ページ1に含まれる内容の要旨
+
P
D L
W
S U
P R D
PS ST
+
UP SEL DN
---
BD MU
CD
TAPE LOC
CDC
1RDM 2 RPT
3SCN
4
5 6AMS
CAR AUDIO
REMOTE CONTROLLER
-
P
D L
W
S U
R
P D
PS ST
+
UP DN
SEL
---
BD MU
CD
TAPE LOC
CDC
1RDM 2 RPT
3SCN 4
5 6AMS
CAR AUDIO
REMOTE CONTROLLER
REMOTE CONTROL BASICS BATTERY REPLACEMENT:
1.Remove the battery holder as the direction indicated by the arrow.
2.Replace the battery Set a new battery property with (+)side up as illustrated.
3.Insert the battery holder. Push in the ho
ページ2に含まれる内容の要旨
LOCATION AND FUNCTION OF CONTROLS 1 2 3 4 5 6 7 8 9 SPECIFICATION GENERAL Power Supply The Main Unit.................DC 13.8 Volts. Negative Ground Maximum Output Power........................................................4 x 35W Unit Dimension.............................................178(W) x 167(D) x 50(H) WOOFER + AUDIO LUD CD FF UP CD - CH FULL LOGIC CASSETTE/RECEIVER/CD-R/W PLAYBACK HIGH POWER 35WX4 CONTROL FM TUNER SECTION OPEN REL TUNE SEL BD Frequency Range........................
ページ3に含まれる内容の要旨
5. LCD (LIQUID CRYSTAL DISPLAY) TROUBLE SHOOTING 6. BAND BUTTON Before going through the check list, finish wiring connection. If there still are Press it to switch from tape, CD or CDC mode to radio mode, then press it any question after finish testing the items in the following list, consult your repeatedly to select the band and the LCD screen will be shown as below: nearest service dealer. FM 1 FM 2 FM 3 AM 1 AM 2 Symptom Cause Solution The comp
ページ4に含まれる内容の要旨
13.TAPE BUTTON INSTALLATION Press it to switch from radio, CD player or CD changer mode to tape mode. In tape mode, press it to make the player automatically switch to the opposite side of the tape when the tape reaches the end of one side. DASH BOARD 14.15.16.18.19.20. 1-6 preset memory buttons METAL MOUNTING STRAP Select the desired band, then tune for the station you want to store in memory, and then press and hold one of 1-6 preset memory buttons HEX NUT SP
ページ5に含まれる内容の要旨
PRECAUTIONS AND MAINTENANCE 17.POWER BUTTON Press it to turn on or off the unit. .1.This unit is designed for negative ground operation only. The equipment can be used safely, if the negative terminal of the battery is connected to the vehicle metal work. 18-19.DISC SELECTING BUTTONS 2.Do not use speakers of impedance less than 4 ohms; and allow the speaker In CD changer mode, press the DISC + button to select the next disc and wires to be shorted together when the unit
ページ6に含まれる内容の要旨
DISC PLAY: SPEAKER CONNECTION Cleaning discs: CDC SOCKET ANTENNA PLUG Before playing, clean the disc with a clean, lint-free. Flip the disc in the direction of the arrow. YELLOW WOOFER LINE OUT MEMORY B+ FUSED YELLOW FILTER BLACK(GND) BOX RCA LINE OUT RED R 0.5A &10A FUSES RED (B+) WHITE L BLUE AUTO ANT 1 A FUSE + + + + FRONT WHITE GRAY FRONT NOTE: RIGHT WHITE/BLACK GRAY/BLACK LEFT . Do not use so solvents such as benzine, thinners. Commercially available cleaners SP SP + + + + GR
