ページ1に含まれる内容の要旨
Contents
Introduction 2
CD Receiver
Connections 11
CR-505DAB
Instruction Manual
Getting Started 16
CD/MP3 Playback 20
DAB 24
FM/AM 28
Thank you for purchasing an Onkyo CD Receiver.
Please read this manual thoroughly before making
Using Other Functions 31
connections and turning on the power.
Following the instructions in this manual will enable
you to obtain optimum performance and listening
enjoyment from your new CD Receiver.
Please retain this manual for future reference.
Appendix
ページ2に含まれる内容の要旨
WARNING: WARNING AVIS RISK OF ELECTRIC SHOCK RISQUE DE CHOC ELECTRIQUE TO REDUCE THE RISK OF FIRE OR ELECTRIC DO NOT OPEN NE PAS OUVRIR SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within CAUTION: the product’s enclosure that may be of sufficient TO REDUCE THE RISK OF ELECTRIC SHOCK, magnitude to constitute a risk of el
ページ3に含まれる内容の要旨
Precautions 1. Recording Copyright 7. Moisture Condensation Unless it’s for personal use only, recording copyrighted Moisture condensation may damage this unit. material is illegal without the permission of the copy- Read the following carefully: right holder. When you take a glass containing a cold drink outside 2. AC Fuse on a summer’s day, drops of water, called condensation, The AC fuse inside the CR-505DAB is not user-service- form on the outside of the glass. Si
ページ4に含まれる内容の要旨
Precautions—Continued Declaration of Conformity This unit contains a semiconductor laser system and is classified as a “CLASS 1 LASER PRODUCT.” So, to We, ONKYO EUROPE use this model properly, read this Instruction Manual ELECTRONICS GmbH LIEGNITZERSTRASSE 6, carefully. In case of any trouble, please contact the store 82194 GROEBENZELL, where you purchased the unit. To prevent exposure to GERMANY the laser beam, do not try to open the enclosure. declare in own responsibility, that
ページ5に含まれる内容の要旨
Table of Contents Introduction DAB Important Safety Instructions ................ 2 Using DAB ............................................. 24 Using DAB.................................................... 24 Precautions ............................................. 3 Ensemble Search Mode............................... 24 Features ................................................... 6 Component Search Mode ............................ 25 Supplied Accessories............................. 6 Sorti
ページ6に含まれる内容の要旨
R 581S C- Features Tuner Amp DAB Tuning 25W/Ch into 6 ohms (1 kHz, 10%) 59 Presets for DAB High Current, Low Impedance Drive 40 Presets for AM and FM Discrete Output Stage Circuitry Automatic FM Scan Tuning Tone Control for Treble and Bass RDS (CT/PS/RT) Tone Direct 3 Audio Inputs and 2 Outputs for TAPE, MD, LINE Others Optical Digital Output Aluminum Volume Knob & Front Panel -Compatible Remote Control CD Player 5-Mode
ページ7に含まれる内容の要旨
RC-581S Before Using the CR-505DAB Installing the Remote Controller Using the Remote Controller Batteries To use the remote controller, point it at the CR-505DAB’s remote control sensor, as shown below. 1 Open the battery compartment, as shown. CR-505DAB Remote control sensor 5 m 2 Insert the two supplied batteries (AAA/ R03) in accordance with the polarity dia- gram inside the battery compartment. Notes: • The remote controller may not work reliably if the CR- 505DAB is subject
ページ8に含まれる内容の要旨
Controls & Connectors Front Panel For detailed information, refer to the pages in parentheses. Disc Tray Display 1 2 3 4 VOLUME MIN MAX PRESET STANDBY / ON BASS TREBLE PHONES INPUT MENU DIRECT PUSH TO ENTER 5 6 789 0 A B C 1 Remote control sensor (7) 8 MENU button (22-30) Receives control signals from the remote controller. Displays the Tuner menu. Selects the play mode for CD or MP3. 2 Standby indicator (16) Lights up when the CR-505DAB is in Standby mo
ページ9に含まれる内容の要旨
Controls & Connectors—Continued Rear Panel For detailed information, refer to the pages in parentheses. 12 34 5 6 7 SPEAKERS RL SUB OPTICAL WOOFER DIGITAL REMOTE DAB FM75 PRE OUT OUT CONTROL AM ANTENNA L IN IN IN R TAPE MD LINE L OUT OUT R 8 90 1 REMOTE CONTROL (15) 6 SUBWOOFER PRE OUT (11) This (Remote Interactive) connector can be con- This RCA/phono connector can be used to connect an nected to the connector on another Onkyo compo- active subwoofer. nent. To use , you must make an analog
ページ10に含まれる内容の要旨
Controls & Connectors—Continued A CLOCK CALL button— Used to display the current Remote Controller time. B TIMER button— Used to set the timers. C Up [ ] & Down [ ] buttons— Used to set the tim- ers. CLOCK STANDBY/ ON CALL D CLEAR button— Used with memory playback. 2 3 TIMER 1 E ENTER button— Used to set the timers. 5 6 F MODE button— Used to set Random Play or Mem- 4 ory Play. 8 9 7 G REPEAT button— Used with repeat playback. --/--- CLEAR 10/0 ENTER H INPUT [ ] [ ] selector buttons— Used to se
ページ11に含まれる内容の要旨
Connecting Your Speakers Before you connect your speakers, read the following: Connecting the Speaker Cords to • Disconnect the power cord from the wall outlet. the Speaker Connectors • Read the instructions supplied with your speakers. • Pay close attention to speaker wiring polarity. In other 1 Strip 10 mm from the words, connect positive (+) terminals only to positive (+) end of each cord. terminals, and negative (–) terminals only to negative (–) 10 mm (7/16“) terminals. If you get them
ページ12に含まれる内容の要旨
Connecting an Antenna This chapter explains how to connect the supplied indoor Connecting the AM Loop Antenna FM antenna, AM loop antenna, and DAB antenna and how to connect commercially available outdoor FM and AM The supplied indoor AM loop antenna is for indoor use only. antennas. The CD Receiver won’t pick up any radio signals without 1 Assemble the AM loop antenna, inserting any antenna connected, so you must connect an antenna to the tabs into the base, as shown. use the tuner. DAB an
ページ13に含まれる内容の要旨
Connecting an Antenna—Continued Connecting an Outdoor FM Antenna Connecting an Outdoor AM Antenna If you cannot achieve good reception with the supplied If good reception cannot be achieved using the supplied AM indoor FM antenna, try using a commercially available out- loop antenna, an outdoor AM antenna can be used in addi- door FM antenna instead. tion to the loop antenna, as shown. Outdoor antenna Insulated antenna cable AM loop antenna FM75 ANTENNA AM Notes: Outdoor AM antennas work best w
ページ14に含まれる内容の要旨
Connecting Your Other Components to the CR-505DAB RCA Connection Color Coding Before Making Any Connections RCA-type connections are usually color coded: red and • Read the manuals supplied with your components. white. Use red plugs to connect right-channel audio inputs • Don’t connect the power cord until you’ve completed and and outputs (typically labeled “R”). Use white plugs to con- double-checked all connections. nect left-channel audio inputs and outputs (typically labeled “L”). Optica
ページ15に含まれる内容の要旨
Connecting -compatible Components With (Remote Interactive) you can control your - To use , you need to connect the CR-505DAB’s compatible Onkyo cassette tape deck or MD recorder with connector to an connector on the other component by the CR-505DAB’s remote controller, and use the following using an cable. An cable is supplied with each - special functions: compatible Onkyo cassette tape deck and MD recorder. Auto Power On Hookup Example: When you turn on a component connected via w
ページ16に含まれる内容の要旨
Powering Up and Setting the Clock ACCUCLOCK Function VOLUME CLOCK STANDBY/ ON CALL CLOCK CALL 2 3 MIN MAX 1 TIMER TIMER PRESET STANDBY / ON BASS TREBLE PHONES INPUT MENU DIRECT 5 6 4 PUSH TO ENTER 8 9 7 --/--- CLEAR 10/0 ENTER ENTER DISPLAY MODE DISPLAY STANDBY/ON SLEEP REPEAT Standby indicator MUTING INPUT Powering Up the CR-505DAB DAB FM AM DIRECT Before connecting the power cord, complete all connections CD (see pages 11 to 15). The very first time you turn on the CR-505DAB, the ACCUCLOCK fu
ページ17に含まれる内容の要旨
Powering Up and Setting the Clock—Continued Setting ACCUCLOCK to Use a Specific Turning Off ACCUCLOCK If you don’t want ACCUCLOCK to calibrate the clock auto- Station matically at 2 AM, 3 AM and 2 PM everyday, you can turn If the wrong time is displayed, you can specify which FM it off as follows. station the ACCUCLOCK function should use. This must be an FM station that supports RDS CT (Clock Time) infor- mation. 1 Press the [FM] button to select FM. 1 Press the [FM] button to select FM.
ページ18に含まれる内容の要旨
Powering Up and Setting the Clock—Continued 5 Press the [ENTER] button. The time flashes. CLOCK STANDBY/ ON CALL CLOCK CALL 2 3 1 TIMER TIMER 6 Use the Up/Down [ ]/[ ] buttons to set 5 6 4 the time. 9 8 7 -- --- CLEAR / ENTER 10/0 ENTER DISPLAY MODE REPEAT SLEEP MUTING INPUT 7 Press the [ENTER] button to set the clock. DAB FM AM DIRECT “Adjusted” appears on the display. CD MD Displaying the Date & Time Setting the Clock Manually 1 Press the [CLOCK CALL] button. If you cannot set the clock by usi
ページ19に含まれる内容の要旨
Using the CR-505DAB VOLUME control Adjusting the Volume VOLUME 1 To adjust the volume, use the [VOLUME] control, or the remote controller’s VOL- UME [ ]/[ ] buttons. MIN MAX PRESET Turn the [VOLUME] control clockwise to increase the STANDBY / ON BASS TREBLE PHONES INPUT MENU DIRECT volume; counterclockwise to decrease it. PUSH TO ENTER Using Headphones INPUT You can connect a pair of stereo headphones to the CR- 505DAB’s PHONES jack for private listening, as shown. CLOCK STANDBY/ ON CALL 2 3 1
ページ20に含まれる内容の要旨
Playing CDs To Fast Forward or Fast Reverse (remote controller only) During playback or while playback is paused, press and VOLUME hold the [ ] button to fast forward, or the [ ] button to fast reverse. For MP3, fast reverse only works within the MP3 track that MIN MAX is currently playing. PRESET STANDBY / ON BASS TREBLE PHONES INPUT MENU DIRECT If you press the button for more than four seconds, the fast PUSH TO ENTER forward or fast reverse speed increases. To Select Tracks / Stop O
