ページ1に含まれる内容の要旨
SM-CDM1057
CD/MP3/WMA RECEIVER CD/MP3/WMA-
Instruction manual
ページ2に含まれる内容の要旨
Dear customer! Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in the future. Table of contents Table of contents ................................................................................................. 2 Important safeguards...........................................................................................3 Installation/Connectio
ページ3に含まれる内容の要旨
IMPORTANT SAFEGUARDS Read carefully through the manual to familiarize yours with this high-quality sound system. Disconnect the vehicle's negative battery terminal while mounting and connecting the unit. When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher amperage rating may cause serious damage to the unit. Do not attempt to disassemble the unit. Laser beams from the optical pickup are dangerous to the eyes. Make sure that pins or other
ページ4に含まれる内容の要旨
Installation/Connections First complete the electrical connections, and then check them for correctness. If you are not confident working with electrical wiring, removing and reinstalling interior panels, carpeting, dashboards or other components of your vehicle, please call your dealer in order to have the unit professionally installed. Before installing the unit, please remove two screws on the top. Before the installation 1. Remove the old unit from the dashboard. Remove the outer trim frame
ページ5に含まれる内容の要旨
Installation method A After inserting the holder into the dashboard, select the appropriate tab and bend them inwards to secure the holder in place. Insert fingers into the groove in the front of frame and remove it. Insert the levers supplied with the unit to the grooves at both sides. The unit can be installed or removed from the dashboard. 5
ページ6に含まれる内容の要旨
Installation method B Note: Outer trim frame, hook, and mounting sleeve are not used for this installation. This is only intended as a general guide; contact the vehicle's manufacturer for specific instructions. This method of installation uses the screw holes at the sides of the unit and the holes of the existing vehicle mounting bracket. 1. Align the screw holes of the mounting bracket supplied with the car and the screw holes of the main unit. Tighten the 2 screws on each side of the unit. T
ページ7に含まれる内容の要旨
To detach the front panel The front panel of the unit may be removed as a theft deterrent. After removing the front panel, use the case provided to keep the front panel from getting damaged. 1. Press OPEN button to flip down the front panel. 2. Pull of the front panel. 3. Store the front panel in the protective case provided for safekeeping. To attach the front panel Hold the right side of the front panel with the plate facing down. First attach the left side of the front panel to the unit by in
ページ8に含まれる内容の要旨
Connection scheme Notes: In spite of having any kinds of speaker system, must use 4 ohms impedance of speaker to reduce the distortion during high volume level. Prohibit to make the conductors of auto antenna and ground touch with each other. 8
ページ9に含まれる内容の要旨
Accessories Name pcs 1 Hexagon nut M5 T (3.5 mm) 1 2 Mounting box (0.6 mm) 1 3 Left key (1.0 mm) 1 4 Right key (1.0 mm) 1 5 Metal bar (0.8 mm) 1 6 ISO connector 1 7 Plain washer =5 mm 1 8 Carrying case 1 9 Outer trim ring 1 10 Spring washer =5 mm 2 11 Screw 5X5 mm 4 12 Screw 5X25 mm 1 13 Screw M5 5X29.3 mm 1 14 Customer information 1 15 Warranty card 1 16 Instruction manual 1 9
ページ10に含まれる内容の要旨
Panel controls Front panel 1. AMS button 2. EQ button 3. MOD button 4. BAND/LOUD button 5. PREV button 6. No 1/PLAY/PAUSE button 7. No 2/SCN button 8. No 3/RPT button 9. No 4/SHF button 10. No 5 button 11. No 6 button 12. TA button 13. AF/REG button 14. PTY button 15. AUX in jack 16. OPEN button 17. EJECT button 18. Disc clot 19. VOL knob/SEL button 20. NEXT button 21. DISP button 22. POWER button 10
ページ11に含まれる内容の要旨
Inner panel Press OPEN button on the front panel to flip it down. 23. Light indicator 24. RESET button 11
ページ12に含まれる内容の要旨
General operations Power button Press any button (except OPEN) or insert disc to switch the unit on. Press the POWER button to switch the unit off. Volume control Rotate the VOL knob on the front panel to adjust volume level. Audio settings adjustment Press SEL button until the display shows: VOL => BAS => TRB => BAL => FAD. Rotate the VOL knob to adjust each mode. Press SEL button for 2 seconds to enter the menu mode. Press it repeatedly to choose the needed item: TA SEEK/ALARM => PI SOUND/MUTE
ページ13に含まれる内容の要旨
Choose PI sound or mute. PI sound refers to the reception noise when the AF function tries to scan alternative frequency. RETUNE mode To determine the initial time of automatic TA (Traffic Announcement) search. There are 2 modes: RETUNE L and RETUNE L. - RETUNE L: 90 seconds. - RETUNE S: 30 seconds. Note: Retune mode is active for TA SEEK mode only. MASK mode During AF search, PI stations and non-RDS (Radio Data Station) stations with strong signal will be masked, in the latter case, the n
ページ14に含まれる内容の要旨
- In case of receiving a RDS station In radio mode: PS -> CT -> FREQ -> P TY In CD mode: CD -> CT -> (ID3 TAG) -> PS -> FREQ -> PTY * In case of no receiving CT or PTY Information, the display shows as “NO CLOCK” or “NO PTY”. - In case of receiving a non RDS station In radio mode: “NO CLOCK” -> FREQ-> ”NO PTY” In CD mode: CD -> “NO CLOCK” -> FREQ -> “NO PTY” Each displaying time is several seconds, and come back to 1'st position after several seconds. Notes: CT = clock time; FREQ = frequency. E
ページ15に含まれる内容の要旨
Radio operations Band selection Press the BAND/LOUD button repeatedly to select your desired radio band during RADIO mode: FM1, FM2, FM3, MW1. Automatic memory storing Press AMS button for 2 seconds, the radio searches from current frequency and checks the signal strength until one cycle is finished. And then 6 strongest stations are stored into the corresponding preset number button. Selecting station Press preset 1-6 button to select the station, which had been stored in the memory. Press the
ページ16に含まれる内容の要旨
RDS function Note: RDS (Radio Data System) service availability varies with areas. Please understand if RDS service is not available in you area, the following service is not available, either. Press AF/REG button to switch ON or OFF RDS function. Setting RDS mode Whenever RDS is switch on, symbol “AF” appears on the display. Program name is displayed on receiving a RDS station. “AF” starts blinking if the broadcasting signals getting worse. “ALARM” will be displayed when an emergency broadcasti
ページ17に含まれる内容の要旨
No2/SCN EASYM, LIGHT M No3/RPT CLASSICS, OTHER M No4/SHF JAZZ, COUNTRY No5 NATION M, OLDIES N06 FOLK M When you select the PTY SPEECH GROUP, the preset numbered buttons are shared as follows: Button Program No1/PLAY/PAUSE NEWS, AFFAIRS, INFO No2/SCN SPORT, EDUCATE, DRAMA No3/RPT CULTURE, SCIENCE, VARIED No4/SHF WEATHER, FINANCE, CHILDREN No5 SOCIAL, RELIGION, PHONE IN N06 TRAVEL, LEISURE, DOCUMENT Listening to Traffic Announcement Press TA button to turn on mode and a traffic announcement is tr
ページ18に含まれる内容の要旨
PI: Program Identification Code – for identifying code. PS: Program Service Name Broadcast – station name data expressed in alphanumerically character. TP: Traffic Program Identification – for traffic information broadcasting station. TA: Traffic Announcement Identification – showing traffic information is being transmitted or not. AF: Alternative frequencies – frequency list of broadcasting station transmitting the same program. Choose EON LOCAL if the transmitter is located near the your rece
ページ19に含まれる内容の要旨
CD/MP3/WMA operations This unit can play disc types: CD/CD-R/-RW. Compatible with formats: MP3/WMA. Loading/Removing the disc Insert the disc into the disc slot with the printed side facing up; the unit will play the disc automatically. Press EJECT button to eject the disc. Switching to CD/MP3/WMA mode When a disc is inserted in the unit, press MOD button to switch to the CD/MP3/WMA mode. Selecting tracks in single step Press PREV button to play the current track from the beginning. Press again
ページ20に含まれる内容の要旨
Selecting directory up/down Press No5 or No6 button to select directory downward or upward. If the MP3/WMA disc does not contain any directory, these buttons are not functional. Searching file and directory Press AMS button repeatedly to cycle through the following search modes: Searching by track number => Searching by directory or file name => Searching from current directory => Searching from root directory. 1. Searching by track number Press button AMS button once to enter “Searching by trac
