ページ1に含まれる内容の要旨
Instructions for use
HOOD
Contents
GB
GB
Installation, 10-11
English
Assembly
Technical information, 12
Electrical connection
Power cable
Technical data
Description, 13
Filtering version
Ducting version
Operation, 14
Controls
HD 63 X
HD 73 X
Maintenance,15
HD 93 X
Cleaning the hood
Cleaning the grease filters
Replacing the charcoal filter
Replacing the lamps
Precautions and tips, 16
General safety
Air vent
Disposal
1
ページ2に含まれる内容の要旨
Installation Assembly GB Before proceeding with the assembly operations, 5) Once adjusted, finally fix the hood with a further remove the grease filters so that the hood is easier to 4 screws (D): Mark the 4 holes to be drilled on the handle (for the instructions see the paragraph wall, unhook the hood and drill the holes marked (8 “Cleaning the grease filters” in the chapter on mm diameter); then use the screw anchors and “Maintenance”). the screws provided for final fixing. FOR CORRECT FUNCTIO
ページ3に含まれる内容の要旨
GB d) Make the electrical connection of the hood by means of the power cable (refer to the paragraph “Electrical connection”). 3) Ducting version: e) Lower the lower flue resting it on the hood. f) Check if the charcoal filter (P) has been a) Connect the air vent of the hood to the air vent installed. If not yet installed, proceed by sliding hole using a flexible hose of 15 cm diameter. the 2 filter clips into their seats and turn the Lock the flexible hose with hose clamps (hose filter upwards.
ページ4に含まれる内容の要旨
Technical information which is marked with the letter N or coloured black; Electrical connection GB – the wire which is coloured brown must be connected to the terminal which is marked with the ! Arrange the electrical power supply within the letter L or coloured red. decorative flue dimensions. – the wire which is coloured green and yellow ! When making the electrical connections, check that must be connected to the terminal in the plug the voltage values correspond to those indicated on which
ページ5に含まれる内容の要旨
Description The hood may be in the filtering or ducting version. Ducting version GB Decide from the outset which type is to be installed. For better efficiency, we recommend installing the The hood aspirates air from the kitchen impregnated hood in the ducting version (if possible). with fumes and smells, passes it through the grease filters and then expels it to the outside through an exhaust duct. Filtering version For this version the charcoal filter does not need to be used. The hood aspirat
ページ6に含まれる内容の要旨
Operation Controls GB LIGHTING MOTOR DECREASE INCREASE BOOST SPEED Light button Speed increase button Turns the lights on/off. Repeatedly pressing the button will increase the motor speed until reaching the maximum speed. Motor button Activates/deactivates the motor. Boost speed button The motor is activated at the last speed set. Activates the motor at boost speed for 10 minutes, after which the motor goes back to running at the Speed decrease button speed set previously. Repeatedly pressing t
ページ7に含まれる内容の要旨
Maintenance ! Always switch off the electricity supply before Replacing the charcoal filter GB carrying out any cleaning or servicing operations on the appliance. If using the hood in the filtering version, the charcoal ! To avoid possible risks of fire always comply with filter (P) will periodically have to be replaced. the indicated instructions when cleaning grease First of all, remove the metal grease filters. Push the filters and when removing grease deposits from the catch towards the insi
ページ8に含まれる内容の要旨
Precautions and tips 04307812 General safety Disposal GB ! The distance between the supporting surface for The European Directive 2002/96/EC on Waste the cooking vessels on the hob and the lower part Electrical and Electronic Equipment (WEEE), requires of the hood must be at least 65 cm. that old household electrical appliances must If the instructions for installation for the hob specify not be disposed of in the normal unsorted municipal a greater distance, this has to be taken into account. w
