ページ1に含まれる内容の要旨
PLCD15MR
OWNER’S MANUAL
Mobile Audio System
• PLL Synthesizer Stereo Radio
• Digital Compact Disc Player
• Automatically Memory Storing
• Full Detachable Panel
• Program CD Tracks
• CD Changer Control
• Auxiliary Input Function
ページ2に含まれる内容の要旨
CONTENTS Installation .....................................................................................................3 DIN Front-Mount....................................................................................................3 Installing the unit.............................................................................................3 Removing the unit...........................................................................................4 Using the Detachable Front Panel .
ページ3に含まれる内容の要旨
INSTALLATION Notes: TAKE OUT SCREW BEFORE INSTALL • The unit can be installed on the vehicle Before install the unit, please remove the or the ships. two screws. • Choose the mounting location where Take out screw before installation the unit will not interfere with the normal driving function of the driver. • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. • Use only the parts included wi
ページ4に含まれる内容の要旨
INSTALLATION Removing the unit 1 6 1 2 5 3 7 Front Panel 4 OPEN button (Fig. 2) 2 1. Dashboard 2. Nut (5mm) 3. Spring washer 4. Screw (5x25mm) 5. Screw 6. Strap Be sure to use the strap to secure the back of the unit in place. The strap can 1. Before removing the unit, press the be bent by hand to the desired angle. OPEN button to slide down the front 7. Plain washer panel. 2. Lever Insert the levers supplied with the unit into the grooves in the housing as shown in figure until they click. Pull
ページ5に含まれる内容の要旨
USING THE DETACHABLE FRONT PANEL To Detach the Front Panel To Reinstall the Front Panel 1. Press the OPEN button, the front panel 1. When the panel bracket is in slide down will slide down. position, insert the front panel into the panel bracket and push the front panel from the middle to slide it up. Open Bottom 2. When the front panel slides down, Button press the bottom button of the front panel upward and pull it out from the 2. When the panel bracket is in slide up panel bracket. position,
ページ6に含まれる内容の要旨
WIRING CONNECTION For 4 x 40W System MAIN UNIT (BLACK) WIRING REMOTE CONNECTOR ANTENNA SOCKET SOCKET (BLACK) CD CHANGER CONNECTOR SOCKET FUSE (YELLOW) IGNITION RED Rch RED AUX IN SWITCH (B+) Lch WHITE YELLOW MEMORY BACK-UP BLACK GROUND (B–) (GREY) Rch RED REAR RCA CABLE POWER BLUE ANTENNA Lch WHITE WHITE GREY FRONT Lch FRONT Rch SPEAKER SPEAKER WHITE/BLACK GREY/BLACK GREEN VIOLET REAR Lch REAR Rch SPEAKER SPEAKER GREEN/BLACK VIOLET/BLACK 6
ページ7に含まれる内容の要旨
OPERATION 16 9 11 10 17 8 1 18 4 15 6 12 13 19 20 21 14 22 23 24 2 3 7 5 25 GENERAL OPERATION • SOUND ADJUSTMENT Press SEL button (10) to select desired audio mode. • ON/OFF The adjustment mode will change in Switch on the unit by pressing PWR the following order. button (9). When system is on, press PWR button (9) again to turn off the Volume Bass Treble Balance Fader unit. Press PWR button (9) for more than 2 By pressing VOL button (11) or VOL seconds, the button is operated to (12), it is p
ページ8に含まれる内容の要旨
OPERATION display. If you select beep sound on, pressing button (17) to select whenever press any button, beep Frequency Priority. sound output. Pressing DISP button (1) while in Frequency Priority will temporarily display clock. • LOUDNESS Press LOUD (DIM) button (15) shortly to reinforce the bass output and display • SELECTABLE CLOCK DISPLAY will show “LOUD”. Press it again to Programs the unit to display the clock release this function. (selectable on/off) when the unit is turned off. While
ページ9に含まれる内容の要旨
OPERATION • STATION STORING RADIO OPERATION Press any one of the preset buttons (14) (M1 to M6) (i.e.19~24) to select a • BAND SELECTION station which had been stored in the At tuner mode, press BAND button memory. Press this button for several (18) shortly to select the desired band. seconds, current station is stored into The reception band will change in the the number button. following order: FM1 FM2 FM3 AM1/MW1 • SCAN AM2/MW2 Press SCAN button (13) to scan through strong stations in the cur
ページ10に含まれる内容の要旨
OPERATION select track 6, then press MEM CD OPERATION button (20) to memorize it and “P- 02” will appear on the display. So • SELECT TRACKS track 6 will be played first. Thus, Press button (16) or button (17) to you can also press / buttons (17) move to the previous track or the and (16) to choose track number 10 following track. Track number shows and press MEM button, then “P- on display. 03” will appear. So track 10 will be Hold press button (16) or button secondly played. Repeat these (1
ページ11に含まれる内容の要旨
OPERATION CD CHANGER OPERATION Note: • SELECT TRACKS A. Notes on discs: Press button (16) or button (17) to 1. Attempting to use non-standard shape move to the previous track or the discs (e.g. square, start, heart) may following track. Track number shows damage the unit. Be sure to use round on display. shape CD discs only for this unit. Hold press button (16) or button 2. Do not stick paper or tape, etc, onto (17) to fast reverse or fast forward. Disc the label side or the recording side o
ページ12に含まれる内容の要旨
SPECIFICATION GENERAL Power Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 178 (W) x 178 (D) x 50 (H) mm Tone Controls - Bass (at 100 Hz) : ± 10 dB - Treble (at 10 KHz) : ± 10 dB Maximum Output Power : 4 x 40 Watts Current Drain : 15 Ampere (max.) CD PLAYER Signal to Noise Ratio : More than 55 dB Channel Separation : More than 50 dB Frequency Response : 40 Hz - 18 KHz RADIO FM Frequency Coverage : 87.5 to 107.9 MHz IF : 10.7 MHz Sensitivity (S/N = 30 dB) : 3 µ V Stereo S
ページ13に含まれる内容の要旨
TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Symptom Cause Solution No power. The car ignition switch is If the power supply is properly not on. connected to the car accessory circuits, but the engine is not moving, switch the ignition key to “ACC”. The fuse is blown. Replace the fuse. Disc cannot be Presence of CD disc inside Remove the disc in the player, load
ページ14に含まれる内容の要旨
www.pyleaudio.com 88-C1802-xx
