ページ1に含まれる内容の要旨
WATER HOSE
ADAPTER
Instructions for Use
Model 2300-511
The Water Hose Adapter connects a
standard water hose to
TM
Hot Water on Demand . Once adapter
is in place and water is turned on at the
TM
source, use Hot Water on Demand
to turn water on & off and to select
desired water temperature.
ページ2に含まれる内容の要旨
TM Be sure Hot Water on Demand is turned off and no water is running through unit. Operate unit from a camp table or picnic table. Do not set it on ground to use. (Water will drain when unit is off, preventing dam- age in freezing temperatures. Attach Water Hose Adapter to Hot WATER HOSE ADAPTER TM Water on Demand : Parts Identifier 1. Remove water pump assembly: a. Disconnect water pump electrical connection from Adapter Water Water Tubing TM Hot Water on Demand (fig. 1). Inlet Fitting b. Remo
ページ3に含まれる内容の要旨
TM Attach Water Hose Adapter to To Start Hot Water on Demand (continued): TM Hot Water on Demand (continued): 2. Connect Water Hose Adapter to Hot Water on TM Demand : a. Connect Water Hose Adapter electrical connec- TM tion to Hot Water on Demand . b. Connect Water Hose Adapter to Hot Water on TM Demand by inserting Quick Connector. c. Connect and tighten water hose to adapter water inlet fitting. d. Connect water hose to water source. TM fig. 3 fig. 4 To Start Hot Water on Demand : 1. Turn o
ページ4に含まれる内容の要旨
Maintenance: To Clean: 1. In a clean container mix one-gallon of water with 6 oz. of a calcium, lime, and rust remover solution (available at hardware, general merchandise and food stores). 2. Disconnect water hose adapter from unit. 3. Unscrew water tubing from adapter body. 4. Detach clips from water tubing. 5. Submerge water tubing in cleaning solution. Allow to set five (5) minutes. 6. Run clean water through water tubing. 7. Air dry. 8. Reattach tubing to Water Hose Adapter and reattach cli
