jack – Connect stereo
ページ10に含まれる内容の要旨
LCD DISPLAY INDICATORS 5 6 3 4 2 7 8 1 9 10 1.) SRR (Surround), ROCK, POP Indicators – Appears when repeatedly pressing the EQ button to select the corresponding EQ setting. 2.) Repeat 1/ALL Indicators – Appears when the Repeat playback mode is selected. 3.) PGM (Program) Indicator – Appears when programming tracks or playing programmed tracks. 4.) INTRO Indicator – Appears when Intro playback mode is selected. 5.) SHUF (Shuffle) Indicator – Appears when Random playback mode is select
ページ11に含まれる内容の要旨
OPERATING INSTRUCTIONS HOLD Switch The HOLD switch (on the left side cabinet) must be in the ‘Off’ (left) position to start the CD player. If you plan to carry the CD player in a handbag, briefcase, school bag, back pack, etc, slide the HOLD switch to the ‘ On’ (right) position. While the HOLD switch is ‘ On’ all of the controls on the CD door are disabled. This prevents the player from starting accidentally by something pressing against the PLAY/PAUSE button. (Off) (On) After you begin CD play
ページ12に含まれる内容の要旨
Electronic Anti-Skip Protection This CD player is equipped with automatic 60 second Electronic Anti-Skip Protection and that will eliminate virtually all skipping during most active uses. When you press the PLAY/PAUSE button to begin playback, the player immediately begins to store 60 seconds of music in a solid state memory that is impervious to shock. The player is always reading the disc 60 seconds ahead of the music you are hearing and storing that information in the memory. If the player i
ページ13に含まれる内容の要旨
Normal CD Playback • Make sure you have installed the batteries. • Make sure the HOLD switch is set to the ‘Off’ (left) position. • Make sure to set the VOLUME control to a low setting before you put on the headphones. IMPORTANT: This CD player can play normal CDs plus CD Recordable (CD-R) and CD ReWritable (CD-RW) discs. However the playability of CD-R/RW discs may be affected by the type of software that was used in ‘ripping’ the tracks from the original discs and ‘ burning’ the tracks o
ページ14に含まれる内容の要旨
5.) Press the PLAY/PAUSE button to begin playback. The display will briefly show two flashing dashes “– –” as the player reads the disc. The total tracks and playing time will appear briefly in the display and then the playback will begin on track ‘01’. The display will show the elapsed playing time of the track being played. 6.) Adjust the VOLUME and EQ controls to your listening preference. If you prefer more Bass, slide the BBS switch to ‘ON’ position. 7.) Playback will continue until the en
ページ15に含まれる内容の要旨
SKIP/SEARCH ( / ) CONTROLS Press the SKIP FWD. or SKIP REV. buttons repeatedly during playback to skip to higher or lower numbered tracks. Playback will begin on the selected track. To search within a track at high speed to locate a specific musical passage depress and hold either the SKIP FWD. or SKIP REV. buttons. The player moves forward or reverse at high speed. When you reach the desired point in the track, release the buttons and normal playback resumes. 14 HD8115_B101205.p65 14 12/10/
ページ16に含まれる内容の要旨
MODE Button Pressing the MODE button during CD playback cycles the player through the following four special playback modes: 1 (Repeat 1) ALL (Repeat All) INTRO SHUF (Shuffle) Playback. Repeat Playback The player can be programmed to continuously repeat a single track or the entire disc automatically. One Track Repeat During playback press the SKIP FWD. or SKIP REV. buttons to select the track to be repeated, then press the MODE button once. The 1 indicator appears in the display and th
ページ17に含まれる内容の要旨
INTRO (Intro Scan) Playback The Intro Scan feature plays only the first 10 seconds of each track on the disc. This feature is useful when you are trying to find a particular song but you cannot remember the title. 1.) Load your disc in the player as usual and press the PLAY/PAUSE button to begin playback. 2.) When playback begins press the MODE button three times. The INTRO indicator flashes. 3.) Press the PLAY/PAUSE button once more. The INTRO indicator stops flashing and remains ‘ On ’. The
ページ18に含まれる内容の要旨
Programmed Playback You can program up to 20 tracks on a disc to play in any desired order. NOTE: You can program a disc either during Playback or in Stop mode. 1.) Press the PROG. button once. The Program Number ‘01’ appears. The PGM indicator and the the track number ‘00’ flash. 2.) Press the SKIP FWD. or SKIP REV. button to select the first track to be programmed. Example: Track 07. 3.) When the desired track number is flashing in the display, press the PROG. button again to enter the desi
ページ19に含まれる内容の要旨
Listening To The Radio 1.) Slide the FM/AM/CD-RADIO OFF function selector to FM or AM position as desired. 2.) Tune to the desired station by turning the TUNING control. 3.) Adjust the VOLUME and EQ controls to your listening preference. 4.) If you prefer more bass, slide the BBS switch to ‘ON’ position. 5.) To turn off the radio, slide the FM/AM/CD-RADIO OFF function switch to CD-RADIO OFF position to shut power ‘Off ’. Antenna Information FM The stereo headphone cable serves as the FM antenna
ページ20に含まれる内容の要旨
CARE AND MAINTENANCE Cleaning the Cabinet Wipe with a soft cloth. If the cabinet is very dirty, dampen the cloth with a weak solution of neutral detergent and water, and then wipe clean. Cleaning the Lens A dirty lens will cause sound skipping and, if the lens is very dirty, the CD may not work. Open the disc cover and clean the lens as follows: Dust or Dry Particles Using a camera lens brush/blower, blow on the lens several times, then wipe it lightly with the brush to remove dust. Then, blow o
