ページ1に含まれる内容の要旨
INST 8100
KIT COMPONENTS
4
Radio
Housing #1
Fig. A
99-8100
INSTALLATION
INSTRUCTIONS
Fig. B
Radio
Housing #2
APPLICATIONS
2-SHAFT HEAD UNITS: Snap the Faceplate onto the front of the Radio Housing. (For
CAR PAGE
applications using Faceplate #2, cut and remove the bottom portion of the Faceplate). Slide
the aftermarket head unit into the kit and secure with shaft nuts. (see Fig. A)
TOYOTA
Faceplate
4Runner 1984-88...........................................
ページ2に含まれる内容の要旨
TOYOTA Camry 1983-86 ALL VEHICLES 1 2 3 "D" Fig. A "D" Disconnect the negative battery terminal to Fig. B prevent an accidental short circuit. Remove Slide Mounting Tabs #3 into slots "D" on (3) Phillips screws above the climate Bracket Set #2. The Mounting Tabs, controls. Remove (2) Phillips screws from Brackets and Bracket slots can be identified the left side of the dash trim bezel and by the stamped letter on each component. remove the bezel. Remove the screws Skip to the I
ページ3に含まれる内容の要旨
TOYOTA Pickup (double DIN) 1989-91 TOYOTA Celica (GT/GTS) 1986-89 1 2 1 2 "D" "B" Disconnect the negative battery terminal to "B" prevent an accidental short circuit. Remove "H" Disconnect the negative battery terminal to prevent an accidental short circuit. Remove (3) screws and (1) bolt securing the driver's (2) screws from the lower steering column side speaker panel and remove the panel. panel and remove the panel. Remove (2) Slide Mounting Tabs #3 and #8 into slots Remove (1)
ページ4に含まれる内容の要旨
TOYOTA Celica 1990-93 TOYOTA Pickup 1984-88 / 4Runner 1984-88 "J" 1 2 1 2 "A" Disconnect the negative battery terminal to Disconnect the negative battery terminal to "I" prevent an accidental short circuit. Pry up prevent an accidental short circuit. Remove on the gear shifter trim panel and remove the the ashtray and (3) screws from the ashtray panel. Remove (2) screws exposed on the Slide Mounting Tabs #3 into slots "A" on bracket. Remove (1) screw from each side Slide Mounting Tabs
ページ5に含まれる内容の要旨
TOYOTA MR2 1985-86 TOYOTA Corolla 1984-87 "G" 1 2 1 2 Fig. A "C" "F" "G" Fig. B "C" "F" Disconnect the negative battery terminal to prevent an accidental short circuit. Remove 2DR/3DR MODELS: Slide Mounting Tabs Disconnect the negative battery terminal to (2) Phillips screws above the climate #3 into slots "G" on Bracket Set #1. (see Fig. prevent an accidental short circuit. Remove controls. Unclip the lower edge of the radio Slide Mounting Tabs #3 into slots "C" on (2) Phillips sc
ページ6に含まれる内容の要旨
TOYOTA Corolla (sed/wag-upper dash) 1988-93 TOYOTA Landcruiser 1982-87 1 2 1 2 "A" "B" "B" "A" Disconnect the negative battery terminal to Disconnect the negative battery terminal to prevent an accidental short circuit. Remove prevent an accidental short circuit. Remove (4) screws from the top edge of the dash trim (4) Phillips screws securing the factory head bezel. Remove (2) screws below the radio Slide Mounting Tabs #8 into slots "A" on unit and disconnect the wiring. Slide Mounting
