ページ1に含まれる内容の要旨
Radio / Cassette
Lima CR 47
Operating instructions
Lima CR47 d® 1 13.05.2002, 10:33 Uhr
ページ2に含まれる内容の要旨
Table of Contents Features ......................................................................................................................................... 19 Traffic Safety and Precautions....................................................................................................... 19 Detachable Face (Release Panel).................................................................................................20 Electrical Connections .........................................
ページ3に含まれる内容の要旨
Features • Radio Features - 15 FM/5 AM Presets, Including 5 FM and 5 AM Travelstore Presets - Station Scan - Local/Distant Seek and Manual Tuning • Cassette Tape Player Features - Auto-Reverse Cassette Mechanism - True Fast-Forward/Rewind - Hard Permalloy Tape Head - Radio Monitor with Radio Preset Access • Audio Features: - 10 Watts x 4 Channel Integrated Amplifier - Adjustable Maximum Turn-On Volume - Bass, Treble, Balance and Fader Control - Loudness Button - Mute Button • Other Features: - D
ページ4に含まれる内容の要旨
Detachable Face (Release Panel) Detaching and Attaching the Face: The face of this unit can be detached and taken with you to prevent it from being stolen. Detaching the Face: Press the REL (Release) Button and detach the face by gently pulling it off as illustrated. Note: Do not pull it straight out from the chassis. Be sure not to drop the face when detaching it from the chassis. Do not expose the face to direct sunlight, heat sources such as hot air ducts or leave it in a humid place. Attachi
ページ5に含まれる内容の要旨
Electrical Connections To avoid the aggravation of costly mistakes and serious damage, please carefully read all of the instructions before you begin. Carefully follow all instructions. General Recommendations • If you’re not confident that you can install the unit correctly, have it installed by a qualified Blaupunkt installation technician. • Use this unit only with negative ground 12 Volt (11-16 Volt) direct current (DC). • Be sure to detach the faceplate before you start to connect or instal
ページ6に含まれる内容の要旨
Speaker Connections Speaker Connections + - + - + - + - RF RR LF LR Attach the faceplate and test the unit. Once the connections have been successfully made, you can begin to mount the unit. 22 Lima CR47 gb® 22 13.05.2002, 10:37 Uhr RR RF LF LR 5A
ページ7に含まれる内容の要旨
Installation Recommendations • The illustration below shows a typical installation, however, you may need to adjust the installation, depending on the unit. If you have questions or need additional installation hardware, consult your Blaupunkt dealer. • Make sure the unit is firmly anchored and does not vibrate. Mounting Hardware Release Keys Sleeve Mounting The Unit in Most Dashboards 1. Install the Sleeve in the dashboard. 2. Select and bend the appropriate tabs to hold the sleeve firmly i
ページ8に含まれる内容の要旨
Mounting the Unit in a Japanese Car You may have difficulty mounting this unit in some Japanese cars that have ISO mounting features. In this case, consult your Blaupunkt dealer. 1. Run a blade along the slits on the back of the front trim ring, unscrew the two side screws, and separate it from the unit. Save the trim ring and related hardware in case you ever want to install the unit in another vehicle. 2. Use the vehicle’s own mounting hardware to attach the unit. 1 2 TOYOTA max. size M5x8 Sli
ページ9に含まれる内容の要旨
Maintenance Removing the Unit Use the Release Keys as shown below. Keep them in a safe place in case you need them in the future. Fuse Replacement When replacing the fuse, be sure to use one with the correct amperage, which will be stated on the fuse case. Never use a fuse that has a stated amperage exceeding the one supplied for this unit, as this could cause malfunction and serious damage to the unit. 25 Lima CR47 gb® 25 13.05.2002, 10:37 Uhr PORTUGUÊS ESPAÑOL SVENSKA NEDERLANDS ITALIANO FRAN
ページ10に含まれる内容の要旨
Location of Controls 1 REL (Release) – Detaching Faceplate 2 ON (Power) – Turning Unit On 3 SRC – Source and Radio Band Select 4 – Cassette Eject 5 – Mute AUDIO – Audio / Clock Adjust :00 6 SCA – Scan TS – Travelstore 7LD – Loudness SENS – Tuning Sensitivity 8 Cassette Insertion Slot 9 CLK – Clock Recall DISP – Display Change 10/11 PROG – Tape Program Change (reverse) 10 FR – Fast Rewind 11 FF – Fast Forward 12 + – Volume + / Bass + / Treble + / Balance Left / Fade to Front 13 – – Volume - / Bas
ページ11に含まれる内容の要旨
Instructions – General Operation See Traffic Safety and Precautions on page 19. “Press” means a momentary press of less than 1/2 second. All presses requiring more than 1/2 second are followed by beep. “Time Out” When additional button presses are anticipated to complete a procedure, the unit will automatically exit the procedure after 4 seconds of inactivity. Clock Recall Vehicle ignition must be on. The display switches to clock. Ignition-On / Turning Unit Off Press the ON Button to turn the u
ページ12に含まれる内容の要旨
Audio Operation Volume Control Buttons (+/–) Press + and – to increase/decrease volume from 0 to 63. Adjustable Maximum Turn-On Volume Press and hold the ON Button for more than two seconds. The unit turns off and the turn-on volume level is memorized. Mute Press to temporarily reduce volume. “MUTE” appears. Mute is terminated by pressing any button. Bass, treble, balance and fader • Bass Hould down the AUDIO Button until “BASS” appears and then press immediately + or – to increase or decrease
ページ13に含まれる内容の要旨
Radio Operation Last Station Memory Each FM bank and AM band has its own last station memory which holds last-tuned frequency for that band or bank irrespective of whether that frequency is stored into a preset. Selecting Bands Press SRC as needed to access FM1, FM2, FM3/FMT, AM/AMT banks. Seek Tuning Press or to seek next receivable frequency. Tuning stops at frequency that fulfills sensitivity requirements predetermined by sensitivity set through SENS button. Tuning Sensitivity (SENS) Press
ページ14に含まれる内容の要旨
Cassette Tape Player Operation Tape Playback: • Insert cassette into Cassette Door. (Note: Make sure that the side of the cassette exposed is facing right and that all slack has been removed from the tape prior to insertion.) • If ignition switch is already in “on” or accessory position, insertion of cassette will turn unit on. If unit already turned on, cassette insertion will override other audio source, such as radio. “LOAD” appears for 2 seconds. Cassette play will begin, and the display wil
ページ15に含まれる内容の要旨
Troubleshooting Guide General Trouble Cause/Solution No sound. • Adjust the volume with the + button. • With a two-speaker system set the fader control to the center position. Radio reception Trouble Cause/Solution* Preset stations are not receivable. • The broadcast is too weak. Automatic tuning is not possible.• The broadcast is too weak. —> Use manual tuning. Travel Store feature does not complete • Not enough broadcast frequencies are recei
ページ16に含まれる内容の要旨
Specifications Audio Power Specifications Power Output and Total Harmonic Distortion: 5.5 watts per channel minimum continuous average output into 4 ohms, 4 channels driven, from 35-15000 Hz. Other Specifications Tuner FM Tuning Range: 87.5 - 108 MHz FM Mono Sensitivity: 1.3 µV Signal-to-Noise Ratio: 65 dB (stereo), 70 dB (mono) Frequency Response: 35-15000 Hz AM Tuning Range: 531 - 1602 kHz Signal-to-Noise Ratio: 50 dB Frequency Response: 35-5000 Hz Cassette Signal-to-Noise Ratio: 55 dB Tape Wo
ページ17に含まれる内容の要旨
Blaupunkt-Werke GmbH Bosch Gruppe 11/96 K7/VKD 8 622 400 953 17 Lima CR47 d® 17 13.05.2002, 10:34 Uhr PORTUGUÊS ESPAÑOL SVENSKA NEDERLANDS ITALIANO FRANÇAIS ENGLISH DEUTSCH
