ページ1に含まれる内容の要旨
6 COMPACT DISC AUTO CHANGER
MODEL : PAV-6CDP
OWNER S MANUAL
ページ2に含まれる内容の要旨
* Tracks from 6 CDs stored in the disc magazine can be selected and played. * Horizontal, vertical, angled and suspended installation. * Do not install the unit in a location where it may be subjected to : - direct sun or other forms of excessive temperature. - excessive heat. - fluid, rain or moisture. - excessive dirt or dust. - excessive vibration. * This unit is designed to be operated on a 13.8 volt DC negative ground electrical system only. Notes on CDs * A defective or soiled
ページ3に含まれる内容の要旨
* Do not expose the discs to direct sunlight or excessive heat. * Clean the discs before inserting them into the disc magazine. Always clean a disc from center outward with a cleaning cloth. * Never use solvents such as benzine or alcohol to clean a disc. * You cannot play an 8cm(3 inch) CD even with the specially designed adapter. Notes on the disc magazine * Do not leave the disc magazine in a place subject to excessive temperature or humidity. * Do not insert more than one disc pe
ページ4に含まれる内容の要旨
3. Insert the magazine firmly 1. * Pull out the slot by pulling (which has been taken out the part with finger. of the unit) with the mark visible on the top side. * With the label side up, insert a CD all the way 6 discs, one in each slot * Push slot and close it. * Press the eject button and pull out the disc magazine. 4. 2. 3
ページ5に含まれる内容の要旨
Supplied mounting kit BRACKET X 2 Double-sided TAPPING Adhesive tape X 1 SCREW X 4 label X 1 WASHER PLATE BOLT X 4 NUT X 4 SCREW X 4 BRACKET Precautions Select the mounting location very carefully by referring to the following points * Make sure that there is not a fuel tank, wiring or piping on the other side of the mounting surface. * Make sure that the installation of the unit will not hinder the movement of the trunk lid or interfere with the spare tire etc. * Use only t
ページ6に含まれる内容の要旨
Removing the transport Installing the unit Mounting angle setting lever screws Be sure to adjust Mounting Angle Find the 3 transport screws at the Setting Lever(A) to appropriate bottom of the unit, which lock the angle; 0 for horizontal, 22.5 unit s mechanism during transport. angle, 45 angle, 67.5 angle, 80 Remove these screws before angle, or 90 for vertical. installation and attach the supplied adhesive labels over the holes. Retain these screws and replace them in the original
ページ7に含まれる内容の要旨
After adjustment, be sure to Making holes on the carpet attach the Double side Tape . Note Do the same procedure on the other side of the unit. Completion Horizontal installation Construction Note About parts numbers ,refer to page 4. angled installation Removing temporarily Be sure to turn the mounting angle setting dial to the 45 position. 6
ページ8に含まれる内容の要旨
Vertical installation 3. Making holes on the carpet 1. Construction 4. Completion 2. Removing temporarily Note About parts numbers , refer to page 4. 7
ページ9に含まれる内容の要旨
2. Making holes Suspended installation When installing the unit in the trunk under the rear window shelf, observe the following. - Make sure that the unit is suspended horizontally. - Select the mounting location carefully so that the unit does not hinder the movement of the torsion bars of the trunk lid. - Make sure that there is nothing on the other side of the mounting location before drilling 3. Completion the holes. - Select the correct size screw to avoid damaging the veh
ページ10に含まれる内容の要旨
When connecting, run the Caution supplied connecting cable and Make sure to disconnect the ground connect to Audiovox model wire terminal of the car battery before PAV-9 as illustrated here. making a connection in order to prevent short circuiting. Note Use only the supplied connecting cable. For complete operation instructions, refer to pages 18,19 and 20 in the PAV-9 owner’s manual. General System 6 CD Change system Usable Disc Compact disc (12cm) Power Source DC 13.8V Negative ground
ページ11に含まれる内容の要旨
12 MONTH LIMITED WARRANTY Applies to Audiovox Video products AUDIOVOX ELECTRONICS CORPORATION (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 12 months from the date of original purchase, such defect(s) will be repaired or replaced with reconditioned product (at the Company s option) without charge for parts and repair labor. To obtain repa
