ページ1に含まれる内容の要旨
DVD/CD RECEIVER KD-ADV6160/KD-DV5100
RECEPTOR CON DVD/CD KD-ADV6160/KD-DV5100
RECEPTEUR DVD/CD KD-ADV6160/KD-DV5100
For canceling the display demonstration, see page 11.
Para cancelar la demostración en pantalla, consulte la página 11.
Pour annuler la démonstration des affichages, référez-vous à la page 11.
For installation and connections, refer to the separate manual.
For customer Use:
Para la instalación y las conexiones, refiérase al manual separado.
Enter below the Model
Pour l’installa
ページ2に含まれる内容の要旨
Thank you for purchasing a JVC product. Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit. INFORMATION (For U.S.A.) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates
ページ3に含まれる内容の要旨
WARNINGS: This product incorporates copyright protection technology that is protected DO NOT install any receiver in by U.S. patents and other intellectual locations where; property rights. Use of this copyright – it may obstruct the steering wheel and protection technology must be authorized gearshift lever operations, as this may by Macrovision, and is intended for home result in a traffic accident. and other limited viewing uses only unless – it may obstruct the operation of saf
ページ4に含まれる内容の要旨
How to read this manual How to use the M MODE button The following methods are used to made the If you press M MODE, the receiver goes into explanations simple and easy-to-understand: functions mode, then the number buttons and Some related tips and notes are explained in 5/∞ buttons work as different function buttons. “More about this receiver” (see pages 50 – 54). Button operations are mainly explained with Ex.: When number button 2 works as the illustrations as follows: MO (monaural)
ページ5に含まれる内容の要旨
Contents How to reset your unit ........................... 2 Other disc operations ..................... 29 How to forcibly eject a disc ................... 2 Basic operations ..................................... 29 How to read this manual ........................ 4 Changing the display information ......... 30 How to use the M MODE button ........... 4 Selecting the playback modes ................ 31 Introduction — Playable discs ............ 6 Dual Zone operations ..................... 32 Li
ページ6に含まれる内容の要旨
Introduction — Playable discs Discs you can play Caution for DualDisc playback You can play back the following discs—12 cm The Non-DVD side of a “DualDisc” does (4-3/4") and 8 cm (3-3/16")—on this receiver: not comply with the “Compact Disc Digital DVD Video: Recorded in NTSC color Audio” standard. Therefore, the use of Non- system with Region Code “1” (see below). DVD side of a DualDisc on this product may – DVD-R/DVD-RW recorded in the DVD- not be recommended. Video format can also be
ページ7に含まれる内容の要旨
Control panel Parts identification Display window 1 5 (up) / ∞ (down) buttons Display window Function as Play / Stop buttons for DVD a Disc information indicators— and VCDs. TAG (ID3 Tag), (folder), (track/file) 2 E EQ (equalizer) button s Main display 3 D DISP (display) button d Source display / Volume level indicator 4 S SEL (select) button f EQ (equalizer) indicator 5 Control dial g Sound mode indicators—ROCK, (standby/on attenuator) button CLASSIC, POPS, HIP HOP, JAZZ, USER 6 Di
ページ8に含まれる内容の要旨
Remote controller — RM-RK230 Installing the lithium coin battery Main elements and features (CR2025) MONITOR CONTROL MODE ASPECT MENU DVD / RECEIVER CONTROL ZOOM ATT +10 SOURCE –100 +100 PRESET / TITLE BAND –10 / TITLE DUAL OSD 123 DISC+ VOL TOP M MENU 456 2nd VOL ENTER 78 9 – DISC SETUP RETURN 0 Before using the remote controller: SHIFT Aim the remote controller directly at the remote sensor on the receiver. Make sure RM-RK230 there is no obstacle in between. Remote sensor IMPORTANT: Fo
ページ9に含まれる内容の要旨
2 4 BAND button r Menu operation buttons* ® Selects the FM/AM/SIRIUS bands. Cursor (% , fi , @ , #), and ENTER 2 5 TOP M (menu) button* % / fi : Also function as DISC + / – 3 Display the DVD and VCD* disc menu. buttons when the source is “CD-CH.” 4 2 6 DUAL button* t RETURN button* Activate and deactivate Dual Zone. y Special function buttons 7 VOL + / – buttons DVD/VCD: (audio) Adjusts the volume level. DVD: (subtitle), (angle) Also function as 2nd VOL +/– buttons 4 1
ページ10に含まれる内容の要旨
Getting started Basic operations * The control panel illustrations used in this manual is of KD-ADV6160. ~ ⁄ Adjust the volume. Ÿ Volume level appears. You cannot select some sources if they Volume level indicator are not ready. @ Adjust the sound as you want. (See pages 33 and 34.) ! For FM/AM tuner only To drop the volume in a moment (ATT) To restore the sound, press it again. ® For SIRIUS radio only To turn off the power 10 EN08-15_KD-ADV6160[J]f.indd 10 EN08-15_KD-ADV6160[J]f.in
ページ11に含まれる内容の要旨
Canceling the display Setting the clock demonstrations 1 If no operations are done for about 20 seconds, display demonstration starts. [Initial: DEMO ON]—see page 35. 2 Set the hour and minute. 1 Select “CLOCK H” (hour), then 1 adjust the hour. 2 Select “CLOCK M” (minute), then adjust the minute. 2 3 3 Finish the procedure. To check the current clock time when the power is turned off 4 Finish the procedure. To activate the display demonstration In step 3 above... 11 EN08-15_KD-ADV6160
ページ12に含まれる内容の要旨
Radio operations Listening to the radio To tune in to a station manually ~ In step ! on the left column... 1 Ÿ Selected band appears. 2 Select the desired station frequencies. Lights up when receiving an FM stereo broadcast with sufficient signal strength. ! Start searching for a station. When a station is received, searching stops. To stop searching, press the same button again. 12 EN08-15_KD-ADV6160[J]f.indd 12 EN08-15_KD-ADV6160[J]f.indd 12 12/14/04 2:25:32 PM 12/14/04 2:25:32
ページ13に含まれる内容の要旨
When an FM stereo broadcast is hard to Storing stations in memory receive 1 You can preset six stations for each band. FM station automatic presetting — SSM (Strong-station Sequential 2 Memory) 1 2 Select the FM band (FM1 – FM3) Lights up when monaural mode is activated. you want to store into. Reception improves, but stereo effect will be lost. To restore the stereo effect, repeat the same procedure. “MONO OFF” appears and the MO indicator goes off. 3 4 “SSM” flashes, then disappea
ページ14に含まれる内容の要旨
Manual presetting Listening to a preset station Ex.: Storing FM station of 92.5 MHz into the preset number 1 of the FM1 band. 1 1 2 2 3 Select the preset station (1 – 6) you want. 3 or 4 When using the remote controller.... or Preset number flashes for a while. To check the current clock time while listening to an FM or AM station * If no title is assigned to a station, “NO NAME” appears. To assign a title to a station, see page 38. 14 EN08-15_KD-ADV6160[J]f.indd 14 EN08-15_KD-
ページ15に含まれる内容の要旨
Disc operations Playing a disc in the receiver The disc type is automatically detected, and Before performing any operations, make playback starts automatically (for DVD: sure the following.... automatic start depends on its internal program). Turn on the monitor for playing a DVD or VCD. If you turn on the monitor, you can also If the current disc is an audio CD, CD Text, control the audio CD, CD Text, and MP3/ MP3/WMA, or VCD without PBC, all tracks WMA playback by referring to the monito
ページ16に含まれる内容の要旨
When inserting a DVD disc: When inserting a VCD: Total title number Total playing time Total track number of the inserted disc of the inserted disc Elapsed playing time Elapsed playing time Current chapter number When inserting an MP3/WMA disc: When inserting a CD Text/audio CD: Total folder number Total playing time Total track number of the inserted disc of the inserted disc Total track number CD Text: Disc title/performer = Track title appears automatically Ex.: When an MP3 file
ページ17に含まれる内容の要旨
Basic operations Operations Display indication and/or next operation To stop play temporarily “PAUSE” illuminates on the display. A still picture appears. A Frame by frame playback B Slow motion playback No sound comes out during Slow Motion Playback. When playing a VCD, Reverse Slow Motion Playback is prohibited. To resume normal play: To replay the previous The playback position moves back about 10 seconds before scenes—One Touch Replay the current position. This function works only wi
ページ18に含まれる内容の要旨
To go to the next or previous To locate a particular title/chapter/ chapters/tracks track directly For DVD: During play or pause For DVD: During play or pause—select a chapter. During stop—select a title. To the following For VCD: While PBC (see page 20) is not chapters/tracks. in use. For MP3/WMA: Select a track within the same folder. To go back to the beginning of the current chapter/track, then the previous chapters/tracks. Select the number corresponding to the item you want
ページ19に含まれる内容の要旨
DVD/VCD special functions For VCD: You can select the audio channel to Selecting subtitles play. (This is convenient when playing a You can select the language of the subtitle Karaoke VCD.) to be shown on the monitor. You can set the initial subtitle language using the setup menu (see page 27). ST ST 1/3 ENGLISH 1/3 ST: To listen to normal stereo (left/right) ENGLISH playback. Ex.: When the disc has 3 options L: To listen to the L (left) audio channel. R: To listen to the R (right) audio
ページ20に含まれる内容の要旨
Canceling the PBC playback Disc menu operations 1 Menu-driven playback is possible while playing back a DVD with menu-driven features or a VCD with the PBC (PlayBack Control). 2 Select a track to start normal playback using the number buttons (see page 9). While playing a DVD To resume the PBC function 1 A title list or disc menu will appear on the monitor. Zoom in 2 Select the item you want on the menu. 1 Selected item starts playback. ZOOM 1 ZOOM 2 ZOOM 3 ZOOM 4 On some discs, you c
