ページ1に含まれる内容の要旨
PORTABLE THREADING
MACHINE
41876
ASSEMBLY & OPERATING INSTRUCTIONS
Due to continuing improvements, actual product may differ slightly from the product described herein.
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http://www.harborfreight.com
TO PREVENT SERIOUS INJURY,
READ AND UNDERSTAND ALL WARNINGS
AND INSTRUCTIONS BEFORE USE.
© ®
Copyright 1999 by Harbor Freight Tools . All rights reserved. No portion of this manual or any
artwork contained herein may be reproduced
ページ2に含まれる内容の要旨
THANK YOU for choosing a HARBOR FREIGHT TOOLS product. For future reference, please complete the owner’s record below: Model____________ Serial No._____________ Purchase Date_______________ SAVE THE RECEIPT, WARRANTY AND THESE INSTRUCTIONS. It is important that you read the entire manual to become familiar with the unit BEFORE you begin assembly. Technical Specifications Electrical Requirements: 110V, 12 Amp, 60 Hz Die Sizes: 1/2", 3/4", 1", 1-1/4" Plug, Cord and Switch: UL Listed Overall Dime
ページ3に含まれる内容の要旨
Work Area TO AVOID RISK OF PERSONAL INJURY, EQUIPMENT DAMAGE, FIRE AND SHOCK, MAKE SURE YOUR WORK AREA IS: Free of damp, wet or rainy conditions. Free of flammable gasses or liquids. Free of children (never let them handle tools or machinery). Well-lit. Clean and uncluttered. Well-ventilated. Before Operating Before operating your Portable Threading Machine check for damaged parts. DO NOT exceed the maximum capacity of the tool. Never force the tool or attachment to do the work of a larger indus
ページ4に含まれる内容の要旨
Grounding/Voltage Warning Common household current is 110-120 volts. As long as the outlet used with the tool is rated from 110-120V there will be no complications using it with household receptacles. Plug the tool into a 110-120v properly grounded outlet protected by a 15-amp, dual element time delay or circuit breaker. NEVER try to plug a 110-120V tool into a 220-240V circuit or serious complications and possible injury to the operator may occur. The plugs have different shapes to prevent t
ページ5に含まれる内容の要旨
Preparation for Pipe Threading Your Portable Threading Machine comes fully assembled but will require insertion of the Die prior to operation. It is important that your read the entire manual to become familiar with the unit BEFORE you use it. Be sure that you have all parts described in the Parts List. To help you with assembly, please refer to the assembly diagram on page 7 and the parts list on page 6. Step 1) Determine the size of the pipe to be threaded. Step 2) Select the appropriate die
ページ6に含まれる内容の要旨
Maintenance Step 1) Clean the Portable Threading machine after each use. Clean dies after each use. Check for broken teeth or pipe material between teeth. Motor Brushes Step 1) Using a small standard screwdriver, remove the Brush Cap. When you remove the Brush Cap, the Brush may spring out. Do not lose the Brush. If the brush does not spring out, gently remove it using the tip of your screwdriver. Step 2) Examine the Brush surface. If the Brush is worn more than 1/4" replace the brush. Th
ページ7に含まれる内容の要旨
Assembly Diagram Wiring Diagram SKU 41876 For technical questions, please call 1-800-444-3353. Page 7
