ページ1に含まれる内容の要旨
website http://www.lgservice.com
e-mail http://www.lgeservice.com/techsup.html
ROOM AIR CONDITIONER
OWNER'S MANUAL
Please read the operating instructions and safety precautions carefully
and thoroughly before installing and operating your room air conditioner.
MANUEL D'UTILISATION
CLIMATISEUR DE FENÊTRE
Veuillez lire attentivement et en entier ce guide d’utilisation et les
mesures de sécurité ci-incluses avant de procéder à l’installation et au
fonctionnement de votre climatiseur.
AIRE ACONDI
ページ2に含まれる内容の要旨
Safety Precautions Safety Precautions .............3 FOR YOUR RECORDS Staple your receipt to this page in case you need it later. Write down the model and serial numbers here: Model # Serial # You can find them on a label on the side of each unit. Electrical Data Dealer's Name Electrical Data ....................5 Date Purchased READ THIS MANUAL Inside you will find many helpful hints on how to use and maintain your air conditioner properly. Just a little preventive care on your part can save yo
ページ3に含まれる内容の要旨
Safety Precautions Safety Precautions To prevent injury to the user or other people and property damage, the following instructions must be followed. n Incorrect operation due to ignoring of instruction will cause harm or damage. The seriousness is classified by the following indications. WARNING : This symbol indicates the possibility of death or serious injury. This symbol indicates the possibility of injury or damage to CAUTION : properties only. n Meanings of symbols used in this manual ar
ページ4に含まれる内容の要旨
CAUTION CAUTION When the air filter is to be Do not clean the air When the unit is to be conditioner with water. cleaned, switch off, and turn removed, do not touch the off the breaker. metal parts of the unit. • They are sharp and may cause • Water may enter the unit and • Since the fan rotates at high degrade the insulation. It may an injury. speed during operation, it may cause an electric shock. cause an injury. Do not put a pet or house Do not use for special Do not operate switches plant
ページ5に含まれる内容の要旨
Electrical Data Electrical Data Electrical Data(For 115V model) Line Cord Plug Use Wall Receptacle Power Supply Do not under any circumstances cut or remove the Use 15 AMP time Parallel grounding prong delay fuse or 15 AMP type from the plug. circuit breaker. Power supply cord with Standard 125V, 3-wire grounding 3-prong grounding plug receptacle rated 15A, 125V AC USE OF EXTENSION CORDS Because of potential safety hazards, we strongly discourage the use of an extension cord. However, if you
ページ6に含まれる内容の要旨
r e l o o C About the Controls on the Air Conditioner The controls will look like one of the following: Controls – Cooling Only Operation Off - Turns air conditioner off. Off Med Fan - Med speed fan operation without cooling. Med High Low Fan - Low speed fan operation without cooling. Fan Cool High Cool - Cooling with high speed fan operation. Med Cool - Cooling with med speed fan operation. Low Cool - Cooling with low speed fan operation. Low Med Fan Cool Low Cool Thermostat 5 This automaticall
ページ7に含まれる内容の要旨
About the Controls on the Air Conditioner The controls will look like one of the following: Controls – Cooling & Heating Operation O Off ( ) :Turns the air conditioner off. o Fan ( ) : The low fan speed operation without cooling (heating). Low Cool ( ) : Cooling with the low speed fan operation. High Cool ( ) : Cooling with the high speed fan operation. Low Heat ( ) : Heating with the low speed fan operation. High Heat ( ) : Heating with the high speed fan operation
ページ8に含まれる内容の要旨
Additional controls and important information. Ventilation The ventilation lever is located in the right of the air discharge. The ventilation lever must be in the CLOSE position in order to maintain the best cooling conditions. When fresh air is necessary in the room, set the ventilation lever to the OPEN position. The damper is opened and room air is exhausted outside. PULL OPEN / PUSH CLOSE Air Direction The direction of air can be controlled wherever you want by adjusting the horizontal lou
ページ9に含まれる内容の要旨
About the Controls on the Air Conditioner Care and Maintenance TURN THE AIR CONDITIONER OFF AND REMOVE THE PLUG FROM THE POWER OUTLET. Air Filter Cleaning The air filter should be checked at least twice a month to see if cleaning is necessary. Trapped particles in the filter will build up and block the airflow. This reduces the cooling capacity and also causes an accumulation of frost on the cooling coils. If the filter becomes turn or damaged you should replace immediately. Replacement filters
ページ10に含まれる内容の要旨
Features and Installation Learning parts name prior to installation will help you understand the installation procedure. Features The Unit 1 5 7 3 6 2 4 11 8 9 10 13 14 12 15 The Sleeve and the Rear Grille (optional) 18 17 16 1. CABINET 11. EVAPORATOR 2. HORIZONTAL AIR DEFLECTOR 12. CONDENSER (Vertical Louver) 13. COMPRESSOR 3. VERTICAL AIR DEFLECTOR 14. BASE PAN (Horizontal Louver) 15. BRACE 4. AIR DISCHARGE 16. SLEEVE ASSEMBLY 5. FRONT GRILLE (Including Expanded Aluminum Rear grille, 6. INLET
ページ11に含まれる内容の要旨
Features and Installation How to Install the Unit CAUTION : There are sharp edges that can cause serious cuts. CAUTION : When lifting the air conditioner, it is HEAVY. Use 2 peoples to lift. For existing sleeve, you should measure the wall sleeve dimensions. You can install the new air conditioner according to these installation instructions to achieve the best performence. All wall sleeves used to mount the new air conditioner must be in good structural condition and have the rear grille that s
ページ12に含まれる内容の要旨
Installation Kits Contents 1 Insulation Front (1 ea) 2 Insulation Horizontal (2 ea) (Adhesive backed) 2,100 mm 670 mm Sleeve Assembly (optional, including expanded aluminum metal grille) 3 Insulation Vertical (4 ea) 4 Support Block (4 ea) 5 Baffle (2 ea) Louvered Grille (Adhesive backed) (Adhesive backed) (Plastic sheet) (optional) 2 355 mm Air Conditioner 1 3 4 Trim (2 ea) 5 12 Features and Installation
ページ13に含まれる内容の要旨
Features and Installation 2. Prepare the wall sleeve for Width of the existing A B installation of the new unit according wall sleeve to the following installation 1 3 3 25- /2" (648 mm) 2- /4" (70 mm) 4- /4" (120 mm) procedures. Before you prepare the 3 3 wall sleeve, you should check the 25- /4" (654 mm) 2- /4" (70 mm) 5" (130 mm) wall sleeve dimensions. 26" (660 mm) 3" (75 mm) 5" (130 mm) 3. Redirect the louvers at the back of 3 1 1 26- /4" (680 mm) 3- /4" (80 mm) 5- /2" (140 mm) the wall sle
ページ14に含まれる内容の要旨
1 A+ /4" Remove the backing from vertical and (6 mm) horizontal insulation and attach them to 1 the inside of the wall sleeve as shown B+ /4" (6 mm) below. Wall Remove the backing from the support Insulation Horizontal blocks and attach them to the inside of Wall Sleeve the wall sleeve as shown below. Slide Insulation the baffles in the slots of the support Vertical blocks. Front A Remove the backing from vertical B insulation and attach them to the back of the unit as sho
ページ15に含まれる内容の要旨
Before you call for service... Before you call for service... Before you call for service... Troubleshooting Tips Save time and money! Review the chart below first and you may not need to call for service. Normal Operation • You may hear a pinging noise caused by water being picked up and thrown against the condenser on rainy days or when the humidity is high. This design feature helps remove moisture and improve efficiency. • You may hear the thermostat click when the compressor cycles on and
