ページ1に含まれる内容の要旨
VRX6671z
Owner’s manual & Installation manual
Mode d’emploi et manuel d’installation
Manual de instrucciones y de instalación
VRX6671z
6.5” MONITOR & FM/AM RADIO WITH
CD/MD CHANGER CONTROL
•
MONITEUR DE 6,5 POUCES ET RADIO FM/AM
AVEC COMMANDE DE CHANGEUR
DE CD/MD
•
MONITOR DE 6,5-PULGADAS Y RADIO FM/AM
CON MANDO PARA EL CAMBIADOR DE
CD/MD
Clarion Co., Ltd.
All Rights Reserved. Copyright © 2000: Clarion Co., Ltd.
QC-6700B
Printed in China / Imprimé en Chine / Impreso en Chine /
2000/2 (IT·K) 28
ページ2に含まれる内容の要旨
Thank you for purchasing the Clarion VRX6671z. ∗ This owner’s manual is for the VRX6671z. ∗ Please read this owner’s manual in its entirety before operating this equipment. ∗ After reading this manual, be sure to keep it in a handy place (e.g., glove compartment). ∗ Check the contents of the enclosed warranty card and keep it carefully with this manual. ∗ This manual includes the operating procedures of the CD changer, MD changer, TV tuner and digital sound processor (DSP) connected via the CeNE
ページ3に含まれる内容の要旨
4. MODE DISPLAY 1. PRECAUTIONS The Color LCD Display and the Information Panel on the main unit show the following displays, provid- !!! !! WARNING ing information about the mode and functions operated. For your safety, the driver should not watch the TV or operate the controls while driving. Please note that watching and operating the TV while driving are prohibited by law in some Display common to each mode countries. Also, while driving, keep the volume to a level at which external sounds c
ページ4に含まれる内容の要旨
CONTROLS / COMMANDES / CONTROLES 2. CONTROLS / COMMANDES / CONTROLES 3. NOMENCLATURE JOYSTICK Operation Note: • Many settings/procedures have to be performed by using the JOYSTICK ¡. Be sure to read this chapter Main unit / Unité principale / Unidad principal Names of Buttons in order to operate it properly. With the Display closed / Avec l`afficheur fermé / Con el visualisador cerrado Note: Selecting an item in the menu • Be sure to read this chapter referring to the front diagrams of chapter
ページ5に含まれる内容の要旨
RADIO mode display COLOR LCD DISPLAY INFORMATION PANEL MAIN SUB VRX6671z 9
ページ6に含まれる内容の要旨
CD/MD Changer mode display COLOR LCD DISPLAY INFORMATION PANEL MAIN SUB 10 VRX6671z
ページ7に含まれる内容の要旨
TV mode display COLOR LCD DISPLAY INFORMATION PANEL MAIN SUB VRX6671z 11
ページ8に含まれる内容の要旨
5. REMOTE CONTROL When the panel is open Remote control unit WIDE 1 Inserting the Batteries 1. Turn the remote control unit over, then slide the rear cover in the direction of the arrow. 2. Insert the AA (SUM-3, IECR-6/1.5V) batter- ies that came with the remote control unit facing in the directions shown in the figure, then close the rear cover. Notes: Using batteries improperly can cause them to explode. Take note of the following points: • When replacing batteries, replace both batteries w
ページ9に含まれる内容の要旨
Functions of Remote Control Unit Buttons Mode CD changer Radio TV Button MD changer £ FUNC Switches among Radio, CD changer, MD changer and TV. ¢ BAND Switches reception band. Moves to the next disc in Switches reception band. DISC UP increasing order. TOP VOLUME 25 Increases and decreases volume (in all modes). § SEARCH Moves preset channels Moves tracks up and Moves preset channels up and down. down. up and down. When pressed and held for 1 second: Fast-forward/ Fast-backward. ¶ PLAY/PAUSE No
ページ10に含まれる内容の要旨
6. DCP The control panel can be detached to prevent 2. Lock the DCP/Operation Panel at the upper theft. When detaching the control panel, store it center until a click is heard. in the DCP (DETACHABLE CONTROL PANEL) POWER button case to prevent scratches. We recommend taking the DCP with you when leaving the car. Removing the DCP 1. Turn the power off. 2. Deeply push in the DCP RELEASE lever 6 to release the DCP/Operation Panel. 3. Press the power button 1 to turn on the DCP/RALEASE lever power
ページ11に含まれる内容の要旨
7. CAUTIONS ON HANDLING LCD panel/Generalities For a longer service life, be sure to read the following cautions. • Be sure to store the LCD panel inside the • Do not insert objects or poke in the space be- main unit when parking the car outdoors for tween the LCD panel and the main unit when long period of time. The LCD panel will oper- the panel is tilted. ate properly in a temperature range of 0 to • Do not place anything on the display when 60°C. the panel is tilted. • Don’t allow any liquid
ページ12に含まれる内容の要旨
8. OPERATIONS Note: Be sure to read this chapter referring to the front diagrams of Basic Operations chapter “2. CONTROLS” on page 5 (unfold). Adjusting the volume CAUTION Operate the VOLUME button 2 in the direction When the unit is turned on, starting and stop- of the arrows w w w w w (up) or z z z z z (down) to adjust the ping the engine with its volume raised to the volume; maximum level may harm your hearings. Be w w w: Increases the volume. w w careful about adjusting the volume. z z z z
ページ13に含まれる内容の要旨
Basic Operations • If a title has been input, it is shown in the SUB dis- 3. To store the Color LCD display ¥ in the source play. If no title has been input, “---------” appears in unit, turn it to the horizontal position until a the display. To input a title, refer to the subsection click is heard. “Entering titles” in “Other Functions” section. • Some special characters of the title, will not be displayed on the Information Panel of the DCP. In this case, those characters will only be left bla
ページ14に含まれる内容の要旨
Basic Operations When the panel is closed: Adjusting the bass and treble Each time you press the Z-EHCR button 9, the Notes: tone effect changes in the following order: • This function is enabled only when the panel is open. “Z-EHCR 1” ➜ “Z-EHCR 2” ➜ “Z-EHCR 3” ➜ • This function can be adjusted only when the Z- “Z-EHCR OFF” ➜ “Z-EHCR 1”... enhancer is OFF. 1. Press the A-M button & to change into the When the panel is open: AUDIO-MODE display. 1. Press the A-M button & to change into the 2. Oper
ページ15に含まれる内容の要旨
Basic Operations Turning on/off the loudness The loudness effect emphasizes the bass and treble to create a natural sound tone. When you are listening to music at a low volume, it is rec- ommended to use the loudness effect. ∗ This function is enabled only when the panel is open. 1. Press the A-M button & for 1 second or longer to select Loudness ON. The “LD” indicator lights in the display. 2. Press the A-M button & for 1 second or longer to select Loudness OFF. The “LD” indicator goes off. Not
ページ16に含まれる内容の要旨
Radio Operations 2. Press the right or left side of SEARCH button FM reception ® 2 to automatically seek a station. For enhanced FM performance the When the right side of SEARCH button 2 is tuner includes signal actuated stereo control, En- pressed, the station is sought in the direction hanced Multi AGC, Impulse noise reduction curcuits of higher frequencies; if the left side of and Multipath noise reduction circuits. SEARCH button 2 is pressed, the station is sought in the direction of lower
ページ17に含まれる内容の要旨
Radio Operations Manual memory Instant station recall (ISR) 1. Press the BAND button % and select the de- Instant station recall is a special radio preset that sired band. (FM or AM) instantly accesses a favorite radio station at a touch of a button. The ISR function even oper- 2. Select the desired station with seek tuning, ates with the unit in other modes. manual tuning, or preset tuning. ISR memory 3. Press and hold one of the PRESET buttons # for 2 seconds or longer to store the cur- 1. S
ページ18に含まれる内容の要旨
CD Changer Operations CD changer functions When the panel is closed: 1. Display the CD-text title (disc or track). When an optional CD changer is connected through the CeNET cable, this unit controls all 2. Press and hold the BAND button % for 1 sec- CD changer functions. This unit can control a total ond or longer. The titles scroll. of 2 changers (MD and/or CD). When the panel is open: Press the FUNC button 1 and select the CD 1. Display the CD-text title (disc & track). changer mode to start
ページ19に含まれる内容の要旨
CD Changer Operations Repeat play Fast-forward/Fast-backward The repeat play continuously plays the current Fast-forward track. This function continues automatically until Press and hold the right side of the SEARCH it is cancelled or the mode is changed. button 2 for 1 second or longer. 1. Press the RPT button 7, to make repeat play Fast-backward starts. “RPT” lights in the display. Press and hold the left side of the SEARCH but- 2. To cancel repeat play, press the RPT button ton 2 for 1 se
ページ20に含まれる内容の要旨
MD Changer Operations Notes: MD changer functions • When the disc title is within 16 characters, the title When an optional MD changer is connected is scrolled immediately. through the CeNET cable, this unit controls all • If the track title is shorter than 16 characters, the MD changer functions. This unit can control a track titles does not scroll. total of 2 changers (MD and/or CD). Press the FUNC button 1 and select the MD Selecting an MD changer mode to start play. If 2 MD changers Each of
