ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
D1374201_User_Manual_T550_T770_MXP_CCM Trademarks and Copyright All rights reserved. This document contains information that is proprietary to TANDBERG. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form, or by any means, electronically, mechanically, by photocopying, or otherwise, without the prior written permission of TANDBERG. Nationally and internationally recognized trademarks and trade names are the property of their respec
ページ3に含まれる内容の要旨
User Manual Environmental Issues Thank you for buying a product, which contributes to a reduction in pollution, and thereby helps save the environment. Our products reduce the need for travel and transport and thereby reduce pollution. Our products have either none or few consumable parts (chemicals, toner, gas, paper). Our products are low energy consuming products. Battery handling Batteries for the Remote Control are Long Life and Alkaline batteries saving the environment;
ページ4に含まれる内容の要旨
D1374201_User_Manual_T550_T770_MXP_CCM Operator Safety Summary For your protection, please read these safety instructions completely before operating the equipment and keep this manual for future reference. The information in this summary is intended for operators. Carefully observe all warnings, precautions and instructions both on the apparatus and in the operating instructions. Equipment Markings The lightning flash symbol within an equilateral triangle is intended to aler
ページ5に含まれる内容の要旨
User Manual ISDN cables - CAUTION - To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord. Servicing - Do not attempt to service the apparatus yourself as opening or removing covers may expose you to dangerous voltages or other hazards, and will void the warranty. Refer all servicing to qualified service personnel. Damaged Equipment - Unplug the apparatus from the outlet and refer servicing to qualified personnel under the following conditions:
ページ6に含まれる内容の要旨
D1374201_User_Manual_T550_T770_MXP_CCM Table of Contents 1 Introduction............................................................................................................................... 1 1.1 At a Glance ............................................................................................................................ 2 1.2 Settings Menu Structure ........................................................................................................ 4 2 Installation .
ページ7に含まれる内容の要旨
User Manual 4.5 Presentation......................................................................................................................... 63 4.6 Lines..................................................................................................................................... 64 5 Peripheral Equipment............................................................................................................. 65 6 Appendices..................................................
ページ8に含まれる内容の要旨
ページ9に含まれる内容の要旨
1 Introduction This User Manual is provided to help you make the best use of your TANDBERG unit. The TANDBERG 550/770 MXP for Cisco CallManager offers superior audio and video quality in a fully-featured unit. Main features Delivers the ultimate visual communication experience, with video quality developed by TANDBERG for business video applications. Full range of Cisco IP telephony functions, including Directory and Call Control, as supported by the Cisco Call Manager.
ページ10に含まれる内容の要旨
ページ11に含まれる内容の要旨
Introduction Microphone The high quality table microphone is designed to use on a table during a videoconference. The ideal location for the microphone is on a flat surface at least 2m (6.5 ft) from the front of the system. The microphone should always be placed pointing away from the system with the cable towards the system. The system will automatically equalize sound levels. Loud and soft voices are picked up and transmitted to the far end at approximately the same level. 3
ページ12に含まれる内容の要旨
ページ13に含まれる内容の要旨
2 Installation Precautions Never install telephone wiring during a lightning storm. Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations. Never touch uninstalled telephone wires or terminals unless the telephone line has been disconnected at the network interface. Use caution when installing or modifying telephone lines. Avoid using a telephone (other than a cordless type) during an electrical storm. There may b
ページ14に含まれる内容の要旨
D1374201_User_Manual_T550_T770_MXP_CCM 2.1 Unpacking and Mounting Unpacking The TANDBERG 550/770 MXP for Cisco CallManager consists of the following items: Videoconferencing system Table microphone Remote control Batteries User manual on CD Cables Power supply Mounting Place the system centrally, on top of the monitor, close to the front and ensure it is stable. 6
ページ15に含まれる内容の要旨
Installation 2.2 Connecting Cables 1. Microphone Cable Connect the microphone to the microphone cable. Connect the microphone cable to microphone input 1 on the system. 2. Monitor Cable(s) Scart (Europe): Connect the Scart adapter to one of the Scart connectors on your monitor. Scart (Europe) & RCA/S-Video (US): Audio: The cable with one RCA connector on one side and two RCA connectors on the other side: Connect the two RCA connectors to your monitor (or S
ページ16に含まれる内容の要旨
ページ17に含まれる内容の要旨
Installation Note! Make sure you insert the card in the right direction (with the product logo pointing upwards). Push the card into the slot until the Eject button pops up. See chapter 4.2.2 Wireless LAN Settings for configuration. 9
ページ18に含まれる内容の要旨
D1374201_User_Manual_T550_T770_MXP_CCM 2.3 Monitor Configuration Power on Power on the monitor and use the monitor remote control to select the Audio/Video input used (refer to your monitor manual). If you are using S-video from the system, remember to select S- Video input to avoid a black and white picture. Select Audio/Video input on monitor Selection of Audio/Video input used is generally performed by pressing the 0/AV button on the TV remote control several times. Please
ページ19に含まれる内容の要旨
3 General Use Wake up the system When the system is not in use, it is in standby mode and the screen is black. Wake up the system by picking up the remote control. An incoming call or pressing any key on the remote control will also wake up the system. If the system does not respond Make sure that the system is switched on by using the On/Off switch located at the rear of the system. 11
ページ20に含まれる内容の要旨
D1374201_User_Manual_T550_T770_MXP_CCM 3.1 The Welcome Menu When the system is switched on, you will see the welcome screen. The welcome screen presents the Main menu and displays your Main Camera image in the background (Main Camera is system default). The following menu will appear when not in a call. Press OK or Cancel(X) to activate or hide the welcome menu. This screen provides you with the telephone number(s) assigned to your unit. 12
