ページ1に含まれる内容の要旨
XDM6220
INSTALLATION/OWNER'S MANUAL
AM/FM/CD/MP3/WMA Receiver with Detach Face
ページ2に含まれる内容の要旨
XDM6220 INSTALLATION Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. (consult a qualified technician for instructions) • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration. Getting Started • Remove 2 transit screws located on top of the unit. • Insert the supplied keys into the slots as shown, and slide
ページ3に含まれる内容の要旨
XDM6220 INSTALLATION Wiring Diagram FUSE When replacing the fuse, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The XDM6220 uses one 10 amp AGC fuse (Battery) located in-line. 3
ページ4に含まれる内容の要旨
XDM6220 OPERATION Control Locations 1 2 3 4 5 6 7 8 21 20 19 18 17 16 15 14 13 12 11 10 9 Release EQ/9 1 12 Power Tuner Scan/8 2 13 Mute Local/Distance/7 3 14 Audio Preset 6/Folder Up 4 15 Band/Play/Pause Preset 5/Folder Down 5 16 6 Auto Store/Preset Scan/Enter 17 Preset 4 7 Mode/Search 18 Preset 3/Intro 8 Eject 19 Preset 2/Random 9 Tune/Track Up/Down 20 Preset 1/Repeat 10 Loudness 21 Volume Up/Down 11 Display/0 The XDM6220 allows playback of your favorite MP3 and WMA files recorded on CD-R and
ページ5に含まれる内容の要旨
XDM6220 OPERATION General Operation Faceplate Removal Press RELEASE and pull away from the left side to remove. To re-install, insert right side of faceplate first then push left side to secure. Semi-permanent Remove trim ring and install supplied #1 x 7/32” Phillips Faceplate Installation head screw through left side of mounting frame into faceplate. Power On/Off Press PWR or any other button (except eject or volume up/ down) to turn the unit on. Inserting a disc will turn the unit on autom
ページ6に含まれる内容の要旨
XDM6220 OPERATION General Operation Programmable Display In tuner mode, press and hold DISP then press TUNE >> Priority to select function priority display. “FREQ” will momentarily appear in the display. Note: "FUNC" will appear in CD or AUX modes. Radio frequency (tuner mode), CD track/elapsed time (CD mode) or AUX (AUX mode) will be displayed by default. Note: When playing MP3/WMA files, the track number/elapsed time, track name, directory name, title, artist, album, year or comment w
ページ7に含まれる内容の要旨
XDM6220 OPERATION General Operation Audio Press AUD to select between Volume (default), Bass, Treble, Balance & Fader. Bass Press AUD until BAS appears Press VOL t or s to adjust ( -6 minimum / +6 maximum) Treble Press AUD until TRE appears Press VOL t or s to adjust ( -6 minimum / +6 maximum) Balance Press AUD until BAL appears Press VOL t or s to adjust (BAL L 12-BAL 00-BAL R 12) BAL 00 represents equal balance Fader Press AUD until FAD appears Press VOL t or s to adjust (FAD F 12-FAD 00-FA
ページ8に含まれる内容の要旨
XDM6220 OPERATION Tuner Operation Seek Tuning Press TUNE << or TUNE >> momentarily to seek the next strong station. Manual Tuning Press TUNE << or TUNE >> for more than 2 seconds, then release. "MANUAL" will momentarily appear in the display. Press TUNE << or TUNE >> momentarily to move radio frequency up or down one step at a time. Press and hold to advance quickly. If tuning is not adjusted for 5 seconds, the unit will return to seek tuning mode (default). "AUTO" will momentarily app
ページ9に含まれる内容の要旨
XDM6220 OPERATION CD Player Operation Insert CD With the label facing up, insert a standard size CD into the CD slot. The CD will automatically begin playback. Eject CD Press EJECT to eject the CD. The unit will change to previous mode of operation (AM, FM, or auxiliary input). If the disc is not removed within 10 seconds, the unit will reload the disc. The unit does not have to be turned on to eject CD. Track Select Press TRACK >> to skip to the beginning of the next track. Press TRACK <<
ページ10に含まれる内容の要旨
XDM6220 OPERATION CD Player Operation - MP3/WMA Files When an MP3/WMA encoded disc is first inserted, Playing an MP3/WMA Disc “READING” will appear in the display. Depending on the number of files and folders, this may take several seconds. The icon will illuminate anytime a valid MP3 encoded MP3 Icon disc is inserted and flash in MP3 search/navigate modes. The icon will illuminate anytime a valid WMA encoded WMA Icon disc is inserted and flash in WMA search/navigate modes. Fold
ページ11に含まれる内容の要旨
XDM6220 OPERATION CD Player Operation - MP3/WMA Files Refer to the following button function table when selecting, searching or navigating MP3/WMA files and folders: MP3/WMA Button Function Table Button Function SEARCH Direct Select, Search and Navigate Modes Enter/Confirm Preset 1 A, B, C, 1 Preset 2 D, E, F, 2 Preset 3 G, H, I, 3 Preset 4 J, K, L, 4 Preset 5 M, N, O, 5 Preset 6 P, Q, R, 6 7 S, T, U, 7 8 V, W, X, 8 9 Y, Z, /, 9 0 -, _, +, 0 AUD Character Shift VOL t / VOL s Character Select
ページ12に含まれる内容の要旨
XDM6220 OPERATION CD Player Operation - MP3/WMA Files Alphanumeric File Press SEARCH for more than 3 seconds, then release. or Folder Search Press SEARCH again, an " " will flash in the display. Use * Step 1 the buttons in the table on page 11 (32 character maximum input) or the VOL t / VOL s to enter the desired alphanu- meric search characters. Press AUD to advance one character to the right. Step 2 Press to initiate the selected alphanumeric search. Step 3 Press VOL t / VOL s to prev
ページ13に含まれる内容の要旨
XDM6220 OPERATION CD Player Operation - MP3/WMA Files *Folder Access Press F to select the previous folder. Press F to select the next folder. *Folder access is only available on MP3/WMA discs recorded with more than one folder. File Repeat Press RPT momentarily to continuously repeat selected file. Press RPT again to cancel. File Repeat Press RPT for more than 2 seconds to consecutively repeat (Current Folder Only) all files in the current folder only. The icon will appear i
ページ14に含まれる内容の要旨
XDM6220 OPERATION CD Player Operation - MP3/WMA Files Media Compatibility The following types of discs/files are compatible: • CD-ROM (ISO), CD-R, CD-RW • CD-DA • MP3 data • WMA data The following types of discs/files are not compatible: • WMA files that are protected by DRM (Digital Rights Management). • WMA lossless format • Discs recorded with Track At Once or packet writing • MP3 PRO format • MP3 playlists • WAV format Playback Order MP3/WMA playback sequence is based on recorded order of
ページ15に含まれる内容の要旨
XDM6220 OPERATION CD Player Operation - MP3/WMA Files Additional MP3/WMA An internal buffer provides ESP (Electronic Skip Protection) Information to virtually eliminate skipping. When playing a disc recorded with regular audio files (CD-DA or .WAV) and MP3/WMA files, the unit will play the MP3/WMA files only. Only MP3 files with filename extension (.mp3) can be played. Only WMA files with filename extension (.wma) can be played. Do not attempt to play discs which contain non-MP3/WMA files w
ページ16に含まれる内容の要旨
XDM6220 WARRANTY Limited One-Year Warranty This warranty gives you specific legal rights. What to do? You may also have other rights which vary from 1. Before you call for service, check the state to state. troubleshooting guide in your owner’s manual. A slight adjustment of any custom Dual Electronics Corp. warrants this product to controls or connections discussed in your the original purchaser to be free from defects in instruction booklet may save you a service material and workmanship
ページ17に含まれる内容の要旨
XDM6220 OPERATION Specifications CD Player Signal-to-noise: >92dB Frequency response: 10Hz-20kHz Channel separation @ 1kHz: >65dB D/A converter: 1 Bit FM Tuner Tuning range: 87.5MHz-107.9MHz Usable sensitivity: 8.5dBf 50dB quieting sensitivity: 10dBf Stereo separation @ 1kHz: 40dB Frequency response: 30Hz-13kHz AM Tuner Tuning range: 530kHz-1710kHz Usable sensitivity: 22uV Frequency response: 30Hz-2.2kHz General Total power output: 200 Watts Peak Power output: 50Wx4 @ 4 ohms, 14.4
ページ18に含まれる内容の要旨
XDM6220 WARRANTY Troubleshooting Problem Cause Action Unit will not turn on Yellow wire not connected or incorrect voltage Check connections for proper voltage (no power) Red wire not connected or incorrect voltage (11~16VDC) Black wire not connected Check connection to ground Fuse blown Replace fuse Unit has power Speaker wires not connected Check connections at speakers (but no sound) One or more speaker wires touching each Insulate all bare speaker wires from other or touching chassis grou
ページ19に含まれる内容の要旨
XDM6220 OPERATION Notes 19
ページ20に含まれる内容の要旨
Dual Electronics Corp. 21318 64th Ave. South Kent, WA 98032 Toll Free: 1-866-382-5476 www.dualav.com ©2005 Dual Electronics Corp. All rights reserved. Windows Media and the Windows logo are trademarks, or registered trademarks of Microsoft Corporation in the United States and or other countries. NSA0505-V01
