ページ1に含まれる内容の要旨
TABLE OF CONTENTS
WS-9228U-IT
Topic Page
Wireless 915 MHz
Inventory of Contents/Additional Equipment
About WWVB
Radio-controlled Weather Station
Quick Set-Up Guide
Detailed Set-Up Guide
Instruction Manual
Battery installation
Program Mode
Program Sequence and Default Settings
Function Keys
Setting the LCD Contrast
Setting the Time Zone
Daylight Saving Time Setting
Radio-controlled Time Setting
12/24-hour Time Setting
Setting the
ページ2に含まれる内容の要旨
To complete the set up of your Wireless Weather Station after the 15 minutes have passed * When the signal is successfully received by the Weather Station, the icon will be please follow the steps that follow in the Detailed Set-Up Guide. switched on. (If not successful, the icon will not be shown in LCD) So the user can easily see whether the last reception was successful (icon on) or not (icon off). On the DETAILED SET-UP GUIDE other hand, the short blinking of the icon shows that a recept
ページ3に含まれる内容の要旨
Note: When in the 12-hour format “P.M.” will appear to the left of the hour 6. Press and release the SET button to confirm and advance to the day/month in the time LCD between the hours of noon and midnight. setting. 7. The day and month will flash in the date LCD. 6. Press and release the SET button to confirm and advance to the time setting. VIII. TIME SETTING There are two methods by which the time and date can be set: A) Automatically via WWVB reception, or 8. Press and rel
ページ4に含まれる内容の要旨
IV. MINIMUM AND MAXIMUM TEMPERATURE RECORDS V. ALARM FUNCTION The WS-9228U-IT keeps a record of the MINIMUM and MAXIMUM temperature, and the time and date of their occurrence—for both the indoor and outdoor modes. A. SETTING THE ALARM (alarms 1 and 2) A. VIEWING THE INDOOR TEMPERATURE AND HUMIDITY RECORDS Note: There are two alarms that can set. Each alarm will sound for a complete 1. Press the IN button once. “MIN” appears above the indoor duration of 2 minutes. temperature an
ページ5に含まれる内容の要旨
the case can act as a heat sink to absorb and store heat from external sources (i.e. handling of the case or radiant heat). Also, the much greater range of the outdoor temperature sensor requires a different calibration curve than the indoor range. Error is usually greater at the extreme ends of a range, making it harder to compare B. WALL MOUNTING different ranges with different curves. Under non-laboratory conditions, it is difficult to 1) Remove the table-stand. To do this, pull do
