ページ1に含まれる内容の要旨
K
R
T
/
N
U
T
RPD 552
High-Power FM/AM/CD Receiver with Detachable Face
Autoradio AM/FM à Lecteur CD de Forte Puissance et à Face Amovible
Receptor FM/AM/Reproductor de CD de Alta Potencia y con Panel Extraíble
Rádio FM/AM/CD de Alta Potência
com Face Removível
Robert Bosch Corporation
Sales Group —
Blaupunkt Division
2800 South 25th Avenue,
Broadview, Illinois 60155
Issue date 03-01
288F0170
RPD552_Cover 1 2/15/01, 6:03 PM
RPD 552 210
CD
PWR
FM
VOL
TS
AUD MIX RPT LD/SENS DISP AM
PORTUGUÊS ESP
ページ2に含まれる内容の要旨
FCC WARNING Precautions Handling the Front Panel This equipment has been tested and found to comply with the • Carefully read this manual before using the unit. If you en- Attaching the Front Panel limits for a Class B device, pursuant to Part 15 of the FCC Rules. counter any problems that are not covered in this manual, These limits are designed to provide reasonable protection please consult the dealer where you purchased the unit or Place the right hand side of the front panel so that the par
ページ3に含まれる内容の要旨
T / N U T Identification of Controls RPD 552 210 CD PWR FM VOL TS AUD MIX RPT LD/SENS DISP AM 1 REL button 11 PRESET MEMORY button Releases the detachable front panel. During radio reception : 2 CD insertion slot 1 6/ - ; For Preset memory Insert the CD here. During CD mode : 3 LCD Display window 4/MIX ; For Mix play 4 PWR button 5/RPT ; For Repeat play Turns the power of the unit on. Mute on/off during power on. 6/ Press for more than 2 seconds to turn off. ; For Pause 5 Eject but
ページ4に含まれる内容の要旨
General Operations Power On/Off Volume Level Control Adjusting the Sound Characteristics VOL / Press the to adjust the volume level. AUD 1. Press the to select the desired adjustment mode. Turning on the power : Volume up BASS ➜ TREBLE ➜ BALANCE & FADER ➜ Mute level PWR : Volume down. Press the to turn on the unit. 2. Press the following buttons to adjust the selected item. Make Turning off the power You can check the volume level visually with the indicators in the adjustment within 5 seco
ページ5に含まれる内容の要旨
Radio Reception Preset Scan Tuning Receiving the Memorized Stations Seek Tuning AM FM AM FM 1. Press the or to select the desired radio band. 1. Press the or to select the desired radio band. AM FM 1. Press the or to select the desired band. FM I ➜ FM II ➜ FM III 1 6/ 2. Press the . 2. Press the - momentarily. or The unit will scan preset memory for the 12 stations from AM I ➜ AM II the AM I/AM II band or the 18 stations from the FM I or FM Local/Distant (LO/DX) Selection II and FM I
ページ6に含まれる内容の要旨
CD Operations Playing the CD player Listening to a disc that is already loaded Scan Play CD Press the to select the CD mode. Press the during CD mode. Playback begins automatically. The ‘‘SCAN’’ indicator appears in the display window. This will Loading Discs play the first 10 seconds of all the tracks on the disc. Insert the disc into the CD insertion slot with the labeled side Pausing Playback Press the again to cancel this feature. facing up. 6/ Press the . ‘‘ ’’ indicator will light
ページ7に含まれる内容の要旨
Installations Supplied Mounting Hardware Mounting Example Bushing Use * Installation in the dashboard. 3. As shown in the figure below, securely fasten the screw, which has been inserted into the bushing, at the rear of the 1. Install the sleeve in the dashboard. unit. Removal trim ring Sleeve Bushing, Locking Mounting Strap Release Fire wall (Supplied) Screw Screw and Screws Keys Precautions • Be sure to remove/detach the front panel before you start 2. Select and bend the appropriate tabs to
ページ8に含まれる内容の要旨
Connections Warning Connection procedure • To prevent short circuit, remove the key from the ignition and disconnect the battery’s (-) terminal. ANTENNA SOCKET • This unit is designed for negative ground 12 V DC operation ANTENNA PLUG only. You can not use it for 24 V or other types of car batter- In the case of a 2-speaker system, ies. tape the ends of unconnected terminals to prevent short circuit 4-speaker System 2-speaker System Connection procedure (White) (White) Front Left Left (White/
ページ9に含まれる内容の要旨
Maintenance Removing the Unit Replacing the Fuse Use the supplied release keys when you need to remove the If the fuse is blown, check the power connection first and then unit from the car. replace the fuse. If the fuse blows again under normal condi- Insert them into the unit as shown below. This will unlock the tions, the unit may be defective. unit from the sleeve, allowing for removal of the unit. Back of the unit Notes Warning • Handle the release keys carefully to avoid injuring your fi
ページ10に含まれる内容の要旨
Troubleshooting Guide Specifications The following check will assist in the correction of most prob- CD Player Troubleshooting GENERAL lems which you may encounter with your unit. Before going Dimensions : Approx. 178 mm × 50 mm × 155 mm through the check list below, refer back to the connection and When problems occur with CD playback, an error message (W × H × D) operating procedures. appears in the display window. Power requirements : 12 volts DC car battery Refer to the table below to identi
