ページ1に含まれる内容の要旨
3-260-754-11 (1)
CD Radio
Cassette-Corder
GB
GB
Operating Instructions page 2
CFD-CD777S MK2
© 2003 Sony Corporation
ページ2に含まれる内容の要旨
Warning To prevent fire or shock hazard, do not expose the player to rain or moisture. To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. Warning Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the appliance. The FUNCTION selector is located at the front. When you turn on the player, the OPR/BATT indicator lights up.
ページ3に含まれる内容の要旨
Basic Operations Table of contents Basic Operations Playing a CD .................................................. 4 Listening to the radio ...................................... 6 Playing a tape ................................................. 8 Recording on a tape ...................................... 10 Dubbing ........................................................ 12 The CD Player Using the display .......................................... 14 Locating a specific track .................
ページ4に含まれる内容の要旨
Basic Operations Playing a CD 14 2,3 For hookup instructions, see pages 19 – 20. 1 Set FUNCTION to CD. 2 Press Z PUSH OPEN/CLOSE down to open the lid of the CD compartment and place a CD on the CD compartment. With the label side up 3 Close the lid of the CD compartment. GB 4
ページ5に含まれる内容の要旨
Basic Operations Display 4 Press u (N on the remote). The player plays all the tracks once. Track number Playing time Use these buttons for additional operations FUNCTION ., > u Z PUSH OPEN/CLOSE VOLUME x Level meter Tip To Do this During operation, the level adjust the volume Turn VOLUME. meter shows the frequency level of the sound. stop playback Press x. Adjusting the volume will pause playback Press u. (On the remote, press not affect the level meter. X.) Press the button again to resume pl
ページ6に含まれる内容の要旨
Listening to the radio 12 33 For hookup instructions, see pages 19 – 20. 1 Set FUNCTION to RADIO. 2 Set BAND to select the band you want. 3 Turn TUNING to tune in the station you want. For better SW reception, use FINE TUNING. GB 6
ページ7に含まれる内容の要旨
Basic Operations Use these buttons for additional operations FUNCTION VOLUME Level meter Tips To Do this • During operation, the level adjust the volume Turn VOLUME . meter shows the frequency level of the sound. turn off the radio Set FUNCTION to TAPE• CD/ Adjusting the volume will RADIO OFF. not affect the level meter. • If the FM broadcast is noisy, set ISS•FM MODE To improve broadcast reception at the rear to “MONO”. Reorient the antenna for FM. Reorient the player itself for Radio will play
ページ8に含まれる内容の要旨
Playing a tape 32 1 32 For hookup instructions, see pages 19 – 20. 1 Set FUNCTION to TAPE•CD/ RADIO OFF. 2 Press xZ to open tape compartment and insert a recorded tape. Use TYPE I (normal) tape only. Close the compartment. With the side you want to play facing you 3 Press PLAY N. The player starts playing. GB 8
ページ9に含まれる内容の要旨
Basic Operations Use these buttons for additional operations DIRECTION Level meter h H DIR MODE VOLUME m, M xZ X m, M X xZ Note To Do this During playback, do not adjust the volume Turn VOLUME. press M, m or N on the other deck as this causes stop playback Press xZ. excessive wow and flutter. fast-forward or rewind the tape Press m or M. Tips pause playback Press X. • During operation, the level Press the button again to meter shows the frequency resume play after pause. level of the sound. play
ページ10に含まれる内容の要旨
Recording on a tape 2 31 MIC For hookup instructions, see pages 19 – 20. 1 Press xZ to open the tape compartment on deck B and insert a blank tape. Use TYPE I (normal) tape only. Close the compartment. With the side you want to record on facing you 2 Select the program source you want to record. Display To record from the CD player, set FUNCTION to CD and insert a CD (see page 4). To record from the radio, set FUNCTION to RADIO, and tune in the station you want using BAND and TUNING (see page
ページ11に含まれる内容の要旨
Basic Operations 3 Start recording. Deck B Press z on deck B (N is depressed automatically). Notes Use these buttons for additional operations • During recording, do not xZ X press M, m or PLAY on deck A as this causes excessive wow and flutter. • While recording from the built-in microphone (MIC), no sound comes from the speakers or the headphones. n • When you connect the microphone to the MIX xZ MIC jack, you cannot record from the built-in X microphone. Tips • Adjusting the volume or selecti
ページ12に含まれる内容の要旨
Dubbing 43 24 1 5 1 For hookup instructions, see pages 19 – 20. 1 Insert a recorded tape into deck A and a blank tape into deck B. Use TYPE I (normal) tape only. Close the compartment. With the side you want to record on facing you 2 Set FUNCTION to DUBBING. 3 To dub at high speed, press HIGH SPEED DUBBING to ON. To dub at normal speed, press HIGH SPEED DUBBING to OFF. GB 12
ページ13に含まれる内容の要旨
Basic Operations 4 Press X and then press PLAY on Deck A deck A. 5 Start dubbing. Deck B Press z on deck B (N is depressed automatically). Note Use these buttons for additional operations During dubbing, do not set xZ xZ FUNCTION or press HIGH SPEED DUBBING as this causes excessive wow and flutter. Tips • Adjusting the volume or selecting the audio emphasis (see page 18) will not affect the recording level. • For the best results, use the AC power as a power source. • When the tape in deck A end
ページ14に含まれる内容の要旨
The CD Player Using the display Locating a specific track You can check information about the CD using the display. You can quickly locate any track using the number buttons. You can also find a specific point in a track while playing a CD. Number DISPLAY buttons ., > Checking the total track number and playing time Press DISPLAY (DISPLAY/ENTER on the To locate Press player) in stop mode. a specific track directly the number button of Total playing the track. time a point while listening to > (f
ページ15に含まれる内容の要旨
The CD Player On the player Use PLAY MODE instead of MODE, . or Playing tracks > to select the track instead of the number button, and u instead of N. repeatedly (Repeat Play) You can play tracks repeatedly in normal, To cancel Repeat Play shuffle or program play modes (see page Press MODE until “REP” disappears from 16). the display. Tip Press and hold LOOP on the remote during play to repeat a selected part of a CD. When you release LOOP, the player returns to normal play. Number buttons MODE
ページ16に含まれる内容の要旨
On the player 1 Set FUNCTION to CD. Creating your own 2 Press PLAY MODE until “PGM” appears in the program (Program Play) display. 3 Press . or > then press DISPLAY/ ENTER for the tracks you want to program in You can arrange the playing order of up to the order you want. 20 tracks on a CD. 4 Press u. To cancel Program Play Press MODE until “PGM” disappears from the display. To check the order of tracks Number buttons before play Press DISPLAY. MODE Every time you press the button, the track num
ページ17に含まれる内容の要旨
The Tape Player The Tape Player Using as a PA system Recording through a microphone/Using as a 1 Plug the microphone into the MIX MIC jack and turn on the microphone if it has PA system a power switch. You can record sound using a microphone 2 Set FUNCTION to TV/LINE IN. (not supplied) or use the player as a public address system. 3 Sing or speak into the microphone and MIX MIC FUNCTION z adjust the volume. Notes • Acoustic feedback (howling) tend to occur when you use a microphone with echo f
ページ18に含まれる内容の要旨
The Audio Emphasis Using the PRESET MODE Set the PRESET MODE selector to the Selecting the audio sound mode you want. emphasis Use To MANUAL select the sound using the 5 (DYNAMIC SOUND SYSTEM) BAND GRAPHIC EQUALIZER. You can select the audio emphasis of the DISCO get powerful, clear sounds sound you are listening to. emphasizing low and high range audio. BALANCE 5 BAND GRAPHIC PRESET PARTY get light, bright sounds EQUALIZER MODE emphasizing high and middle range audio. LIVE get wide-ranging soun
ページ19に含まれる内容の要旨
Setting Up Setting Up Choosing the power sources You can use the AC power or batteries as a power source. 1 Speaker terminals 4 Battery compartment Right speaker AC IN Left speaker Speaker cord 2 to a wall outlet Tips 1 Hooking up the speakers • To detach the speakers, unlock speaker (see B on the diagram) and slide the speaker box all the 1 Align the grooves and slide the speaker way up and away from the player. box down until it snaps into place A. • Connect the supplied speakers to this playe
ページ20に含まれる内容の要旨
2 Connecting the AC power cord 4 Using the player on batteries Insert one end of the supplied AC Insert eight R20 (size D) batteries (not supplied) into the battery compartment. power cord to the AC IN socket located at the rear of the player, and the other To use the player on batteries, end to the wall outlet. disconnect the AC power cord from the player. Adjusting the voltage Be sure to set the VOLTAGE SELECTOR (at the rear) to your local power supply. Replacing batteries Replace the batterie
