ページ1に含まれる内容の要旨
OWNER’S MANUAL
PLCD32
PLL SYNTHESIZER STEREO RADIO WITH
COMPACT DISC PLAYER DIGITAL
ページ2に含まれる内容の要旨
INSTALLATION Notes: • Choose the mounting location where the unit will not interfere with the normal driving function of the driver. • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. • Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions. • Consult with your nearest dealer if installation requires the drilling of
ページ3に含まれる内容の要旨
1. Dashboard 1 6 2. Nut (5mm) 3. Spring washer 7 4 4. Screw (5 x 25mm) 5 2 5. Screw 3 6. Strap Be sure to use the strap to secure the back of the unit in place. The strap can be bent by hand to the desired angle. (Fig. 2) 7. Plain washer Removing the unit 1. Frame 1 2. Insert fingers into the groove in the front of frame and pull out to remove the frame. (When reattaching the frame, point the side with a groove downwards 2 and attach it.) 3 3. Lever Insert the levers supplied with the unit
ページ4に含まれる内容の要旨
HOW TO REMOVE AND INSTALL THE FRONT PANEL 1. Press the release button and pull-off the front panel. Keep front panel into the case. 2. To install the front panel, insert the panel into the housing and make sure the panel is properly installed, otherwise, abnormalities occurs on the display or some keys will not function properly. REMOVING THE FRONT PANEL Front Panel Release Button INSTALLING THE FRONT PANEL 4
ページ5に含まれる内容の要旨
WIRING CONNECTION MAIN UNIT ANTENNA CONNECTOR IGNITION RED SWITCH (B+) (GREY) Rch RED RCA CABLE YELLOW MEMORY BACK-UP Lch WHITE BLACK GROUND (B–) POWER BLUE ANTENNA 2-SPEAKERS SYSTEM 4-SPEAKERS SYSTEM 4-SPEAKERS SYSTEM 2-SPEAKERS SYSTEM WHITE GREY WHITE GREY FRONT FRONT Lch SPK. Rch SPK. WHITE/BLACK GREY/BLACK Lch Rch SPK. SPK. GREEN VIOLET REAR REAR Lch SPK. Rch SPK. GREEN/BLACK GREEN/BLACK VIOLET/BLACK VIOLET/BLACK Note: 1. For 2-speakers system, green, violet, white/black and grey/black wire
ページ6に含まれる内容の要旨
OPERATION 7 17 2 1 3 5 8 12 10 11 4 16 18 13 20 21 22 14 23 19 15 6 9 24 25 GENERAL OPERATION • ON/OFF Switch on the unit by pressing any button [except button (4) and RELEASE button (7)]. When system is on, press button (9) to turn off the unit. • FACEPLATE RELEASE Press RELEASE button (7) to detach the removable faceplate. 6
ページ7に含まれる内容の要旨
• SOUND ADJUSTMENT Press SEL button (10) to select the desired adjustment mode. The adjustment mode will change in the following order: Volume Bass Treble Balance Fader By pressing VOL button (11) or VOL button (12), it is possible to adjust the desired sound quality. • LOUDNESS Press BND/LOU button (13) for several seconds to reinforce the bass output and display will show “LOUD”. Press it for several seconds again to release this function. • SET THE CLOCK Holding down the DSP button
ページ8に含まれる内容の要旨
RADIO OPERATION • BAND SELECTION At tuner mode, press BND/LOU button (13) shortly to select the desired band. The reception band will change in the following order: FM1 FM2 FM3 AM • STATION SELECTION Press TUNE/SEEK/TRACK button (16) or TUNE/SEEK/TRACK button (17) shortly to activate automatic seek function. Press for several seconds until “MANUAL” appeared on the display, the manual tuning mode is selected. If both buttons have not pressed for several seconds, they will ret
ページ9に含まれる内容の要旨
CD OPERATION • SELECT TRACKS Press TUNE/SEEK/TRACK button (16) or TUNE/SEEK/TRACK button (17) to move to the previous track or the following track. Track number shows on display. Hold TUNE/SEEK/TRACK button (16) or TUNE/SEEK/TRACK button (17) to fast reverse or fast forward. CD play starts from when you release the button. • PAUSE PLAYING Press PAU button (20) to pause CD player. Press it again to resume play. • REPEAT THE SAME TRACK Press RPT button (22) to
ページ10に含まれる内容の要旨
SPECIFICATION GENERAL Power Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 178 (W) x 165 (D) x 50 (H) Tone Controls - Bass (at 100 Hz) : + 10 dB / – 10 dB - Treble (at 10 KHz) : + 10 dB / – 10 dB Maximum Output Power : 40W x 4 (ch) Current Drain : 5 Ampere (max.) CD PLAYER Signal to Noise Ratio : More than 60 dB Channel Separation : More than 60 dB Frequency Response : 20 Hz - 20 KHz RADIO FM Frequency Coverage : 87.5 to 107.9 MHz IF : 10.7 MHz Sensitivity (S/N = 30 dB
ページ11に含まれる内容の要旨
TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Symptom Cause Solution No power. The car ignition switch is If the power supply is properly not on. connected to the car accessory circuits, but the engine is not moving, switch the ignition key to “ACC”. The fuse is blown. Replace the fuse. Disc cannot be Presence of CD disc inside Remove the disc in the player, load
ページ12に含まれる内容の要旨
www.pyleaudio.com 88-C1040-28
