ページ1に含まれる内容の要旨
OPERATION AND PARTS MANUAL
SERIES
MODELS
MVH-306D (RECOIL START)
MVH-306DS (ELECTRIC START)
REVERSIBLE PLATE COMPACTOR
(YANMAR L-70EE DIESEL ENGINE)
Revision #11 (04/04/14)
To find the latest revision of this
publication, visit our website at:
www.multiquip.com
THIS MANUAL MUST ACCOMPANY THE EQUIPMENT AT ALL TIMES.
ページ2に含まれる内容の要旨
PROPOSITION 65 WARNING Diesel engine exhaust and some of PAGE 2 — MVH306D/DS PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #11 (02/04/14)
ページ3に含まれる内容の要旨
NOTES MVH306D/DS PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #11 (02/04/14) — PAGE 3
ページ4に含まれる内容の要旨
TABLE OF CONTENTS Yanmar L-70EE Diesel Engine MIKASA MVH-306D/DS- Cylinder Block Assembly .................................... 50-51 REVERSIBLE PLATE Cylinder Head and Cover Assembly .................. 52-53 COMPACTOR Muffler Assembly ............................................... 54-55 Air Cleaner Assembly......................................... 56-57 Proposition 65 Warning ..............................................2 Crankshaft, Piston and Camshaft Assembly ..... 58-59 Table Of Contents
ページ5に含まれる内容の要旨
PARTS ORDERING PROCEDURES Ordering parts has never been easier! Choose from three easy options: Effective: st January 1 , 2006 Best Deal! Order via Internet (Dealers Only): If you have an MQ Account, to obtain a Username Order parts on-line using Multiquip’s SmartEquip website! and Password, E-mail us at: parts@multiquip. com. ■ View Parts Diagrams To obtain an MQ Account, contact your ■ Order Parts District Sales Manager for more information. ■ Print Specification Information Use the int
ページ6に含まれる内容の要旨
SAFETY INFORMATION Do not operate or service the equipment before reading Potential hazards associated with the operation of this the entire manual. Safety precautions should be followed equipment will be referenced with hazard symbols which at all times when operating this equipment. may appear throughout this manual in conjunction with Failure to read and understand the safety safety messages. messages and operating instructions could Lethal Exhaust Gases result in injury to yourself and ot
ページ7に含まれる内容の要旨
SAFETY INFORMATION GENERAL SAFETY NOTICE CAUTION This equipment should only be operated by trained and qualified personnel 18 years of age and older. NEVER operate this equipment without proper protective clothing, shatterproof glasses, respiratory protection, Whenever necessary, replace nameplate, operation and hearing protection, steel-toed boots and other protective safety decals when they become difficult read. devices required by the job or city and state regulations. Manufacturer
ページ8に含まれる内容の要旨
SAFETY INFORMATION COMPACTOR SAFETY WARNING DANGER DO NOT place hands or fingers inside engine compartment when engine is running. NEVER operate the equipment in an explosive atmosphere or near combustible materials. An NEVER operate the engine with heat shields or explosion or fire could result causing severe guards removed. bodily harm or even death. Keep fingers, hands hair and clothing away WARNING from all moving parts to prevent injury. NEVER disconnect any emergency or safety
ページ9に含まれる内容の要旨
SAFETY INFORMATION FUEL SAFETY BATTERY SAFETY (ELECTRIC START ONLY) DANGER DANGER DO NOT add fuel to equipment if it is placed inside truck DO NOT drop the battery. There is a possibility that the bed with plastic liner. Possibility exists of explosion or battery will explode. fire due to static electricity. DO NOT expose the battery to open flames, sparks, cigarettes, etc. The battery contains FUEL combustible gases and liquids. If these gases and liquids come into contact with a flame
ページ10に含まれる内容の要旨
SAFETY INFORMATION TRANSPORTING SAFETY CAUTION NEVER allow any person or animal to stand underneath the equipment while lifting. NOTICE Before lifting, make sure that the equipment parts (hook and vibration insulator) are not damaged and screws are not loose or missing. Always make sure crane or lifitng device has been properly secured to the lifting bail (hook) of the equipment. ALWAYS shutdown engine before transporting. NEVER lift the equipment while the engine is running. Tight
ページ11に含まれる内容の要旨
SPECIFICATIONS Table 1. MVH-306D/DS Reversible Plate Compactor Specifications C) entrifugal Force 10,125 lbs. (4,593 kg V) ibration Frequency 4,400 vpm (70 Hz Traveling Speed 0 to 75 ft/min (0 to 23 m/min) Plate Size (L x W) 18 x 34 in (45.72 x 86.36 cm) External Plate Size (L x W) 24 x 34 in (60.96 x 86.36 cm) Max. Area of Compaction (no extensions) 6,750 sq. ft. (2,057 sq. meters) O) verall Length 61.8 in (1570 mm O) verall Width 18.0 in (457 mm O) verall Height (with handle) 44.1 in (1120 mm
ページ12に含まれる内容の要旨
DIMENSIONS Figure 3. MVH-306D/DS Reversible Plate Compactor Dimensions TABLE 3. DIMENSIONS RS EF. DIMENSION A) 53 in. (134.6 cm. B) 18 in. (46 cm. C) 34 in. (86 cm. D) 63.8 in. (162 cm. E) 32.5 in. (82.5 cm. PAGE 12 — MVH306D/DS PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #11 (02/04/14)
ページ13に含まれる内容の要旨
GENERAL INFORMATION Plate Compactor Frequency/Speed The Mikasa MVH-306D/DS is a walk behind, reversible plate The compactor's vibrating plate maximum frequency is 4400 compactor designed for the compaction of sand, clay and vpm (vibrations per minute). The forward and reverse travel speed asphalt. This plate compactor is a powerful compacting tool of the compactor is approximately 75 ft./minute (23 meters/ capable of applying a tremendous force in consecutive high minute). frequency vibrations
ページ14に含まれる内容の要旨
COMPONENTS Figure 4. MVH-306D/DS Reversible Plate Compactor Components Figure 4 illustrates the location of the major components for the MVH-306D/DS Reversible Plate Compactor. The function of each component is described below: 8. Belt Cover – Remove this cover to gain access to the V- 1. Hand Grip – When operating the compactor use this hand belts. NEVER run the compactor without the V-belt cover. If grip to manuever the compactor. the V-belt cover is not installed, the possibility exist tha
ページ15に含まれる内容の要旨
BASIC ENGINE Figure 5. MVH-306D/DS Engine Components ENGINE COMPONENTS 6. Recoil Starter– Manual-starting method. Pull the starter Figure 5 illustrates the location of the major lever components of grip until resistance is felt, then pull briskly and smoothly. the machine. Each component is described below: 1. Fuel Filler Cap – Remove this cap to add unleaded 7. Oil Filler Cap / Dipstick – Remove this cap to add oil to the gasoline to the fuel tank. Make sure cap is tighten securely. engine cra
ページ16に含まれる内容の要旨
INSPECTION CAUTION 4. If the oil level is low (Figure 7), fill to the edge of the oil filler hole with the recommended oil type (Table 4). Maximum oil NEVER operate the compactor in a capacity is 1.16 quarts (1.10 liters). confined area or enclosed area structure that does not provide ample free flow of air. CAUTION ALWAYS wear approved eye and hearing protection before operating the compactor. Before Starting Figure 7. Engine Oil Leve 1. Read safety instructions at the beginning of man
ページ17に含まれる内容の要旨
INSPECTION CAUTION DANGER DO NOT overfill hydraulic oil tank. This could cause oil EXPLOSIVE FUEL! leaks and sluggish operation. Clean cap and surrounding Motor fuels are highly flammable and can area before opening to prevent dirt from entering oil tank. be dangerous if mishandled. DO NOT smoke while refueling. DO NOT attempt to refuel if the engine is hot or running. 5. When adding hydraulic oil, only fill to the specified oil level as marked on the front of the hydraulic oil tank (F
ページ18に含まれる内容の要旨
OPERATION CAUTION DO NOT attempt to operate the compactor until the Safety, General Information and Inspection sections of this manual have been read and thoroughly understood. Releasing the Handle Figure 14. Handle Adjustment 1. Pull the handle release pin, (Figure 13) then push down on the hand grip to release the handle. STARTING THE ENGINE Electric Start (Option) 1. Open the fuel cock (Figure 15). Figure 15. Open Fuel Cock 2. Place the throttle lever (Figure 16) in the START positio
ページ19に含まれる内容の要旨
OPERATION 5. If the engine fails to start, DO NOT continue to rotate the ignition key for more than 5 seconds. Return the key to the RUN position and wait 10 seconds before starting again Figure 18. Engine Start Handle 4. Push down decompression lever (Figure 19) and Figure 17. Starter Switch (Option) release. CAUTION While the engine is running, never try to turn the ignition key to the START position. 6. After starting the engine, continue to warm up the engine for about 3 to 10 seconds
ページ20に含まれる内容の要旨
OPERATION NOTICE ALWAYS move the throttle lever quickly without hesitation, because increasing the engine speed slowly causes the clutch to slip. 3. To make the compactor move in the forward direction push the travel lever ( Figure 21) forward. Figure 22. Throttle Lever (Stop) Figure 23. Starter Switch (STOP) Figure 21. Travel Lever Emergency Shutdown 4. To make the compactor move in the reverse direction pull the travel lever ( Figure 21) backwards. 1. For a recoil start type engine, mo
