ページ1に含まれる内容の要旨
CR-4000 SERIES
CASH DRAWER
USER’S MANUAL
Rev. : C
NOTICE
The manufacturer of the POS cash drawer makes no representation or warranties, either
expressed or implied, by or with respect to anything in this manual, and shall not be liable
for any implied warranties of fitness for a particular purpose or for any indirect, special or
consequential damages. Information in this document is subject to change without notice
and does not represent a commitment on the part o
ページ2に含まれる内容の要旨
MODEL NUMBERS Model CR400X CR410X CR421X Bill Compartment 5 Adjustable 5 Fixed 5 Fixed Plastic Metal Metal Bill clip Coin compartment 9 Fixed 9 Fixed 5 Fixed 1Underneath Cash Tray 4 Behind Cash Tray Coin Roll storage INFERFACE APPLICATION Security Model Number Interface Power / Source Code CR-4000/4100/4210 Printer drive N. A. 12/24 V Pulse / Printer CR-4001/4101/4211 Dedicated RS232 serial N. A. 12VAC / Adaptor CR-4002/4102/4212 Non-dedicated RS232 serial 0 ~ 255 CR-4003/4103/
ページ3に含まれる内容の要旨
b). For CR4001/ 4101/ 4211/ 4002/ 4102/ 4212: CCBLA-196A with one 9PM and one 9PF connector. c). For CR4003/ 4103/ 4213: CCBLA-089-1 with one 25PM and one 25PF connector. d). For CR4004/ 4104/ 4214: The serial signal cable is already built on. e). For CR4005/ 4105/ 4215/ CR4005-II/ 4105-II/ 4215-II: USB cable is already built on. 6. Power Source depend on model a). For CR-4000/ 4100/ 4210: not applicable b). For CR-4001/ 4101/ 4211/ 4002/ 4102/ 4212/ 4003/ 4103/ 4213/ 4005/ 4105/ 4215 /
ページ4に含まれる内容の要旨
3). Set S1 for security code to open cash drawer. In normal practice, the security code is suggested to be a non-displayable ASCII character. For. example, a hexadecimal number between 01 to 1F. Please refer to rear panel illustration below. CR4001/ 4101/ 4211/ 4002/ 4102/ 4212/ 4003/ 4103/ 4213 Rear panel illustration. AC 12V I/P PARALLEL O/P (DB25F) Switch is ON when pushed up SERIAL O/P (DB9M) S1 S2 8 4 1 1 SERIAL I/P (DB9F) PARALLEL I/P (DB25M) GROUND S1 Set secu
ページ5に含まれる内容の要旨
COM1 DB9 616P PHONE JACK 4PIN PHONE JACK CR4005/ 4105/ 4215/ CR4005-II/ 4105-II/ 4215-II 1). Define a drawer number for the cash drawer so that this cash drawer is going to respond accordingly in USB communication. Follow the table below for SWITCH SETTING to adjust the switch S1 according to this drawer number if it is not 7. Please note that within each system there should never be any 2 USB interface cash drawers carrying the same drawer number. O 4 3 2 1 N
ページ6に含まれる内容の要旨
UPOS driver application (Applied for all Posiflex cash drawer) Please first find in Posiflex Product Information CDROM or download from Posiflex web sites for UPOS driver setup. In this application CR4XX3 and CR4XX4 respond to openDrawer command only; CR4XX0, CR4XX1 and CR4XX2 are compliant to UPOS version 1.4; CR4XX5 are compliant to UPOS version 1.7 and CR4XX5-II are compliant to UPOS version 1.8. FUNCTIONAL TEST CR4000 / 4100 / 4210 1. Follow the printer’s manual of the printer the
ページ7に含まれる内容の要旨
2. Start up the test program and click “STATUS” button. The drawer status of Open/Close or Not present will be displayed under each drawer number as “O”, “C” or “N” 3. Use a key to turn the lock to standby position (the one marked with sign at middle), click the check only the box (es) under the drawer number(s) for the drawer(s) to be tested then click the “KICK” button. 4. The cash drawer will then open and the Open/Close/Not present status of the tested drawer number will be renew
ページ8に含まれる内容の要旨
Security Code CR-4002/ 4102/ 4212/ 4003/ 4103/ 4213 1-255; factory preset value = 7 CR-4005/ 4105/ 4215/ 4005-II/ 4105-II/ 4215-II USB PID Drawer Open Sense CR-4000/ 4100/ 4210 Drawer open sense circuit shorts when open CR-4001/ 4101/ 4211/ 4002/ 4102/ 4212 Pin 9 shorts to pin 5 when drawer open CR-4005/4105/4215/4005-II/4105-II/4215-II Through USB driver KEYLOCK OPERATION Physically lock the drawer. Open the drawer by the key. Automatically open the drawer by POS printer or P
