ページ1に含まれる内容の要旨
TC9217MM-W, TC9220MM-W, TC9227MM-W
Instruction Manual
EN Monitor Mounts
1 of 11 ISSUED: 06-25-99 SHEET #: 039-9003-8 02-08-05
ページ2に含まれる内容の要旨
| TC9217MM-W, TC9220MM-W, TC9227MM-W | Instruction Manual | EN 2 MONITOR MOUNT COMPATIBILITY CHART For Bosch LTC Series Monitors Bosch Monitor Ceiling Wall Model No. Mount Mount Monochrome LTC 2009/51, /61 MM3000 TC9209MM-W LTC 2012/51, /61 MM3000 TC9209MM-W LTC 2017/50, /60 TC9217MM-C TC9217MM-W LTC 2020/90 TC9220MM-C TC9220MM-W Color LTC 2810/90, /91 TC9217MM-C TC9217MM-W LTC 2813/90 TC9217MM-C TC9217MM-W LTC 2814/90 TC9217MM-C TC9217MM-W LTC 2821/90, /91 TC9220MM-C TC9220MM-W LTC 2910/90 MM30
ページ3に含まれる内容の要旨
Installation and Assembly Models: TC9217MM-W, TC9220MM-W, BOSCH TC9227MM-W BOSCH Monitor Wall Mounts Before you start make sure all parts IMPORTANT! Read entire This product is intended for use with UL shown (see parts list, page 9) are Listed products and must be installed by a instruction sheet before you qualified professional installer. included with your bracket. start installation and assembly. IMPORTANT! If attaching a VCR Mount Product is UL rated up to ___ TV carefully study both
ページ4に含まれる内容の要旨
TV BOTTOM Attach support tray (A) to vertical support arms (P) as shown. Y Note: Choose the square hole which aligns closest with the center of gravity R mark on the TV (as determined in step 1). R Y Attach anti-rollout hooks (R) as shown using M6 Z screws (Z) and retainer P bars (Y). Note: Extruded side of retainer bar (Y) E Y goes towards anti-rollout hook (R). Hand tighten only. R A P J O P T I O N A L Although top clamps (Q) and anti-rollout hooks (R) [see step 7] will provide more t
ページ5に含まれる内容の要旨
For Wood Stud Walls drill three 5/32" (4 mm) dia. holes to a minimum depth of 2.5" (64 mm) into stud center. Attach wall arm (W) using three #14 x 2.5" (6 mm x 65 mm) wood screws (V). WARNING • Tighten wood screws so wall arm is firmly attached, but do not tighten with excessive force! Overtightening can cause stress damage to wood screws, greatly reducing their holding power. Tighten to 80 in • lb (9 N.M.) maxi- mum torque. WOOD STUD WALL W V 5 of 12 ISSUED: 06-25-99 SHEET #: 039-9003-8 02-
ページ6に含まれる内容の要旨
WARNING • When installing BOSCH wall mounts on cinder block, verify that you have a minimum of 1-3/8" of actual concrete surface in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount in a solid part of the block, generally 1" minimum from the side of the block. Cinder block must meet ASTM C-90 specifica- tions. It is suggested that a standard electric drill on slow setting is used to drill the hole instead of a hammer drill to avoid breaking out the b
ページ7に含まれる内容の要旨
Note: Slots in corners of top clamps (Q) and corners of vertical support arms (P) allow for the installation of safety belt (model ACC 666, sold separately). If using this belt, install it now. DETAIL 1 Q Q Q DETAIL 2 R Z Q R P R A P R K P Position TV onto support tray (A). Position anti-rollout hooks (R) against front edge of TV. WARNING • Each anti-rollout hook (R) should have at least 1/4” of surface contact with the front of the TV. If this is not the case the support tray (A) must be adjust
ページ8に含まれる内容の要旨
TILT CLEARANCE S T F S O When attaching the horizontal support (S) to wall arm or ceiling plate, carefully thread retaining collar (O) onto end of flush mount (T) tube (or extension column). Tighten at least DETAIL 3 four complete turns ending with one of the small threaded (BOTTOM VIEW) holes aligned with slot in the end of flush mount tube (T) (or extension column). Insert and tighten one M5 screw (F). WARNING • Set screw (F) is self tapping and may be hard to get started but is essential to t
ページ9に含まれる内容の要旨
Parts List TC9217MM-W TC9220MM-W TC9227MM-W Description Qty. Part # Part # Part # A1 left end support tray 1 128-1023 128-1026 128-1026 A2 right end support tray 1 128-1024 128-1027 128-1027 center support tray 1 128-1128 128-1134 128-1135 A3 B 5/16 - 18 x 1/2" carriage bolt 4 520-9207 520-9207 520-9207 C 5/16-18 washer/nut combo 4 530-1016 530-1016 530-1016 M10-1.5 x .7 flange nut 2 520-9261 520-9261 520-9261 E F M5 x .8 x 10 mm screw 6 520-9250 520-9250 520-9250 G uni-clip 4 2245-081 2245-081
ページ10に含まれる内容の要旨
GENERAL WALL MOUNT KIT SPECIFICATIONS Mount TV/Monitor Product BOSCH rated when attached to... Support concrete, Model Tray wood cinder block stud Number Depth (D) Screen Size or brick 125 lb 150 lb 10" 13" - 17" (57 kg) (65 kg) TC9217MM-W (254 mm) (330 mm) (432 mm) 125 lb 150 lb 10" 19" - 21" (57 kg) (65 kg) (254 mm) (482 mm) (533 mm) 14" 19" - 21" 125 lb 150 lb TC9220MM-W (356 mm) (482 mm) (533 mm) (57 kg) (65 kg) 125 lb 150 lb 10" 25" - 27" (57 kg) (65 kg) (254 mm) (635 mm) (686 mm)
ページ11に含まれる内容の要旨
ページ12に含まれる内容の要旨
Americas Europe, Middle East, Africa Asia-Pacific Bosch Security Systems Bosch Security Systems B.V. Bosch Security Systems Pte Ltd 130 Perinton Parkway P.O. Box 80002 38C Jalan Pemimpin Fairport, New York, 14450, USA 5600 JB Eindhoven, The Netherlands Singapore 577180, Singapore Phone: +1 (585) 223 4060 E-mail: Phone: +65 319 3488 Fax: +1 (585) 223 9180 ema.securitysystems@bosch.com Fax: +65 319 3499 E-mail: security.sales@us.bosch.com http://www.boschsecurity.com E-mail: www.boschsecurity.us
