Greenheck Fan Tube Axial Upblast Fans TAUB-CAの取扱説明書

ページ1に含まれる内容の要旨

Part # 453905
READ AND SAVE THESE INSTRUCTIONS
TUBE AXIAL UPBLAST FANS
Model TAUD (Direct Drive, Aluminum Propeller)
®
Model TAUB-CA (Belt Drive, Aluminum Propeller)
Model TAUB (Belt Drive, Steel Propeller, High Temp.)
INSTALLATION, OPERATION AND MAINTENANCE MANUAL
Greenheck Model TAUD, TAUB-CA and TAUB fans are thoroughly inspected and test run at the factory, however damage may
occur during handling and shipping. Consequently, it is important that the unit be carefully inspected for visible

ページ2に含まれる内容の要旨

FOR MODEL TAUB (SIZES 42 thru 60) WITH UL LISTED SMOKE EXHAUST CONSTRUCTION Lifter Arm Spring Lifter Tube Point “A” Install pin here to lockout damper fifters IMPORTANT Electrical - This equipment must be LISTED U L POWER installed with remote overload R protection having adequate rating as to voltage, frequency, VENTILATOR horsepower and full load current per FOR phase. Where connected to a circuit Spring Bracket Point “B” SMOK E protected by fuses, use time delay Pin Storage Location fuse

ページ3に含まれる内容の要旨

ROUTINE MAINTENANCE FOR BELT DRIVE FANS — CAUTION: See **WARNING** on page 1 Once the fan has been put into operation, periodic maintenance should be scheduled to assure reliability and performance. The following items should be checked as a part of this maintenance schedule: 1. Fasteners and set screws 3. Lubrication 5. Removal of dust and dirt 2. Bearings 4. Belts 1. FASTENERS AND SET SCREWS - Normal fan vibration has a tendency to loosen mechanical fasteners. Periodic inspection should in

ページ4に含まれる内容の要旨

PARTS LIST Butterfly Dampers Outlet Screen (optional) Damper Hinge Rod Windband Windband Bracket Fusible Link Damper Lifters (optional) Motor Plate Tie Down Points Weatherhood Propeller Motor Bearing Cover Motor Pulley Shaft Bearings Belt(s) Fan Pulley Curb Cap Shaft Pulley Inlet Guard Access Door (optional) (optional) Always provide the fan serial number when requesting parts or information. WARRANTY Greenheck warrants this equipment to be free from defects in material and workmanship for a