ページ1に含まれる内容の要旨
LCM7070
7”Color TFT-LCD Monitor
10
ページ2に含まれる内容の要旨
Specifications 12 Saftey Advice 13 Wiring Diagram 14 Installation 15 Baisc Functions 16 Electronical Installation and control functions 17 Trouble shooting 18 WARRANTY CARD 38 11
ページ3に含まれる内容の要旨
Specifications 7” (17,8cm) FTF/LCd 16:9 Car Monitor Stand-alone or Headrest Installation Resolution: 1400 x 234 pixel Resolution RGB 480 x 234 pixel Contrast Ratio 300:1 Brightness 350cd/m2 Viewing Angle Vertical 160°, Horizontal 160° PAL/NTSC Auto Mode On Screen Display Control V1 & V2 Inputs 1 x Remote control 1 x Mounting Stand & Cable Kit 1 x Heardrest Mounting bracket Built in IR Headphone Transmitter 1 x Monitor Control Box 12 Subject to technical changes
ページ4に含まれる内容の要旨
Saftey Advice Thank you for choosing a Audiovox product. We hope you will find the instructions in this owner’s manual clear and easy to follow. If you take a few minutes to look through it, you’ll learn how to use all the features of your new Audiovox LCM7070 monitor for maximum enjoyment. Traffic The Driver should never operate these products while the vehicle is in motion! Installation of all TV monitors must be out of the driver´s field of vision. Build-in position Installation of all TV mo
ページ5に含まれる内容の要旨
Caution: Please oberserve the right polarity of the cables and the right colours of the RCA-Plugs. 14 Technische Änderungen vorbehalten
ページ6に含まれる内容の要旨
Method 1: Installation with Stand Mount at first the stand at an appropriate postion. F.i. in the dashboard with the supplied screws. Observe by any means, that you don´t damage wires, cables or other preinstalled parts in the vehicle. At first remove carefully the mounting frame of the monitor´s rearside. Then slide the monitor´s mounting slot (A) on the fixing plate (B) from the mounting stand. Ensure thereby a propper allignment of the fixing plate in the mounting slot and don´t tilt. Adduc
ページ7に含まれる内容の要旨
Basic Functions Remote Control The Monitor settings can be adjusted only with remote control 16 Technische Änderungen vorbehalten
ページ8に含まれる内容の要旨
Electronical installation and control functions 1. Please connect the monitor connection cable with the supported „S“ cable. The other side of the „S“ cable you con- nect with the Monitor control box. 2. Connect your DVD player or your headunits Audio / Video output with the Audio / Video input 1 at the monitor con- trol box. 3. Please connect the power connection cable like follow: - red: ignition DC 12V or with the automatic antenna output of your Radio - yellow: DC 12V permament power - b
ページ9に含まれる内容の要旨
Trouble Shooting Power This product is designed for operation with a 12 Volt DC, negative ground vehicle. Too low voltage or wrong polarity my cause malfunctions. Service Do not try and service these products yourself, seel only a qualified service center or factory service center. Damages Be careful not to drop or apply undue pressure to the frontpanel of your video monitor. If the screen crakcs due to misuse you warranty will be void! Check-Points 1. The operating temperature of this product