ページ1に含まれる内容の要旨
I-See S 150
L C D M o n i t o r
Cod. A05-15AM-C01
User Manual
Manuale d’uso
Manuel d’utilisation
A05-15AM-C01_MX02
ページ2に含まれる内容の要旨
A05-15AM-C01_MX02
ページ3に含まれる内容の要旨
Important Safety instructions .........................................................................................6 1 Introduction ............................................................................................................7 1.1 General information .......................................................................................7 2 Installation..............................................................................................................8 2.1 Intr
ページ4に含まれる内容の要旨
3.1 Introduction..................................................................................................34 3.2 Opérations ...................................................................................................35 3.3 Modes supportés .........................................................................................38 3.4 Plug & Play ..................................................................................................39 3.5 Consommations.............
ページ5に含まれる内容の要旨
A05-15AM-C01_MX02 5 / 45_1
ページ6に含まれる内容の要旨
Important Safety instructions 1. Read these instructions carefully 2. Save this manual for later use 3. Unplug the monitor from the power source when you clean the monitor. Don’t use liquid cleaners or aerosol cleaners. Use a cloth to clean it. If it doesn’t do, please use LCD screen cleaners 4. Don’t use attachment not recommended as they may cause hazards. 5. Please grasp the plug to unplug the connector from the wall outlet. Do not pull the power cord to unplug it. 6. Don’t place
ページ7に含まれる内容の要旨
1 Introduction 1.1 General information This monitor is a high-performance intelligent multi-scanning color monitor adopting 15”active matrix TFT LCD display that uses amorphous silicon TFT as a switching devices. with very low radiation, anti-glary surface treatment and occupying small place , It is very suitable for home and office applications. 1.1.1 Features • Max.resolution: 1024×768 @75Hz • Viewing angle: H: -75º/+75º, V: -70º/+70º • Active area: 304.128 x 228.096(mm²) • Pi
ページ8に含まれる内容の要旨
2 Installation Please consider the following advice before you install your monitor. 2.1 Introduction 2.1.1 Position Place your monitor to the place where there’s less light reflects . Generally, it has a suitable angle with the window. 2.1.2 Height The peak of the monitor should be a little lower than your eyes when you sit down. 2.1.3 Inclination You will feel comfortable with the sloping screen. 2.1.4 Install the monitor
ページ9に含まれる内容の要旨
d. power on Turn on both of the monitor and computer. After the monitor is power on, the LED lights up green, If the LED become red and flashing, please check the video signal cable fig.2 connection If LED is off, please press power on switch . 2.1.4.1 Self test pattern ATLANTIS LAND If there is no horizontal or vertical sync. signals, your monitor will display as fig.2 to indicate no sign
ページ10に含まれる内容の要旨
2.2.3 OSD control keys 2.2.3.1 Autokey This key is used to ATLANTIS LAND complete auto adjusting function. 2.2.3.2 +/- key These two keys will complete the left (decrease) or right (increase) adjustment and choose the menu function. The contrast and the brightness can be set by +/- key directly. 2.2.3.3 Enter key Confirmation key, to display the OSD menu and complete the confirmation function 2.2.4 OSD menu The function li
ページ11に含まれる内容の要旨
2.2.5 Function table 2.2.6 Special functions 2.2.6.1 Auto Adjustment( ) When you choose this function, the monitor will enter into automatical adjustment mode. will display on the screen. After a few seconds, the monitor will be in the best visual display mode. 2.2.6.2 Color selection ( ): When the function is selected , the monitor will enter into the sub-menu, there are five functions that can be selected: • 9300°K • 7800°K • 6500°K • USER • W-B A05-1
ページ12に含まれる内容の要旨
SELECTED USER You will enter into the user mode and you can adjust the R/G/B percentage to obtain your satisfactory color SELECTED W-B It will enter into the auto color balance mode, and the monitor will automatically adjust the white-black color benchmark to obtain optimal color balance. R, G, B ADJUSTMENT When in “User’s mode”, the monitor will automatically enter into R/G/B adjustment mode, push the ENTER key ,the relative options will flash, then adjust it by pressing “+/-“
ページ13に含まれる内容の要旨
Recommend mode: 1024×768@75Hz Pixel clock NO. Mode Resolution Vertical Freq (Hz) Horizontal Freq. (KHz) (MHz) 1 VGA 60 31.469 25.175 640×480 2 720×480 70 31.468 28.322 3 SVGA 60.3 37.879 40 800×600 4 60 48.363 65 XGA 1024×768 5 60 56.476 75 6 70 60.023 78.75 2.4 Plug & Play This monitor meets the standards of VESA DDC. When using video graphic with VESA DDC1/2B, it will auto-scan video frequency, output power, function and other parameters to windows. It will go to p
ページ14に含まれる内容の要旨
2.7 Specification Monitor type TFT LCD Surface treatment Anti-glary Active area 304.128(H) x 228.096(V) (mm²) Viewing angle: H -75º/+75º V -70º/+70º 2 Max. Brightness 250cd/m Max. contrast ratio 350:1 Response time 10/15ms Max resolution 1024×768@75Hz Input resistance 75±3 Ω H-frequency 30KHz ÷ 60KHz V-frequency 55Hz ÷ 75Hz Power supply for Adapter 100V/240VAC 60Hz/50Hz 1.5A Power supply for monitor 12VDC 3.3A Power consumption <30W Input c
ページ15に含まれる内容の要旨
2.8 Simple troubleshooting Symptom Solution Check if the power cord, the monitor, and the power 1. No picture & no LED plug are well connected light Check if the monitor is off. Check if the PC video card and signal cable are well 2. No picture & LED connected and check if signal cable well connected red flashing with monitor. 3. Picture blur or too Push the “AUTO” key to make the monitor adjust big or too small automatically. Push the “AUTO” key to adjust the brightness and t
ページ16に含まれる内容の要旨
3 Substitution Terms for Lcd Monitor with warranty This document indicates terms within Atlantis Land S.p.A. will substitute its Lcd monitors which might have defective pixels. For every kind of damages different from ones indicated in those pages, warranty conditions are written in the document “Atlantis Land Warranty – On Site”. Here following you will have: A brief introduction to the TFT panels built technology; ISO 13406-2 indicated defective limits; Atlantis Land S.p.A. s
ページ17に含まれる内容の要旨
Table 1 Panel Inches Resolution Pixel Number 15” 1027 x 768 786,432 17” 1280 x 1024 1,310,720 19” 1600 x 1200 1,920,000 This Norm identifies five different kind of damage (Table 2). For every one of them it indicates the maximum acceptable defectiveness, divided in quality class. It is indicated in: number of damages for every million of pixels (Table 3). Table 2 TYPE 1 Full Pixel continuously turned on (white point) TYPE 2 Full Pixel continuously turned off (black point) TY
ページ18に含まれる内容の要旨
Istruzioni preliminari 1. Leggere attentamente queste istruzioni 2. Conservare il manuale per consultazioni successive 3. Scollegare l’alimentazione quando si pulisce il monitor. Non usare liquidi o aerosol. Usare uno straccio di stoffa, oppure un prodotto apposito per la pulizia degli LCD. 4. Non utilizzare cavi di collegamento appropriati, potrebbero essere pericolosi. 5. Utilizzare la spina per staccare il cavo dalla presa, non tirare direttamente il cavo. 6. Non calpestare il ca
ページ19に含まれる内容の要旨
1 Introduzioni 1.1 Informazioni generali Questo monitor è un monitor ad alte prestazioni, con funzioni di multi-frequenza, dotato di una matrice attiva TFT LCD di 17”, che utilizza la tecnologia TFT. Emette bassissime radiazioni, il display è trattato con superficie antiriflesso e occupa uno spazio molto limitato. È ideale sia per la casa che per l’ufficio. 1.1.1 Prestazioni • Risoluzione massima: 1024×768 @75Hz • Angolo di visuale: H: -75°/+75°; V: -70°/+70° 2 • Area attiva: 304.
ページ20に含まれる内容の要旨
2 Installazione 2.1 Introduzione Fare attenzione alle indicazioni riportate per l’installazione 2.1.1.1 Posizione Porre il monitor in un’area dove ci sia meno luce riflessa, non in prossimità di finestre. 2.1.1.2 Altezza La parte superiore del monitor dovrebbe essere leggermente più bassa dei vs. occhi, quando siete seduti. 2.1.1.3 Inclinazione Questa può consentire un uso più confortevole. 2.1.1.4 Installazione del monitor Assicurarsi che il computer ed il monitor siano
