ページ1に含まれる内容の要旨
05-04-06
MODEL CA100
REMOTE CONTROL AUTO ALARM SYSTEM
INSTALLATION & OPERATION INSTRUCTIONS
WIRING DIAGRAM
6 Pin White Mini Connector
6 Pin
Black Antenna Wire
White
2 Pin LED Indicator
2 Pin
Valet Switch
White
Blue
Blue Wire: (-) 200mA Unlock Pulse
2 Pin
White
Green Wire: (-) 200mA Lock Pulse
5 Pin
Main 5 Pin White harness
White
MAIN 5 PIN WIRE HARNESS:
1. Red / White Wire: Parking Light Relay Power Input
2. White Wire: Parking Light Relay Output
3. Black Wire: G
ページ2に含まれる内容の要旨
05-04-06 Exit: Turn Ignition to 'OFF' position, or leave it for 15 seconds. Three long chirps & Three parking light flashes confirm exit. B. ALARM FEATURES PROGRAMMING: ALARM FEATURE “I” PRORAMMING: 1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position. nd 2. Push the Valet switch 2 times and holding in on 2 push until one short chirp with one long chirp is heard then release the valet switch. You are now in the Alarm feature ‘I’ programming mode. 3. Press and release
ページ3に含まれる内容の要旨
05-04-06 6. Hit the bumper or strong metal part of the vehicle to test the threshold level of the sensor. a). Activate the warn-away (first stage the shock sensor), the siren will emit a short chirp. b). Activate the full alarm (second stage the shock sensor), the siren will emit a long chirp. 7. When you are satisfied with the second stage the shock sensor setting, press and hold and button at the same time for 2 seconds. Two long siren chirps to indicate the unit is ready to accept ad
ページ4に含まれる内容の要旨
05-04-06 The vehicle doors will automatically lock after passive arming cycle has been completed. ACTIVE DISARMING – UNLOCK & DISARM: 1. Press button on the transmitter. 2. The siren will chirp twice and parking light will flash twice to indicating that the security system is now disarmed. The vehicle doors will unlock disarming when interfaced with the security system. Tamper Disarm: If alarm triggered, upon disarm the system, siren chirp 4 times, parking light flash 3 times. Two Step
ページ5に含まれる内容の要旨
05-04-06 This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions. (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. CA100 5
