ページ1に含まれる内容の要旨
QSControl.net™
Wall Control Plate
Accessories
INSTALLATION GUIDE
▼▼▼▼▼ WCP-1
▼▼▼▼▼ WCP-2
*TD-000215-00*
*TD-000215-00*
Rev. B
QSControl.net™ Wall Control Plate Accessories Installation Guide Rev. B
1
ページ2に含まれる内容の要旨
QSControl.net™ Wall Control Plate Accessories I. INTRODUCTION The WCP-1 and WCP-2 are wall control plate accessories for QSControl.net terminal strip for use with individual wires. Note: You must assign any network audio system components, such as Basis, RAVE, and DSP functions to their respective OmniPort inputs in the QSControl.net products. They allow an installer to create simple, non-computer user VenueManager application. interfaces for these products in sound systems. As a result, end use
ページ3に含まれる内容の要旨
R2 Non-QSControl.net applications CW Cut here The WCP-1 can be used for non-QSControl.net analog applications, such to insert as variable passive signal attenuation or a variable voltage divider (see resistor R2 CW Figure 5). The WCP-1 has two circuit board locations where you can Wiper 10K mount resistors to adjust the full clockwise and/or counterclockwise CCW values of the resistances and thereby change the range of attenuation or Cut here voltage variation from minimum to maximum. A resistor
ページ4に含まれる内容の要旨
V. WARRANTY AND DISCLAIMERS QSC Audio Products, Inc. is not liable for any damage to speakers, amplifiers, or PRODUCT RETURN GUIDELINES any other equipment that is caused by negligence or improper installation and/or 1. Pack the product securely for protection during shipment. QSC will use of the WCP wall control plate accessories. provide factory packaging free of charge, on request. 2. Include a copy of the sales receipt, your name, return address, phone PRODUCT WARRANTY number, and a descript
