Metra Electronics 99-7009の取扱説明書

ページ1に含まれる内容の要旨

INSTALLATION INSTRUCTIONS FOR PART 99-7009
APPLICATIONS
Mitsubishi Endeavor
2004-2010
99-7009
KIT FEATURES
DIN Head Unit Provisions
ISO DIN Head Unit Provisions
KIT COMPONENTS
A) Radio Housing B) ISO Brackets C) Trim Plate
C
A
B


WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Harness:


Antenna Adapter:



T OOLS REQUIRED:
Phillips Screwdriver Socket Wrench
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2004-2010 METRA ELECTR

ページ2に含まれる内容の要旨

99-7009 Dash - Mitsubishi ---------------------------------- Kit - ISO Head Unit Provision with Pocket ---------------------------- - DIN Head Unit Provision with Pocket ---------------------------- Final Assembly ------------------------------------------------------ Notes ---------------------------------------------------------------- KNOWLEDGE IS POWER Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in

ページ3に含まれる内容の要旨

DY A SH DISA SSEMBL 99-7009 2004-2010 MITSUBISHI ENDEAVOR A Disconnect the negative battery terminal 1 to prevent an accidental short circuit. 2 Unsnap and remove entire panel sur- rounding radio and A/C controls. (Figure A) Remove (1) 10MM nut from the rear support 3 on the top left of radio on cross bar behind B dash. (FIGURE B) 4 Remove (3) Phillips screws to remove factory radio chassis (Figure C) Remove (4) Phillips screws from the pock- 5 C et at the bottom of the radio

ページ4に含まれる内容の要旨

ページ5に含まれる内容の要旨

ページ6に含まれる内容の要旨

ページ7に含まれる内容の要旨

ページ8に含まれる内容の要旨

INST997009 1-800-221-0932 www.metraonline.com Rev. 04-26-10 © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION INST99-7009