ページ1に含まれる内容の要旨
TABLE OF CONTENTS
INTRODUCTION 3
PRODUCT OVERVIEW 4
REMOTE RAIN GAUGE 9
REMOTE SENSOR 10
BEFORE YOU BEGIN 11
BATTERY INSTALLATION 13
REMOTE TEMPERATURE SENSOR 14
Wireless Rain Gauge
MAIN UNIT 14
LOW BATTERY WARNING 14
HOW TO USE THE TABLE STAND 14
GETTING STARTED 15
REMOTE AND INDOOR TEMPERATURES 15
AUTO-SCANNING 16
CHECKING REMOTE RAINFALL DATA 16
MAXIMUM AND MINIMUM TEMPERATURE 17
LOST COMMUNICATION 17
TRANSMISSION COLLISION 19
CALENDAR AND CLOCK DISPLAY MODES 19
MANUAL SETTI
ページ2に含まれる内容の要旨
FRONT VIEW (RAIN MODE CONTROL PANEL) E. DOWN ( ) button A. WEATHER AND TIME INFORMATION IN A • Toggles between the rainfall modes – for past hour, for THREE - LINE LCD DISPLAY the past 24 hours, and for the past 7 days • Decreases all function parameters; press and hold for rapid decrease A • Enables or disables high rain alarm • Enforces the remote rain gauge signal search CH F. MEMORY button AM • Toggles between the rainfall memory modes – for the ZONE PM PRE-AL
ページ3に含まれる内容の要旨
SIZE AA/UM3 SIZE AA/UM3 REMOTE RAIN GAUGE REMOTE SENSOR FEATURES • Remote temperature transmission to the main unit via 433 MHz signal • 100 feet (30 meters) transmission range without interference G H D • LCD display of measured temperature • Three transmission (3) channels selection • Selection of the temperature display in Celsius or Fahrenheit • Case can be wall mounted using built-in hanger E 4 3 3 M H z W I R E L E S S E 1 2 3 C 1 2 3 CHANNEL RESET ˚C/˚F F A I D F B THERMO – SEN
ページ4に含まれる内容の要旨
BATTERY INSTALLATION REMOTE TEMPERATURE SENSOR REMOTE RAIN GAUGE NOTE: Install the batteries; select the channel and • Unlock the funnel-shaped top on the rain gauge by temperature in C° or F° before mounting the remote turning both knobs on the sides in an anti-clockwise temperature sensor. direction. • Remove the screws from the battery compartment with a small Phillips screwdriver. • Remove the funnel-shaped top lifting it off the rain • Set the channel. The switch is located in
ページ5に含まれる内容の要旨
RAINFALL HISTORY • The path between units is clear of obstacles. Shorten the The rainfall history records will be automatically stored in distance if necessary. the memory of the main unit. There are three historical • Fresh batteries are installed correctly in both remote records may be displayed – for the past hour, past day and temperature sensor and main unit. past week. • If there is no reception, please perform the following steps: To display any of available rainfall history read
ページ6に含まれる内容の要旨
SETTING THE WEEKDAY AND SINGLE DAY ACTIVATING THE ALARM ALARMS • Press ALARM ON/OFF button to enter into the alarms • Press ALARM button once to enter into the alarms mode. setting mode. The default alarm is a Weekday alarm. • Press DOWN ( ) to activate or UP ( ) to deactivate The abbreviation “OFF” with a letter “ W ” next to it desired alarm. When alarms are activated, the will be displayed, if the alarm has not been set previously. corresponding icons will be
ページ7に含まれる内容の要旨
DECLARATION OF CONFORMITY FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation We is subject to the following two conditions: (1) This device may Name: Hideki Electronics, Inc. not cause harmful interference, and (2) This device must accept Address: 7865 SW Mohawk, Tualatin, OR 97062 any interference received, including interference that may cause Telephone No.: 1-503-612-8395 undesired operation. declare that the product Product No.: TC150 Warning: Changes or modific