ページ1に含まれる内容の要旨
M4100CDUM.qxd 07/24/03 4:29 PM Page 1
Installation and
Operations Manual
AM/FM/CD RECEIVER EJECT
POWER
VOL
DISP
BAND
MUTE
SEL
LOUD/DIM
VOL
OPEN
SHIFT
MODE SCAN 1 2 MEM 3 PGM 4 RPT 5 RDM 6 INT AS/PS ELAPSE
M4100CD
Water-Resistant
AM/FM/WB and CD Stereo Receiver
A Registered Trademark of Magnadyne Corporation
®
ページ2に含まれる内容の要旨
M4100CDUM.qxd 07/24/03 4:29 PM Page 2 Location and Function of Control at a Glance 3 20 19 18 17 16 15 14 AM/FM/CD RECEIVER EJECT POWER 1 VOL DISP BAND 2 MUTE SEL LOUD/DIM VOL OPEN SHIFT MODE SCAN 1 2 MEM 3 PGM 4 RPT 5 RDM 6 INT AS/PS ELAPSE 4 5 6 7 8 9 10 11 12 13 21 22 1. Power Button: Turns the unit On/Off. 2. Audio Control Buttons: Adjusts the Volume, Bass, Treble, Balance and Fader. 3. Multi-Function Buttons: Adjusts the radio frequency, sets the clock, and changes CD tracks. 4. Mode Bu
ページ3に含まれる内容の要旨
M4100CDUM.qxd 07/24/03 4:29 PM Page 3 Location and Function of Control at a Glance 9. Multi-Function Button 4/RPT: Radio: Recalls a memorized radio station, and programs a radio station into memory (See Radio Operation for more information). CD: Enters CD track repeat mode (See CD Operation for more information). 10. Multi-Function Button 5/RDM: Radio: Recalls a memorized radio station, and programs a radio station into memory (See Radio Operation for more information). CD: Plays all tracks
ページ4に含まれる内容の要旨
M4100CDUM.qxd 07/24/03 4:29 PM Page 4 Using the Detachable Front Panel To Detach the Front Panel To Install the Front Panel 1. Press the OPEN button (13), and the front 1. While the panel bracket is in the down posi- panel will slide down to a flat position. tion, insert the front panel. Open Button 2. With the front panel down, press the bottom button of the front panel upward and pull the front panel out from the panel bracket. 2. After the front panel is securely inserted on the panel brac
ページ5に含まれる内容の要旨
M4100CDUM.qxd 07/24/03 4:29 PM Page 5 Radio Operation Listening to the Radio Programming the Radio 1. Press the “BAND” button (17) to select a radio You can program up to 12 FM radio stations and 6 AM band: FM1, FM2, AM or WX (weather band). radio stations. 2. AM or FM Station Selection: Manual Station Recall Programming Automatic Seek Station Selection: Press the 1. Press the “BAND” button (17) to select a radio band: FM1, FM2 or AM. or button (3) to automatically seek the 2. Select the desi
ページ6に含まれる内容の要旨
M4100CDUM.qxd 07/24/03 4:29 PM Page 6 General Operations Setting the Clock Frequency Display Priority 1. Press DISP button (16) for more than 3 seconds Press and hold DISP button while pressing the until the clock shown in the display area is flash- button to select Frequency Priority. ing. Pressing DISP button while in Frequency Priority will temporarily display clock. 2. Press the button (3) to adjust the hours In CD Mode 3. Press the button (3) to adjust the minutes. When the display pri
ページ7に含まれる内容の要旨
M4100CDUM.qxd 07/24/03 4:29 PM Page 7 CD Operation Inserting a Disc Program CD Tracks Push the Open button (13) to open the front Use the Program function to select up to 32 CD panel. Insert a disc into the CD Slot, label side up, tracks to play in any order. The Program function and the disc will begin to play automatically. allows you to select a track number for each spot in the playing sequence. A CD must be inserted to Ejecting a Disc use the Program function. Push the Open button to ope
ページ8に含まれる内容の要旨
M4100CDUM.qxd 07/24/03 4:29 PM Page 8 Installation Procedure Gray Wire with Black Stripe: Connect this wire to the Step 1: The radio chassis is designed to be “Sleeve Right Front Speaker (-) negative terminal or wire. Mounted” through a opening in the dashboard panel. The required opening size is 182mm (7-3/16") x Purple Wire with Black Stripe: Connect this wire to the 84mm (3-5/16"). Cut or enlarged an opening in the Right Rear Speaker (-) negative terminal or wire. dashboard to accommodate
ページ9に含まれる内容の要旨
M4100CDUM.qxd 07/24/03 4:29 PM Page 9 Wiring Diagram M4100CD Antenna Socket Red Right Channel Ignition Audio Line Out Red Wire Switch (+12v in ) Connect to Line Input of Optional Amplifier White Battery Yellow Wire (+12v in) Left Channel Black Wire Ground (B-) Power Antenna Blue Wire (Switched +12v out) Left Right Gray Wire White Wire Front Front Speaker Speaker Gray Wire with Black Stripe White Wire with Black Stripe Left Right Green Wire Violet Wire Rear Rear Speaker Speaker Green Wire wi
ページ10に含まれる内容の要旨
R M4100CDUM.qxd 07/24/03 4:29 PM Page 10 Final Installation Sheet Metal Screw Nut Washer Metal Strap Push Out Mounting Sleeve Tabs Dashboard Mounting Sleeve Release Lever Removing the Unit from Dashboard: Remove the metal strap holding the back of the radio chassis. With the front panel in the down position, insert removal keys into the small slots in the upper part of chassis panel. There is a right and left removal key, R and L are stamped on the keys. Once the keys are inserted, push the
ページ11に含まれる内容の要旨
M4100CDUM.qxd 07/24/03 4:29 PM Page 11 CD Changer Connection CD Changer M4100CD (Optional) Male to Male 8-Pin Din Cable 8-Pin Din Connector (Supplied with CD changer) Wired Remote Connection Wired Remote (Optional) M4100CD Female 8-Pin Male 8-Pin Mini Din Connector Mini Din Connector 11
ページ12に含まれる内容の要旨
M4100CDUM.qxd 07/24/03 4:29 PM Page 12 Specifications GENERAL CD PLAYER AM RADIO Power Supply Signal to Noise Ratio: Frequency Coverage: Requirements: > 55 dB 530 to 1710 kHz DC 12 Volts, Negative Channel Separation: IF: Ground > 50 dB 450 kHz Chassis Dimensions: Frequency Response: Sensitivity (S/N=20dB): 178 mm (W) x 165 (D) x 50 40Hz – 18 kHz 32 dBu (H) Tone Controls: FM RADIO Bass: 100 Hz ±10 dB Frequency Coverage: Treble: 10 kHz ±10 dB 87.5 to 107.9 MHz Maximum Output Power: Sensitivity
