ページ2に含まれる内容の要旨
notice is used to sa Ve this Manual address practices Keep this manual for the safety warn- not related to personal injury. ings and precautions, assembly, operat- caution, without ing, inspection, maintenance and cleaning the safety alert procedures. Write the product’s serial symbol, is used to address number in the back of the manual near the practices not related to assembly diagram (or month and year of personal injury. purchase if product has no number). Keep this manual and
ページ3に含まれる内容の要旨
inattention while operating the Solar grounded. Ground Fault Circuit Inter- Security Light may result in serious rupter (GFCI) should also be imple- personal injury. mented – it prevents sustained elec- trical shock. 2. Use the Solar Security Light only with specifically designated battery packs. general safety Use of any other battery packs may create a risk of injury and fire. 1. Do not use Solar Security Light for other than intended use. 3. When battery pack is not in use, keep it away
ページ4に含まれる内容の要旨
Panel (2) can be installed only as far speciFications apart as the connecting wire allows. Charge Time 6-8 hours 4. Choose a location that receives full, (5), 1.2V, 600 mAh/6V, Ni-Cd direct sunlight a minimum of eight Power Source rechargeable battery pack hours a day. The location should not Detects motion over a range of Range be near nighttime light sources such 120° at 16 feet. as porch lights or streetlights as this Delay 5-60 seconds will cause the Light to remain off. Working 14°
ページ5に含まれる内容の要旨
remove the Covers (3) to allow for operation insertion of the Screws. read the entire iMportant 8. Set the Lamp (1) to the angle height saFeguards section at the Drill holes for the enclosed screws. beginning of this manual Make certain that the drilling path is including all text under clear of obstacles such as cables, subheadings therein before set gas and water pipes and electrical up or use of this product. lines. Insert anchors into the holes. Figure 2 Thread in the enclosed Sc
ページ6に含まれる内容の要旨
replacing the batteries inspection and Maintenance Figure 3 t o preVent serious injury Lamp Battery FroM accidental Pack Base operation or electric Motion shock: Detector before appliance inspection Head or maintenance, make sure 1. The Battery Pack is located in the the appliance’s switch is Base of the Lamp (1). Remove the turned off, and the unit has screws that connect the base togeth- cooled completely. er. Separate the base as shown in t o preVent serious Figure 3. in
ページ7に含まれる内容の要旨
please read the FolloWing careFully THe MANUFACTUReR AND/OR DISTRIBUTOR HAS PROVIDeD THe PARTS LIST AND ASSeMBLy DIAGRAM IN THIS MANUAL AS A ReFeReNCe TOOL ONLy. NeITHeR THe MANUFACTUReR OR DISTRIBUTOR MAKeS ANy RePReSeNTATION OR WARRANTy OF ANy KIND TO THe BUyeR THAT He OR SHe IS qUALIFIeD TO MAKe ANy RePAIRS TO THe PRODUCT, OR THAT He OR SHe IS qUALIFIeD TO RePLACe ANy PARTS OF THe PRODUCT. IN FACT, THe MANUFACTUReR AND/ OR DISTRIBUTOR exPReSSL y STATeS THAT ALL RePAIRS AND PARTS RePLACeM
ページ1に含まれる内容の要旨
36 led solar
security light
Model 98085
asseMbly and operation instructions
Diagrams within this manual may not be drawn proportionally.
Due to continuing improvements, actual product may differ slightly from the product described herein.
®
distributed exclusively by harbor Freight t ools .
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our website at: http://www.harborfreight.com
read this material before using this product.
Failure to do so can result in serious injury.
sa Ve this Man
