ページ1に含まれる内容の要旨
INSTALLATION INSTRUCTIONS FOR PART 95-5025
APPLICATIONS
FORD Mustang
1987-1993
95-5025
KIT FEATURES
• Double DIN Head Unit Provision
• ISO Stacked Head Unit Provision
KIT COMPONENTS
A) Double DIN Brackets • B) Double DIN Trim plate • C) (4) # 8 X 1” Phillips Screws
C
A
B
WIRING ANDANTENNA CONNECTIONS (Sold Separately)
• 70-1770 - Ford harness - 1985-2004
TOOLS REQUIRED:
• Phillips Screwdriver • Socket Wrench • Rotary Cutting Tool
• Radio Removal Tools (Part # 86-5618)
1-800-221-0932 www.
ページ2に含まれる内容の要旨
95-5025 TABLE OF CONTENTS Dash Disassembly - Ford Mustang 1987-1993 .... ........ ........ ....... ........ ......1 Kit Assembly - Double DIN Head Unit Provision ..... ........ ... ..... ....... .. ......2 - ISO Stacked Head Unit Provision ..... ........ ......... ....... ......2 *Note: Refer also to the instructions included with the aftermarket radio. KNOWLEDGE IS POWER Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics scho
ページ3に含まれる内容の要旨
95-5025 DASH DISASSEMBLY FORD MUSTANG 1987-1993 A 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Using Metra's 86-5618, pull the factory head unit from the dash and disconnect the wiring. (Figure A) 3 Remove two 7/16” hex bolts from inside the dash cavity and remove the radio sub-dash bracket. (See recommended tool list on front cover) Note: The threaded studs from under this bracket will also need to be removed for the aftermarket Double DIN radio to cle
ページ4に含まれる内容の要旨
95-5025 KIT ASSEMBLY DOUBLE DIN HEAD UNIT PROVISION/ ISO STACKED HEAD UNIT PROVISION A 1 Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter from Metra or AXXESS. Re-connect the negative battery terminal and test the unit for proper operation. 2 Attach the Double DIN brackets to the Double DIN radio or stacked ISO head units using the screws supplied with the radio. (Figure A) B 3 Mount the head unit/ kit assembly to the dash using the four supplied #