ページ1に含まれる内容の要旨
INSTALLATION INSTRUCTIONS
LAT-NR160
LED Tail Lights for ‘64-’66 Chevelle, ’71-’72 Chevelle,
and ’66-’67 Nova
MAN#650158
Kit Includes:
Installation:
‘64 Chevelle ‘65 Chevelle ‘66 Chevelle ‘71-‘72 Chevelle ‘66-67 Nova
1 2 3
1. Remove the tail light lens.
2. Remove the light bulb.
3. Remove the original bulb connector from the back side of the housing. The housing may need
to be removed from the car on the ’71-’72 Chevel
ページ2に含まれる内容の要旨
4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is recommended. 5. Remove the screw and aluminum back plate from the back of the new LED assembly. LED assembly standard back back for ‘71-‘72 Chevelle (attached to the assembly) (packaged separately) 6. Insert the new LED assembly through the front of the tail light housing and align the LED assembly with the hole where the original bulb and connector were located. Use cauti
ページ3に含まれる内容の要旨
8. Secure the back plate with the supplied screw and washer. 9. Make sure the original lens gasket is in place and then replace the tail light lens. Tighten the screws down carefully. MAN#650158
ページ4に含まれる内容の要旨
10. Start by cutting off the existing light socket as it will not be used. Do not strip wires. Trim the wires from LED assembly to appropriate length once mounted, making sure wires are routed cleanly and securely. 11. Use the supplied moisture resistant pigtail connectors* to attach the wires from the new LED assembly to the existing vehicle harness. Insert appropriate wire from vehicle harness and mating LED assembly wire into a connector and crimp following instructions below. *Fo
