PYLE Audio View Series PLVWR5600の取扱説明書

ページ1に含まれる内容の要旨

PLVWR5600
OWNER’S MANUAL
FLIP DOWN TFT MONITOR

ページ2に含まれる内容の要旨

INSTALLATION Desk-top Installation Mounting Bolts (M3x6) 2 1 Tapping Screw (M4x10) Bracket Levers Fig. 1 1. Determine the mounting location and drill four mounting holes. 2. Attach the bracket to the holes with the tapping screws (M4x10). 3. Let the two levers aim at the fixing holes on the bottom of the base to fix the display unit. 4. Attach the TV unit to the preferred location with the mounting bolts (M3x6). 5. For the convenience of fixing the unit, you can turn the display left or right to

ページ3に含まれる内容の要旨

INSTALLATION Ceiling-on Installation Bracket Levers Tapping Screws (M4x10) Fixing holes Mounting Bolts (M3x6) Fig. 2 1. Determine the mounting location and drill four mounting holes. 2. Attach the bracket to the holes with the tapping screws (M4x10). 3. Let the two levers aim at the fixing holes to fix the display unit. 4. Attach the unit to the bracket with the mounting bolts (M3x6). 5. When the installation has completed, you can also turn the display upward or downward, left or right to adju

ページ4に含まれる内容の要旨

REPLACING THE CAR DOME LAMP Follow the directions show below for a new lamp changing. 1. Position light switch to “ ”. 2. Push back the lamp cover and open it. (Refer to the following figure) 3. Remove and discard the old lamp. 4. Install a new bulb. 5. Close the cover. Lamp Cover Bulb Light Switch Bulb Specification Diameter: ø8mm Length: 28mm Voltage Spec.: DC12V, 5W CAR DOME LAMP WIRING Line for Car Dome Lamp Note: Color Connection Red Power Supply White Interior Lig

ページ5に含まれる内容の要旨

CONTROL & FUNCTION KEYS 1 2 4 5 6 7 8 9 3 11 11 12 12 13 14 18 15 16 19 17 5

ページ6に含まれる内容の要旨

CONTROL & FUNCTION KEYS 10 5.6 INCH TFT COLOR MONITOR 6

ページ7に含まれる内容の要旨

MONITOR 1. (=POWER) Press button (1) to turn on the unit. Press it again to turn it off. 2. POWER INDICATOR LIGHT When the system is on, the indicator light (2) will be illuminated. 3. CAR DOME LAMP The car dome lamp (3) will be on in some needed situations. 4. LIGHT SWITCH The are three seetings for the car dome lamp operation: (OFF), (AUTO), and (ON), refer to light switch (4). A. : To turn off the lamp. B. : To make the lamp turned on only when car doors are opened. C. :

ページ8に含まれる内容の要旨

13. PUSH (Monitor Release Button) Opening the Monitor Press the PUSH button (13) to eject the screen display from the base at a little angle. Then you can easily turn the display upward or downward for good viewing. The monitor also can be adjusted through 30 degree both left and right from the central viewing position Closing the Monitor Return the monitor to the central viewing position. Then push the monitor back into the monitor base unit until the screen engages with PUSH button (13) .