ページ1に含まれる内容の要旨
Contents
Before using
Important Safety Instructions........... 2
CD Receiver
Precautions ....................................... 3
Features ............................................ 4
Supplied accessories ........................ 5
Before operating this unit ................ 5
CR-305FX
Preparation
Audio equipment connections ......... 6
Connecting speaker systems ............ 8
Connecting the AC power cord
Instruction Manual
(mains lead) .................................... 9
Making antenna c
ページ2に含まれる内容の要旨
WARNING: WARNING AVIS RISK OF ELECTRIC SHOCK RISQUE DE CHOC ELECTRIQUE TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT OPEN NE PAS OUVRIR DO NOT EXPOSE THIS APPARATUS TO RAIN OR The lightning flash with arrowhead symbol, within an MOISTURE. equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s CAUTION: enclosure that may be of sufficient magnitude to constitute a TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT risk of
ページ3に含まれる内容の要旨
Precautions 8. Moisture Condensation 1. Recording Copyright—Unless it's for personal use only, record- Moisture condensation may damage this unit. ing copyrighted material is illegal without the permission of the Read the following carefully: copyright holder. Moisture may condense on the lens of the optical pickup, one of 2. AC Fuse—The AC fuse inside the unit is not user-serviceable. If the most important parts inside this unit. you cannot turn on the unit, contact your Onkyo dealer. • Moistur
ページ4に含まれる内容の要旨
Features Precautions This unit contains a semiconductor laser system and is classified as ■ 2 × 20 watts min RMS at 4 ohms, 1 kHz no more than a "CLASS 1 LASER PRODUCT". So, to use this model properly, 1.0 % THD (FTC rating) read this Instruction Manual carefully. In case of any trouble, please ■ 2 × 20 watts at 4 ohms, 1 kHz, DIN contact the store where you purchased the unit. ■ 2 × 25 watts at 4 ohms, EIAJ To prevent being exposed to the laser beam, do not try to open the ■ 4-Ohm Drive capabil
ページ5に含まれる内容の要旨
LL 2 3 1 5 6 4 A. R NC 8 9 7 E MUTING L T TIMER R S STANDBY/ ON C CA LO LL CK 1 2 3 INPUT 4 5 6 A.PRESENCE 7 8 9 +10 CLEAR 0 MUTING MEM RANDOM SLEEP REPEAT CD TUNER TIMER PRESET TAPE ENTER RC-617S STANDBY/ ON CLOCK CA INPUT P ESE E +10 CL AR 0 MEM RANDOM S EEP REPEA CD TUNER PRESET TAPE ENTER C-617 Supplied accessories Check that the following accessories are supplied with this unit. Remote controller (RC-617S) × 1 AM loop antenna × 1 FM indoor antenna × 1 Batteries (AAA/R03) × 2 Before operatin
ページ6に含まれる内容の要旨
Audio equipment connections • Do not connect the AC power cord (mains lead) to the wall outlet (the mains) until you have completed all the other connections including the connections on page 7, and the speaker connections on page 8. • On each pair of connectors, a red connector (marked R) corresponds to the right channel, and a white connector (marked L) to the left channel. Connect white plugs of audio connection cables to L connectors and connect red plugs of audio connection cables to R con
ページ7に含まれる内容の要旨
Audio equipment connections Connecting the remote control cables If your other components are made by ONKYO and those components are equipped with connectors, you can control the - connected components with the supplied remote controller. • The unit must be connected in the system hookups for control operations. • Each component has two connectors except for this unit. There is no difference between these connectors. • The components may be connected in any order. • The hookups on the previ
ページ8に含まれる内容の要旨
Connecting speaker systems Connecting left and right speakers • The load impedance of each speaker must be at least 4 ohms. • Do not use unnecessarily long or extremely thin speaker cords. Otherwise, the DC resistance of the speaker cords may become too high, lowering the damping factor and causing the sound quality to deteriorate. • Do not connect the speaker cord to the L and R connectors at the same time and do not connect two or more speakers to the same speaker connectors. NO NO SPEAKERS SP
ページ9に含まれる内容の要旨
M I N E M U Connecting speaker systems Connecting a sub-woofer SPEAKERS REMOTE RL CONTROL FM 75 ANTENNA AM R L TAPE OUT (REC) DIGITAL OPTICAL (PLAY) OUTPUT IN Active sub-woofer OUT ( ) REC (PLAY) SUBWOOFER IN PRE OUT CDR RL • The SUBWOOFER PRE OUT jack supplies the left and right mixed monaural signals to the sub-woofer. Connecting the AC power cord (mains lead) Connecting the AC power cord (mains lead) 2. STANDBY/ON 1. Connect the AC power cord (mains lead) to the wall outlet (the mains). “– –:
ページ10に含まれる内容の要旨
Making antenna connections Assembling the AM loop antenna Assemble the loop antenna as shown in the illustration. Insert into the hole. Connecting the antenna cable 12 3 1. Press down the lever. 2. Insert the wire into the hole. 3. Release the lever to replace it. Connecting the included antennas Connecting the FM indoor antenna The FM indoor antenna is for indoor use only. Extend the antenna and move it in various directions until the clearest signal is received. Fix it with push pins or simila
ページ11に含まれる内容の要旨
Making antenna connections Connecting an FM outdoor antenna Please make sure that you follow the considerations below regard- ing the location. Keep the antenna away from noise sources (neon signs, busy roads, etc.). It is dangerous to put the antenna close to power lines. Keep it well FM 75 away from power lines, transformers, etc. ANTENNA AM • To avoid the risk of lightning and electrical shock, grounding is necessary. FM 75 ANTENNA AM Connecting an AM outdoor antenna The outdoor antenna will
ページ12に含まれる内容の要旨
M I N E M U Control positions and names 12 3 4 5 6 78 9 TUNING/PRESET STANDBY/ON MEMORY FM MODE DISPLAY INPUT CLEAR PHONES 15 14 13 12 11 10 ab c de f g h i j k l TIMER TRACK AUTO MONO AM PM RDS Display ST STEREO CD W.DAY MUTING MIN W.END MEMORY kHz S.BASS REC REPEAT MHz DIRECT SLEEP RANDOM s r q p o n m Front panel Display For more information about buttons or knobs, refer to the pages listed If a protective film on the surface of the screen making it difficult to in the brackets ( [ ] ) belo
ページ13に含まれる内容の要旨
Remote controller RC-617S For more information about buttons or knobs, refer to the pages listed in the brackets ( [ ] ) below. 1. STANDBY/ON button [9] Toggles between STANDBY and ON. 2. Number buttons [18, 24] Used to select CD tracks or desired preset station. CLOCK STANDBY/ ON 1 CALL 7 3. SLEEP button [31] Enables you to make the sleep time setting. 2 3 1 4. VOLUME (UP)/ (DOWN) buttons [16, 17] INPUT 8 5 6 Enables you to increase or decrease the volume level. 4 2 5. TUNER PRESET buttons [
ページ14に含まれる内容の要旨
Setting the clock CLOCK STANDBY/ ON CALL 2 3 1 INPUT 5 6 4 A.PRESENCE 8 9 7 +10 CLEAR MUTING 0 MEM RANDOM SLEEP REPEAT CD TUNER TIMER TIMER PRESET TAPE ENTER ENTER Setting the clock 1 TIMER 1. Press the TIMER button until “ADJUST” is selected on the display, then press the ENTER button. The day of the week will flash on the display. 2. Press the buttons until the desired day of the week is selected, then press the ENTER button. ENTER The time will flash on the display. 3. Use the buttons to se
ページ15に含まれる内容の要旨
Setting the clock CLOCK STANDBY/ ON CALL CLOCK CALL 2 3 1 INPUT 5 6 4 A.PRESENCE 8 9 7 + CLEAR 10 0 MUTING MEM RANDOM SLEEP REPEAT CD TUNER TIMER TIMER PRESET TAPE ENTER ENTER Switching between the 24 hour and 12 hour 1 display settings TIMER 1. Press the TIMER button repeatedly to display “24H/12H.” 2. Press the ENTER button. “24H” or “12H” flashes on the display. 3. Use the buttons to select 24H (24 hour display) or 12H (12 hour display). 4. Press the ENTER button to confirm the setting. 2 EN
ページ16に含まれる内容の要旨
M M I I E N E N M M U U Choosing the required source CLOCK STANDBY/ ON CALL 2 3 1 VOLUME INPUT 5 6 INPUT 4 A.PRESENCE 8 9 7 A. PRESENCE +10 CLEAR 0 MUTING MEM RANDOM SLEEP REPEAT TUNING/PRESET STANDBY/ON MEMORY FM MODE DISPLAY INPUT VOLUME CLEAR / CD PHONES TUNER TIMER PRESET TAPE INPUT ACOUSTIC Indicator ENTER PRESENCE Choosing the required source Remote controller 1 INPUT 1. Press the INPUT buttons or the INPUT buttons on INPUT the remote controller to select the desired source. Each time
ページ17に含まれる内容の要旨
M I N E M U Muting / Listening with the headphones CLOCK STANDBY/ ON CALL 2 3 1 INPUT 5 6 4 A.PRESENCE 8 9 7 +10 CLEAR 0 MUTING MUTING MEM RANDOM SLEEP REPEAT TUNING/PRESET STANDBY/ON MEMORY FM MODE DISPLAY INPUT VOLUME CLEAR / PHONES CD TUNER TIMER PRESET TAPE PHONES ENTER Muting the sound Press the MUTING button on the remote controller to mute the sound. The MUTING indicator flashes on the display. To restore the sound, press the MUTING button again. MUTING Tip MUTING During muting, • if you
ページ18に含まれる内容の要旨
M I N E M U Playing a CD CLOCK STANDBY/ ON CALL 2 3 , 1 INPUT 5 6 INPUT 4 A.PRESENCE 8 9 7 CLEAR +10 0 MUTING MEM RANDOM SLEEP REPEAT TUNING/PRESET STANDBY/ON MEMORY FM MODE DISPLAY INPUT CLEAR , CD PHONES TUNER TIMER PRESET TAPE INPUT ENTER Playing a CD 1 Label side 1. Press the button to open the disc tray, and put the CD in the tray with the label side facing up. Put 8-cm discs within the center circle of the tray. To close the disc tray, press the button. 2. Press the INPUT buttons or
ページ19に含まれる内容の要旨
M I N E M U Playing a CD STANDBY/ ON CLOCK CALL 2 3 , 1 INPUT 5 6 4 Number A.PRESENCE 8 9 7 buttons + CLEAR 10 0 MUTING MEM RANDOM RANDOM SLEEP REPEAT REPEAT TUNING/PRESET STANDBY/ON MEMORY FM MODE DISPLAY INPUT CLEAR , CD PHONES TUNER TIMER PRESET TAPE ENTER Tracks can also be selected by using the number buttons Examples: (remote controller only). • Use buttons 1 to 9 to select tracks 1 to 9. Use button 0 to select To select track 5: press 5 track 10. To select track 11 and upwords, press the
ページ20に含まれる内容の要旨
M I N E M U Playing a CD CLOCK STANDBY/ ON CALL 2 3 1 , INPUT 5 6 4 DISPLAY A.PRESENCE 8 9 7 +10 CLEAR CLEAR MUTING 0 MEM RANDOM MEM SLEEP REPEAT TUNING/PRESET STANDBY/ON MEMORY FM MODE DISPLAY INPUT CLEAR , CD PHONES TUNER TIMER PRESET TAPE MEMORY ENTER MEMORY playback Remote controller 1 MEMORY FM MODE You can select and store track numbers (up to 20) in the desired MEM playback order. CLEAR 1. Press the MEMORY button while the CD is stopped. 2. Press the , buttons to select the first track T
