ページ1に含まれる内容の要旨
0
UMP9020
Owner's Manual/Manual del Usario/Manual de L'Utilisateur
AM/FM/CD/MP3/WMA Cassette Receiver
WMA
AM / FM / CD/MP3/ WMA CASSETTE RECEIVER
ULTRA SERIES UMP9020 7
TAPE OPEN CLOSE CD OPEN CLOSE EJ
Receptor Casete AM/FM/CD/MP3/WMA
MUTE
BAND
LOUD
9
Ampli-Syntoniseur Cassette AM/FM/CD/
MANU
MP3/WMA
SKIP
8
SCAN
/
3 in 1 CD/MP3 CASSETTE RECEIVER
AMS PAU SCN RPT SHF CD- CD+
D-AUD
ページ2に含まれる内容の要旨
UMP9020 Para obtener instrucciones en Español, diríjase a la página 22. Pour des instructions en Francais, référez-vous à la page 42. PREPARATION Getting Started customer support line at 1-800-323-4815. Disconnect Battery (U.S.A. and Canada only.) It’s a good idea to read all of the instructions Before you begin, disconnect the battery before beginning the installation. negative terminal. Tools and Supplies Contents The following tools and supplies are needed to Installation Instructions.....
ページ3に含まれる内容の要旨
UMP9020 INSTALLATION INSTRUCTIONS ISO Installation ISO INSTALLATION CAUTION: The support strap must be used This unit is designed to fit into a 2.0 DIN to prevent damage to the dashboard from dashboard opening, found in many imported the weight of the radio or improper cars. The unit has threaded holes in the chassis operation due to vibration. side panels which may be used with the original factory mounting brackets of some Toyota, Nissan, Mitsubishi, Isuzu, Hyundai and Honda CAUTION: F
ページ4に含まれる内容の要旨
UMP9020 WIRING CD Changer Connector Auxiliary Input Antenna 15 15 Connector Power Antenna Connect to power antenna Blue or amplifier. If not used, tape Subwoofer Output bare end of wire. Connect to optional Blue subwoofer. Black Ground Gray Amplifier Wiring Connect to ground terminal. Rear Connect line out for optional external amplifiers. The red Yellow Memory/Battery Brown connector is for the right + Connect to battery or 12 volt Front and the white connector is power source that is always fo
ページ5に含まれる内容の要旨
0 UMP9020 OPERATING INSTRUCTIONS 1 3 4 Power On/Off Button Volume Control Audio Control (SEL) Press the POWER button (1) to turn the unit on To increase or decrease the volume level, turn Press the SEL button (4) twice to set the unit for and off when the vehicle ignition switch is on. If the AUDIO ADJUST control (3). The volume bass adjustment (“BAS” and the setting number the radio is off when the ignition switch is turned will increase/decrease and the level will be will momentarily appear
ページ6に含まれる内容の要旨
0 UMP9020 OPERATING INSTRUCTIONS panel. Within five seconds, rotate the AUDIO 4 5 Bass Control Loudness Control (BAND/LOUD) ADJUST control to adjust the balance between the To adjust the bass level, press the SEL button When listening to music at low volumes, this front and rear speakers from “10F” (full front) to (4) until “BAS” appears on the display panel. feature will boost the bass and treble ranges to “10R” (full rear). “F=R” represents an equal balance Within five seconds, rotate th
ページ7に含まれる内容の要旨
UMP9020 OPERATING INSTRUCTIONS 11 6 8 Tuning Control Audio Mute (MUTE) Equalizer Selector (EQ) Seek Tuning Press the MUTE button (8) to mute the volume The EQ button (11) applies preset sound effects from the system. “MUTE” will flash on the to the unit’s audio output signal. When pressed, Press either side of the MANU/SKIP (, ) display panel and the volume will be muted. it will activate one of the following modes: button (6) to tune rapidly to the next available Press the MUTE button
ページ8に含まれる内容の要旨
0 UMP9020 OPERATING INSTRUCTIONS 1. Turn the vehicle ignition and radio on. 13 18 - Station Pre-Set Memories 2. Press the DSP button (20) to display the clock. To set any one of the 6 pre-set memories (13- 3. Press and hold the DSP button (20) until 18) in each band, use the following procedure: the time flashes. 1. Turn the radio on and select a band. 4. Press the Down Tuning ( ) button (6) to 2. Select the first station to be pre-set using adjust the hours and the AM/PM indication the MAN
ページ9に含まれる内容の要旨
0 UMP9020 CD PLAYER OPERATION 21 CD Open/Close/Disc Slot 21 To access the disc slot, located behind the front WMA AM / FM / CD/MP3/ WMA CASSETTE RECEIVER panel, press the CD OPEN CLOSE EJ button ULTRA SERIES UMP9020 7 TAPE OPEN CLOSE CD OPEN CLOSE EJ (21). This causes the front panel to open and MUTE fold down, revealing the disc slot (22). With the BAND LOUD front panel in this fold-down position, gently 9 insert the disc into the slot (label side facing up) MANU until the soft-loading me
ページ10に含まれる内容の要旨
0 UMP9020 CD PLAYER OPERATION 13 6 14 CD Play/Pause Selector Cue/Review Functions Track Scan Select (SCN) During disc play, press the PAU (play/pause) Use the Cue and Review functions to perform a During disc play, press the SCN button (14) to button (13) to pause the disc. When paused, high-speed audible search to any section of a play the first 10 seconds of each track. (“S- the disc symbol stops moving, “S-PAUSE” is disc. Press and hold the up tuning side of the SCN” will be displayed). When
ページ11に含まれる内容の要旨
UMP9020 CD PLAYER OPERATION 15 21 Repeat Play Selector (RPT) Disc Eject Button During disc play, press the RPT button (15) to Press the CD OPEN CLOSE EJ button (21) to repeat the playback of a desired track (S-RPT allow the front panel to fold down, exposing the appears on the display panel). Play of the disc slot (22). Press and hold the CD OPEN selected track will continue to repeat until the CLOSE EJ button to eject the disc and revert to Track Repeat function is cancelled by pressing rad
ページ12に含まれる内容の要旨
UMP9020 MP3/WMA PLAYER OPERATION Instructions for Insert/Eject, Play/Pause, Track Direct Song/File Access Table 1: Key Assignments Selection, Cue/Review, Scan, Repeat, and Press the D-AUD button (12) one time to AMS Mode Select Random are the same for CD and MP3 enable direct track searching. Use the preset BAND ENTER operation. Please see the CD Player Operation buttons 1-6, 7 (MODE), 8 ( ), 9 ( ) and 0 1A, B, C, 1 section for information about these topics. (DSP) to select the desired
ページ13に含まれる内容の要旨
0 UMP9020 MP3 PLAYER OPERATION Searching from the Root Directory 1. Press the D-AUD button (12) three times 23 21 2 to enable root directory searching. 2. Use the Up Tuning ( ) and Down Tuning ( ) buttons (6) to select the WMA AM / FM / CD/MP3/ WMA CASSETTE RECEIVER ULTRA SERIES UMP9020 7 desired directory/song. The display will list 7 8 TAPE OPEN CLOSE CD OPEN CLOSE EJ all available directories and songs. If a MUTE BAND directory is present, a "D-DIR" icon will LOUD 5 4 appear in the displ
ページ14に含まれる内容の要旨
UMP9020 TAPE PLAYER OPERATION rewind ( ) button is pressed while the tape is 23 26 Cassette Door/Insert Tape Eject Button moving from right to left, the tape rewinds. To To access the cassette door, located behind the To stop tape playback and eject the tape, press stop fast tape movement, lightly push the front panel, press the TAPE OPEN CLOSE the tape eject button (26), located behind the opposite button. If the tape is allowed to fast- button (23). The front panel will open and fold fro
ページ15に含まれる内容の要旨
0 UMP9020 CD CHANGER CONTROLS Built into the UMP9020 are controls to operate already in the changer, play resumes from the an optional CD changer. Please check with track on the disc previously in play. your Phase Linear car stereo specialist or call 1-800-323-4815 for recommendations of the 17 18 , Disc Select (CD-/CD+) models that will work with this radio. The CD-/CD+ buttons (17 and 18) are used to Adjustment of the audio functions (volume, select the desired disc for play. To advance to
ページ16に含まれる内容の要旨
0 UMP9020 WIRELESS REMOTE CONTROL OPERATION The infrared remote controller will allow you to control the basic functions of the UMP9020. WMA AM / FM / CD/MP3/ WMA CASSETTE RECEIVER ULTRA SERIES UMP9020 7 The infrared sensor (27) detects the infrared TAPE OPEN CLOSE CD OPEN CLOSE EJ command signal from the remote control unit. MUTE BAND LOUD 9 MANU SKIP 8 SCAN / 3 in 1 CD/MP3 CASSETTE RECEIVER AMS PAU SCN RPT SHF CD- CD+ D-AUD 7 27 MOD SEL PWR VOL 9 8 TUNE/SEEK VOL LOU BND DSP 0 ENT PAU SCN RPT
ページ17に含まれる内容の要旨
UMP9020 CARE AND MAINTENANCE Your new radio/CD player does not require any disc may occur. Such damage will not be • Carefully wipe fingerprints, dust and dirt maintenance. However, proper understanding covered by the Warranty on this product. from the disc’s playing surface with a soft of its use and handling will help you obtain cloth. Wipe in a straight motion from the • When not using the disc player, always maximum enjoyment of its capabilities. We center to the outside of the disc. rem
ページ18に含まれる内容の要旨
UMP9020 SPECIFICATIONS CD-R and CD-RW Capability Technical Specifications AM Tuner Tuning Range: 530kHz - 1710kHz Depending on media type and method of Sensitivity @ 20dB Signal to Noise: 30uV "recording/burning", some CD-R/RWs may be Frequency Response: 30Hz - 2kHz, -3dB incompatible with this unit. After "recording/ General burning", the session must be closed. Please Power Supply: 11 to 16VDC, negative ground refer to your software's recommended Fuses: Battery - 15 amp/ATO, Ignition/ pro
ページ19に含まれる内容の要旨
UMP9020 90 DAY LIMITED WARRANTY AUDIOVOX CORPORATION (the Company) LIABILITY UNDER THIS WARRANTY IS may not apply to you. This Warranty gives you warrants to the original retail purchaser of this LIMITED TO THE REPAIR OR specific legal rights and you may also have product that should this product or any part REPLACEMENT PROVIDED ABOVE AND, IN other rights which vary from state to state. thereof, under normal use and conditions, be NO EVENT, SHALL THE COMPANY'S U.S.A: Audiovox Corporation, 150
ページ20に含まれる内容の要旨
UMP9020 20
