ページ1に含まれる内容の要旨
#90111 0207
Single Master Station with Door Release
- REFER TO INSTALLATION MANUAL INSIDE LEM-1DL BOX FOR STANDARD
INSTALLATION INFORMATION -
The LEM-1DL master station provides communication to and from a door station, and has a separate
button for door release. This supplemental instruction manual addresses many of the additional functions
and modifications for the LEM-1DL system, including installation and troubleshooting information.
MASTER STATION:
LEM-1DL: 1-call master station wit
ページ2に含まれる内容の要旨
WIRING DIAGRAM: Dual Master LEM-1DL System with DAK-2S Dual Master Adaptor Component LEM-1DL Please read and understand all LE-D Module* instructions before installation. 1 1 LEM-1DL Component Module* 1 E E E Leave E/- - jumper PT-1210N PT-1210N attached + + - - Door Strike Electric strike shown is being powered from same transformer powering the first LEM-1DL. EL EL EL EL IMPORTANT!!! Each master REQUIRES an individual power supply. OPERATION NOTES: 1. Only one master can be used at a time
ページ3に含まれる内容の要旨
WIRING DIAGRAM: LEM-1DL System with External Signaling using RY-AC Relay Component LE Series Module* LEM-1DL Sub 1 1 Output of RY-AC (Yellow wires) provide a momentary dry contact closure while E the call button on the door E station is being pressed. - NOTE: Intercom must PS-1225UL BELL WHITE be powered with 12V YELLOW RED DC power supply + + RY-AC Leave jumper when RY-AC is BLACK YELLOW between E and - - - connected. attached Power source for bell Component Module* Normally Open D
ページ4に含まれる内容の要旨
INSTALLATION TIPS: 1. Use shielded wire for the communication path, and ground one end of the shield to an earth ground. 2. Run intercom wire at least 20" away from AC wiring, fluorescent lights or dimmer switches. 3. Keep intercom cable away from alarm, data, phone, and video cables. 4. Door release wires must be in a separately jacketed cable from the intercom wires. Use two separate cables; one for audio and one for door release. 5. When installing a second master station, wire must be r
