ページ1に含まれる内容の要旨
User's Manual
MODEL NO.:PLDVCR600
PLDVCR500
view
◆ In the initial settings, exclusive channel for DVD/Video is set to CH 3.
Set the TV channel to CH3 before using it.
◆ Region code of DVD/Video player for home is 1 or ALL.
In inserting a disc with other region code, it does not operate.
Please only use a disc with region code 1 or ALL.
is a 'Prohibition' mark. If this mark is displayed in operating the product,
◆
please wait for a while, then use it. If 'Prohibition' mark continues to
ページ2に含まれる内容の要旨
Important Safeguards The lightning flash with arrowhead symbol, within an equilateral triangle, CAUTION is intended to alert the user to the presence of uninsulated RISK OF ELECTRIC SHOCK dangerous voltage within the product s enclosure that may be of DO NOT OPEN sufficient magnitude to constitute a risk of electric shock. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER- The exclamation point within an equilateral SERVICEABLE PARTS INSIDE. REFER SERVICI
ページ3に含まれる内容の要旨
This set has been designed and manufactured to assure personal safety. Improper use can result in electric shock or fire hazard. The safeguards incorporated in this unit will protect you if you observe the following procedures for installation, use and servicing. This unit is fully transistorized and does not contain any parts that can be repaired by the user. 1 READ INSTRUCTIONS All the safety and operating instructions should be read before the unit is operated. 2 RETAIN INSTRUCTIONS The
ページ4に含まれる内容の要旨
12 POWER-CORD PROTECTION Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the unit. Note to CATV system installer This reminder is provided to call the CATV system installer s attention to Section 820-40 of the NEC which provides guidelines for proper grounding and, in particular, specif
ページ5に含まれる内容の要旨
22 DAMAGE REQUIRING SERVICE Unplug this unit from the wall outlet and refer servicing to qualified service personnel under the following conditions. A. When the power-supply cord or plug is damaged. B. If liquid has been spilled, or objects have fallen into the unit. C. If the unit has been exposed to rain or water. D. If the unit does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating
ページ6に含まれる内容の要旨
Read Carefully before Using Cautions in use of DVD-Video player are described below. Please read carefully before using a DVD-Video player. Installation place and handling - When you place this player near other devices, they may affect poorly together. - When you place DVD-Video player and TV in the upper and lower sides, it may cause flickering of pictures or failure (tape is not ejected). - When you place this player near strong magnetic materials, it may affect image or voice poorly or
ページ7に含まれる内容の要旨
Tape and Disc Handling - Do not use any tape and disc below. Damage of video head or cut/coiling of tape may cause failure. Tape with mold Tape or disc stained with juice or attachments Tape having breakage connection Disassembled tape Disc with severe scratch Moisture condensation may occur in tape. Moisture condensation damages the tape. Please use the tape after the moisture condensation is disappeared. - After use, store tape vertically in a case to prevent lo
ページ8に含まれる内容の要旨
Contents Important Safeguards 1 Other's Operation 29 Read Carefully before Using 5 Using a zoom function 29 Advantages of This Product Are.... 8 Anglr 29 Idenificatuion of Controls 9 To skip chapter in a DVD 30 front palel 9 To Play It Fast 30 rear panel 11 To Play It Slow 30 remote Controller 12 Repeating a Defined Period 31 instructions in using remote 13 Confirming The Current Disc Mode 31 Connecting with TV 14 To Display Menus In a Disc 32 Connecting with Cab
ページ9に含まれる内容の要旨
Advantages of This Product Are ..... BUILT-IN TV TUNER (TV/CATV) Hi-Fi stereo system [VCR] Digital Auto Tracking [VCR] BACK LIGHTING OF FUNCTION BUTTONS EXTERNAL IR REMOTE CONTROLLER WITH RECEIVER DEW & HEAT SENSORS FOR TAPE PROTECTION AUTO START FUNCTION DC power Supply (2 kind of DC 12v inputs) DVD, VCD, CD, CD-R(MP3), CD-RW, VHS playback function Watching DVD for recording broadcast Integrated REMOTE (VCR, DVD) MP3 file playback function (CD-R disc having records of MP3 files)
ページ10に含まれる内容の要旨
Identification of Controls Front Panel OPEN/CLOSE Open/Close button Audio/Video in jack Connect these jack to the audio/video out jacks If this key is pressed while power is supplying . terminal of your game machine or camcorder using disc tray will open,the open/close button lamp will the RCA cord provided. light up in red then insert the disc and the disc will be played automatically Remote control receiver. Playback/Pause button(DVD) Autorepeat lamp Playback d
ページ11に含まれる内容の要旨
Play key. Cassette-In Lamp. Press this key to playback a recorded tape, When the cassette is inserted, or to release special operation such as the search mode. the CST-IN lamp will light up in green. In the playback mode the playback indicator lamp will be light in red, and Auto Tracking mode, Power Key this indicator lamp will blink. When power is supplied to the set, the power indicator lamp will always light up in red. Rewind / Review key. The Power ON and Power OFF mode will be toggled
ページ12に含まれる内容の要旨
Rear Panel ANT IN Connector. DC JACK IN (DC 12V) Connect the TV antenna For car using, we recommend to use this connector (or cable if available- home use) to this with 3-wire system. connector. * Connector description for 4 RF OUT Connector. ACC 12V This connectors provides an interface to the antenna input connectors terminal of your VEHICLE BATTERY 12V GND television using a coaxial cable. IR INPUT Tuner the television to channel 3 or 4 Connect this terminal to re
ページ13に含まれる内容の要旨
REMOTE CONTROLLER 1 DVD & VCR Power On/Off 46 45 2 REPEAT Playback button [DVD] 3 MENU button 4 TITLE MENU button 5 MOVE in OSD button POWER OPEN/CLOSE 6 A/V SEL button 44 ANGLE SUBTITLE AUDIO REPEAT 7 OSD DISPLAY button 43 2 8 RETURN button REPEAT A-B ZOOM TOP MENU MENU 3 42 9 CLEAR button 41 10 PROGRAM button 11 MUTE button 40 ENTER 12 GOTO button 13 PBC button A/V SEL. SETUP 39 6 14 FF button DISPLAY 7 15 F.SKIP button RETURN 2 1 3 8 16 CH3/CH4 button [VCR] CLEAR 5 4 6 17 9 EJECT button [V
ページ14に含まれる内容の要旨
Instructions in Using REMOTE Operate REMOTE within 7m from the unit. Do not keep in the place with Do not light up sending part of Do not press 2(two) buttons at much dust and humidity REMOTE the same time. 13
ページ15に含まれる内容の要旨
Connecting with TV ■ In the initial SET, exclusive channel for video is set to CH 3. To change this setting, set again in CHANNEL SET screen in VCR operation. In connecting RF cable to TV, set TV channel to CH3. ■ How to Connect with RF cable REAR PANEL OF DVD-VIDEO REAR PANEL OF TV INPUT 1 INPUT 2 OUTSIDE ANTENNA OR WALL ANTENNA OUTLET ANT IN RF CABLE 1. Remove circular cable (RF cable) (surplus cable) plugged in ANT.IN Jack in rear panel of TV. Connect the cable to ANT.IN jack in
ページ16に含まれる内容の要旨
Connecting with Cable Box If your cable system only requires you to use a converter box for some channels (i.e., pay-TV channels), follow these steps: Find the primary incoming RF cable. Plug this cable into a splitter (available at your local electronics store.) Connect one RF cable between one OUT terminal on the splitter and the IN terminal on the converter box. Connect another RF cable between the other OUT terminal on the splitter and the A-IN terminal on an A/B switch available at your
ページ17に含まれる内容の要旨
Connecting with Other VCR or Camcorder 1. Connect AUDIO/VIDEO OUT jack in Camcorder(or playback video) to AUDIO/VIDEO IN jack in rear panel (or front panel) of DVD-Video with connecting cable. 2. Connect ANT. IN jack in TV to RF.OUT jack in DVD-Video with RF cable. 3. To record contents of camcorder or playback video with DVD-Video, insert recording tape attached recording tab in DVD-Video. 16
ページ18に含まれる内容の要旨
How to Copy(Edit) Tape with Other VCR or Camcorder 1. Turn on DVD-Video. 2. Press [OUTPUT] button of remote control and adjust DVD-Video to display "External Input 1" or "External Input 2" in TV screen. 3. Press [PLAY] button in Camcorder or playback video. 4. Press [REC] button in DVD-Video if you want to record contents of camcorder or playback video. 5. Press [Pause] button in DVD-Video when unnecessary or undesired scene is displayed in recording. (Caution) Recording is released automat
ページ19に含まれる内容の要旨
LANGUAGE SETUP MENU Select DISC Menu Language Select AUDIO Language 1. Press the "SETUP" button on the remote control. 1. Press the "SETUP" button on the remote control. The initial MENU is displayd. The initial MENU is displayd. SETUPM MENU SETUPM MENU T T LANGUAGE SETUP T T LANGUAGE SETUP DISPLAY SETUP DISPLAY SETUP AUDIO SETUP AUDIO SETUP ? PARENTAL SETUP ? PARENTAL SETUP OTHERS SETUP OTHERS SETUP VCR SETUP VCR SETUP EXIT SETUP EXIT SETUP LANGUAGE SETUP LANGUAGE SETUP 2. Press the sel
ページ20に含まれる内容の要旨
Select SUBTITLE Language 1. Press the "SETUP" button on the remote control. The initial MENU is displayd. SETUPM MENU T T LANGUAGE SETUP DISPLAY SETUP AUDIO SETUP ? PARENTAL SETUP OTHERS SETUP VCR SETUP EXIT SETUP LANGUAGE SETUP 2. Press the select(ENTER) button then the "LANGUAGE SETUP" is displayed. LANGUAGE SETUP MENU DISC MENU ENGLISH AUDIO FRANCAIS T SUBTITLE DEUTSCH ESPANOL ITALIANO MAIN MENU LANGUAGE SETUP 3. Press the SHIFT button to select (ENTER) the "SUBTITLE". Then t
