ページ1に含まれる内容の要旨
CD-RECEIVER
KDC-W6537U
KDC-W6537UY
INSTRUCTION MANUAL
© B64-3620-00/00 (EW/E2W)
ページ2に含まれる内容の要旨
Contents Safety precautions 3 Menu system 22 Menu System Notes 4 Security Code Touch Sensor Tone General features 7 Manual Clock Adjustment Power Synchronize Clock Selecting the Source DSI (Disabled System Indicator) Volume Selectable Illumination Attenuator Display Illumination Control Audio Control Dimmer Audio Setup Switching preout Speaker Setting Built-in Amp Setting Switching Display Supreme Setting Subwoofer Output News Bulletin with Timeout Setting Theft Deterrent Faceplate Local Seek TE
ページ3に含まれる内容の要旨
Safety precautions Do Not Load 8 cm (3 in.) CDs in the CD slot 2WARNING If you try to load a 8 cm (3 in.) CD with its adapter into To prevent injury or fire, take the following the unit, the adapter might separate from the CD and precautions: damage the unit. • To prevent a short circuit, never put or leave any metallic objects (such as coins or metal tools) inside About CD players/disc changers connected the unit. to this unit • Do not watch or fix your eyes on the unit’s display Kenwood
ページ4に含まれる内容の要旨
Notes • If you experience problems during installation, Cleaning the Unit consult your Kenwood dealer. If the faceplate of this unit is stained, wipe it with a dry soft cloth such as a silicon cloth. • When you purchase optional accessories, check with If the faceplate is stained badly, wipe the stain off with your Kenwood dealer to make sure that they work a cloth moistened with neutral cleaner, then wipe it with your model and in your area. again with a clean soft dry cloth. • The charac
ページ5に含まれる内容の要旨
About Audio file About USB device • Playable Audio file • Install the USB device in the place where it will not prevent you from driving your vehicle properly. AA C-LC (.m4a), MP3 (.mp3), WMA (.wma), WAV (.wav) • You cannot connect a USB device via a USB hub. • Playable disc media • Take backups of the audio files used with this unit. The files can be erased depending on the operating CD-R/RW/ROM conditions of the USB device. • Playable disc file format We shall have no compensation for
ページ6に含まれる内容の要旨
Notes This Product is not installed by the manufacturer of a Handling CDs vehicle on the production line, nor by the professional • Do not touch the recording surface of the CD. importer of a vehicle into an EU Member State. • Do not stick tape etc. on the CD, or use a CD with tape stuck on it. • Do not use disc type accessories. Information on Disposal of Old Electrical • Clean from the center of the disc and move and Electronic Equipment (applicable for outward. EU countries that have ad
ページ7に含まれる内容の要旨
General features ATT VOL Release button SRC Control knob Clock display LOUD indicator ATT indicator Power ⁄ • This unit automatically turns full power OFF after 20 Turning ON the Power minutes lapses in Standby mode in order to save the Press the [SRC] button. vehicle's battery. The time until full power OFF can be set in (page 28). • When the power is ON, the (page 23) is • When connection of the iPod is recognized, the source displayed as "CODE ON" or "
ページ8に含まれる内容の要旨
General features Attenuator 5 Exit Audio Control mode Press any button. Turning the volume down quickly. Press a button other than the [VOL] knob and [ATT] Press the [ATT] button. button. Each time you press the button, the Attenuator turns ON and OFF. When the Attenuator is ON, the "ATT" indicator blinks. Audio Setup Setting the Sound system, such as Cross over Network. Audio Control 1 Select the source to adjust Press the [SRC] button. 1 Select the source to adjust Press the [SRC] button.
ページ9に含まれる内容の要旨
In Audio file source Speaker Setting Information Display Fine-tuning so that the System Q value is optimal Music title & Artist name "TITLE" when setting the speaker type. Album name & Artist name "ALBUM" 1 Enter Standby Folder name* "FOLDER" Press the [SRC] button. File name "FILE" Select the "STANDBY" display. Play time & Music number "P-TIME" Clock "CLOCK" 2 Enter Speaker Setting mode Press the [VOL] knob. In Standby/ Auxiliary input source 3 Select the Speaker type Information Display Turn
ページ10に含まれる内容の要旨
General features Subwoofer Output 2 Push the faceplate in until it clicks. The faceplate is locked in place, allowing you to use Turning the Subwoofer output ON or OFF. the unit. Push the Control knob toward down for at least 2 seconds. Each time you push the knob, Subwoofer output switches ON and OFF. When it is ON, "SW ON" is displayed. Theft Deterrent Faceplate The faceplate of the unit can be detached and taken TEL Mute with you, helping to deter theft. The audio system automatically mut
ページ11に含まれる内容の要旨
Tuner features AME FM AM 1 - 6 SRC Control knob Band display Frequency display ST indicator Preset station number Tuning Selecting the station. 1 Select tuner source Press the [SRC] button. Select the "TUNER" display. 2 Select the band Push the Control knob towards [FM] or [AM]. Each time you push the knob toward [FM], it switches between the FM1, FM2, and FM3 bands. 3 Tune up or down band Push the Control knob towards [4] or [¢]. ⁄ • During reception of stereo stations the "ST" indicator is O
ページ12に含まれる内容の要旨
Tuner features Function of remote control Auto Memory Entry Direct Access Tuning Putting stations with good reception in the memory automatically. Entering the frequency and tuning. 1 Select the band for Auto Memory Entry 1 Select the band Push the Control knob towards [FM] or [AM]. Press the [FM] or [AM] button. 2 Enter Direct Access Tuning mode 2 Open Auto Memory Entry Press the [DIRECT] button on the remote Press the [AME] button for at least 2 seconds. control. "A-MEMORY" is displayed. "– –
ページ13に含まれる内容の要旨
RDS features TI 1 - 6 SRC Control knob TI indicator RDS indicator PTY indicator Receiving other traffic information stations Traffic Information Push the Control knob towards [4] or [¢]. Changing to traffic information automatically when ⁄ a traffic bulletin starts even when you are not • Traffic information can be switched when it is on the listening to the radio. Tuner Source. However, you cannot switch the Traffic Press the [TI] button. information during reception of the Traffic bulletin
ページ14に含まれる内容の要旨
RDS features PTY (Program Type) ⁄ • Speech and Music include the Program type shown Selecting the Program Type and searching for a below. station. Music: No.12 — 17, 26 — 30 Speech: No.3 — 11, 18 — 25, 31 1 Enter PTY mode • You can put the Program Type in the [1] — [6] button Press the Control knob. memory and for quick recall. Refer to the (page 14). ⁄ • You can change the display language. Refer to
ページ15に含まれる内容の要旨
Changing Language for PTY Function Selecting the Program Type display language. 1 Enter PTY mode Refer to (page 14). 2 Enter Changing Language mode Press the [TI] button. 3 Select the language Push the Control knob towards up or down. Each time you push the knob, the language alternates between the languages shown in the table below. Language Display English "ENGLISH" French "FRENCH" Swedish "SWEDISH" German "GERMAN" 4 Exit Changing Language mode Press the [TI] button. | E
ページ16に含まれる内容の要旨
CD/USB device/Audio file/External disc control features Release button S.MODE SCAN RDM/3/ REP F.SEL M.RDM SRC Control knob A.RDM Track number Play time IN indicator Disc number When a disc is inserted Playing CD & Audio file Press the [SRC] button. Select the "CD" display. When there is no disc inserted 1 Drop open the faceplate Pause and play Press the Release button. Press the Control knob. Each time you press the knob, the audio pauses or 2 Insert a disc. plays. 3 Push the faceplate on the
ページ17に含まれる内容の要旨
Removing the USB device ⁄ • You can eject the disc for 10 minutes after switching off 1 Drop open the faceplate the engine. Press the Release button. 2 Set the remove mode as the USB source Press the [0] button for at least 2 seconds. The 0 indicator blinks. Playing USB (iPod) device 3 Remove the USB device. When the USB device is not connected Connect the USB device Playback of the file contained in the USB device Drive Search starts. Selecting the device inserted in the Multi Card When th
ページ18に含まれる内容の要旨
CD/USB device/Audio file/External disc control features Function of disc changer/ Audio file Playing External Disc Disc Search/Folder/Album Search Playing discs set in the optional accessory disc player connected to this unit. Switching between folders/albums contained in the disc in the disc changer, media, or device being Press the [SRC] button. played now. Select the display for the disc player you want. Display examples: Push the Control knob towards up or down. Display Disc player "CD C
ページ19に含まれる内容の要旨
Track/File/Disc/Folder Repeat Random Play Replaying the music, disc in the Disc changer or Play all the music on the disc or Audio file folder in Audio file folder you are listening to. random order. Press the [REP] button. Press the [RDM] button. Each time you press the button, the Repeat Play Each time you press the button, Random Play turns alternates between the modes shown in the tables ON or OFF. below. When the Random mode is ON, "DISC RDM"/"FOLD RDM"/"RDM ON" is displayed. In CD & Ext
ページ20に含まれる内容の要旨
CD/USB device/Audio file/External disc control features Function of Audio file Function of non-iPod and non-"Music Editor" file All Random Play File Select 1 mode Playing randomly from all of the Audio files Select the target folder by tracing the hierarchical recorded in the media. levels of folders. This is convenient when managing audio files by folder. Press the [A.RDM] button for at least 1 second. When the random mode is ON, "ALL RDM" is 1 Enter Folder Select 1 mode displayed. Press th
