ページ1に含まれる内容の要旨
AZ102S
CD Soundmachine AZ1022
AZ102C
AZ102N
AZ102G
Register your product and get support at
AZ102V
www.philips.com/welcome
AZ102R
AZ102B
User Manual
ページ2に含まれる内容の要旨
S H UF F L E R E P E A T 1 8 DYNAMIC BASS BOOST 0 @ VOLUME TUNING 7 1 CD SOUNDMACHINE AZ102 6 2 5 3 4 L I F T P R O T G O O P E N
ページ3に含まれる内容の要旨
2
ページ4に含まれる内容の要旨
7 3 4 8 5 PROG X 6 ALL
ページ5に含まれる内容の要旨
English Controls/Power Supply Congratula tions on your purchase and CAUTION welcome to Philips! – Visible and invisible laser radiation. If the cover is open, do not look at the beam. To fully benefit from the support that – H igh voltage! Do not open.You run the Philips offers, register your product at www.philips.com/welcome. risk of getting an electric shock. The machine does not contain any user- serviceable parts. Supplied Accessories – M odification of the product could result –
ページ6に含まれる内容の要旨
Power Supply General Operation / Tuner Using AC power General operation WArNINg: Always check you have Switching on and off and selecting the completely switched off the set, before function you change or disconnect power supply. 1 To select your sound source, adjust the 1 Check if the power voltage, as shown on Source selector to: CD, FM or MW. the type plate located on the bottom 2 To switch off the set, adjust the Source of the set, corresponds to your local selector to OFF posit
ページ7に含まれる内容の要旨
CD Player Playing a CD Selecting a different track • This CD player plays Audio Discs • Press ∞ / § once or repeatedly until the including CD-Recordables (CD-R) and desired track number appears in the display. CD-Rewritables (CD-RW). • In the pause/stop position, press 2; to start playback. • MP3, CD-ROM, CD-I, CDV, VCD, DVD or computer CDs are not possible for playback. IMPORTANT! Finding a passage within a track CDs encoded with copyright protection 1 During playback, press
ページ8に含まれる内容の要旨
CD Player Programming track Different play modes: numbers REPEAT. and SHUFFLE You may store up to 20 tracks in the desired (See 6, 7) sequence. If you like, store any track more REPEAT than once. You can play the current track or the whole disc repeatedly, and combine REPEAT 1 In the stop position, press PROG to modes with PROG (PROGRAM). activate programming. Ü Display: PROG and 00 flash. (See 5) REP – plays the current track continuously. REP ALL – repeats the entire CD/program 2
ページ9に含まれる内容の要旨
Maintenance & Safety ( ) 8 See CD player and CD handling Safety information • If the CD player cannot read CDs correctly, • Place the set on a flat, hard and stable use a cleaning CD to clean the lens before surface so that the system does not tilt. taking the set to repair. • Where the MAINS plug or an appliance • The lens of the CD player should never be coupler is used as the disconnect device, touched! the disconnect device shall remain readily operabl
ページ10に含まれる内容の要旨
Troubleshooting If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WArNINg: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee. Problem Note: Make sure the CD is not encoded with – Possible cause copyright protection technologies, as some •
ページ11に含まれる内容の要旨
Environmental information All unnecessary packaging material has been omitted. The packaging can be easily separated into three materials: cardboard, polystyrene and plastic. Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging, dead batteries and old equipment. Specifications Power consumption ......................................................................................
ページ12に含まれる内容の要旨
Meet Philips at the Internet http://www.philips.com CLASS 1 LASER PRODUCT AZ102S AZ102C AZ102N AZ102G AZ102V AZ102R AZ102B Printed in China AZ102_98_UM_V3.0
