ページ1に含まれる内容の要旨
Radio CD
Kiel CD36 7 646 050 510
Malaga CD36 7 646 065 510
Operating instructions
http://www.blaupunkt.com
01Kiel_MalagaCD36 d 1 15.02.2006, 11:52 Uhr
ページ2に含まれる内容の要旨
2 4 1 3 5 6 9 8 11 10 7 2 01Kiel_MalagaCD36 d 2 15.02.2006, 11:52 Uhr
ページ3に含まれる内容の要旨
CONTROLS 1 Button to switch the device on/ ; BND•TS button off and operate the volume Short press: Select the FM mute function. memory banks and the MW and LW wavebands (MW/LW 2 SRC button only on the Malaga CD36). Short press: Switch sources be- Long press: Start the Travel- tween CD, CD changer (if con- store function. nected) and AUX. Long press: Briefly display the clock time. 3 button to eject a CD from the device. 4 Volume control 5 CD compartment 6 TRAF RDS button Short press: Switch tra
ページ4に含まれる内容の要旨
CONTENTS Traffic announcements in Notes and accessories ......... 27 CD mode ..................................... 38 Switching on/off ................... 28 Ejecting a CD .............................. 39 Adjusting the volume............ 29 CD-changer mode ................ 39 Setting the power-on volume ........ 29 Switching to CD-changer mode ... 39 Quick volume reduction (mute) .... 30 Selecting CDs ............................. 39 Switching the confirmation beep Selecting tracks ............
ページ5に含まれる内容の要旨
NOTES AND ACCESSORIES Notes and accessories Road safety Road safety has absolute pri- Thank you for choosing a Blaupunkt ority. Only operate your car sound product. We hope you enjoy using this system if the road and traffic condi- new piece of equipment. tions allow you to do so. Familiar- Please read these operating instruc- ise yourself with the device before tions before using the equipment for setting off on your journey. the first time. You must always be able to hear The Blaupunkt editor
ページ6に含まれる内容の要旨
ACCESSORIES SWITCHING ON/OFF Amplifiers Switching on/off You can use all Blaupunkt and Veloci- You can switch the device on/off in the ty amplifiers. following ways: CD changers Switching on/off using the vehicle You can connect the following Blau- ignition punkt CD changers: If the device is correctly connected to CDC A 08, IDC A 09 and CDC A 03. the vehicle’s ignition and it was not switched off using button 1, it will switch on/off simultaneously with the ignition. Switching on/off using butt
ページ7に含まれる内容の要旨
SWITCHING ON/OFF ADJUSTING THE VOLUME Note: Adjusting the volume If the vehicle ignition was switched You can adjust the volume in steps off before you inserted the CD, from 0 (off) to 66 (maximum). you will first have to switch on the To increase the volume, device by pressing button 1 in order to start playing the CD. ➮ turn the volume control 4 clock- wise. To decrease the volume, ➮ turn the volume control 4 anti- clockwise. Setting the power-on volume Note: The device is equipped with a
ページ8に含まれる内容の要旨
ADJUSTING THE VOLUME Note: Switching the confirmation To protect your hearing, the pow- beep on/off er-on volume is limited to a value The system will play a confirmation of “38”. If the volume level was beep for some functions if you keep a higher than this when the device button pressed down for longer than was last switched off and the two seconds, for instance, when you “LAST VOL” setting is activated, assign a radio station to a station but- the system will reset the volume to ton. You ca
ページ9に含まれる内容の要旨
RADIO MODE Radio mode Switching to radio mode If you are in CD, CD-changer or AUX This device is equipped with an RDS mode, radio receiver. Many of the receivable FM stations broadcast a signal that not ➮ press the BND•TS button ; only carries the programme but also or additional information such as the sta- ➮ press the SRC button 2 re- tion name and programme type (PTY). peatedly until the memory bank The station name appears in the dis- (e.g. “FM1”) appears in the display. play as soon as the
ページ10に含まれる内容の要旨
RADIO MODE Switching REGIONAL on/off Tuning into stations manually ➮ Press the MENU button 8. You can also tune into stations manu- ally. ➮ Press the or button 7 re- peatedly until “REG” appears in Note: the display. “OFF” or “ON” is dis- You can only tune into stations played alongside “REG”. manually if the RDS function is ➮ To switch REGIONAL on/off, press deactivated. the or button 7. ➮ Press the or button 7. ➮ Press the MENU button 8. Browsing through broadcasting Selecting the wave
ページ11に含まれる内容の要旨
RADIO MODE ➮ Press the or button 7 re- Note: peatedly until “SENS” and the cur- Any stations previously stored in rently set value appear in the dis- this memory bank are deleted in play. the process. “SENS HI6” means that the tuner is set ➮ Press and hold down the BND•TS to the highest sensitivity setting. “SENS button ; for longer than two sec- LO1” means it is set to the lowest sen- onds. sitivity setting. The storing procedure begins. “FM ➮ Set the desired sensitivity using TSTORE” appea
ページ12に含まれる内容の要旨
RADIO MODE Cancelling SCAN and continuing PTY-EON listening to a station If you specify the programme type and start seek tuning, the radio will switch ➮ Press the MENU button 8. from the current station to a station of Scanning stops and the radio contin- the selected programme type. ues playing the station that it tuned into last. Note: If the tuner does not find a station Setting the scanning time that matches the selected pro- ➮ Press the MENU button 8. gramme type, you will hear a beep an
ページ13に含まれる内容の要旨
RADIO MODE Selecting the PTY language FM). If interference occurs, the inter- ference level is cut automatically. You can select the language in which the programme types are displayed. Switching HICUT on/off The following are available: ➮ Press the MENU button 8. “DEUTSCH”, “ENGLISH” and ➮ Press the or button 7 re- “FRANÇAIS”. peatedly until “HICUT” appears in ➮ Press the MENU button 8. the display. ➮ Press the or button 7 re- ➮ Press the or button 7 to ad- peatedly until “PTY LANG” ap- j
ページ14に含まれる内容の要旨
TRAFFIC INFORMATION if you retune the radio from a traf- Traffic information fic information station to a station Your device is equipped with an RDS- that does not broadcast traffic in- EON receiver. EON stands for En- formation. hanced Other Network. If you hear the warning beep, you can Whenever a traffic announcement (TA) either switch off traffic information pri- is broadcast, the system switches au- ority or tune into a station that broad- tomatically from a station that does not casts t
ページ15に含まれる内容の要旨
CD MODE If there is already a CD inserted in the CD mode drive, You can use this device to play stand- ➮ press the SRC button 2 re- ard audio CDs, CD-Rs and CD-RWs peatedly until “CD” appears in the with a diameter of 12 or 8 cm. display. Risk of severe damage to the Playback begins from the point at CD drive! which it was last interrupted. Contoured CDs (shape CDs) are not suitable for playback in this unit. Selecting tracks We do not accept responsibility for ➮ Press one of the arrow buttons
ページ16に含まれる内容の要旨
CD MODE Cancelling MIX “RPT OFF” appears briefly in the dis- play and the RPT symbol disappears. ➮ Press the 5 MIX button : again. Normal playback is then resumed. “MIX OFF” appears briefly in the dis- Pausing playback (PAUSE) play and the MIX symbol disappears. ➮ Press button 3 :. Scanning tracks (SCAN) “PAUSE” appears in the display. You can scan (briefly play) all the tracks on the CD. Cancelling pause ➮ Press and hold down the MENU ➮ Press button 3 : whilst pause button 8 for longer than t
ページ17に含まれる内容の要旨
CD MODE CD-CHANGER MODE Ejecting a CD CD-changer mode ➮ Press the eject button 3 next to Note: the CD compartment. Information on handling CDs, in- serting CDs and operating the CD The CD is ejected. changer can be found in the oper- ➮ Remove the CD. ating instructions supplied with Note: your CD changer. If a CD is ejected, the drive will Switching to CD-changer mode automatically draw it back in again after approx. 10 seconds. ➮ Press the SRC button 2 re- peatedly until “CHANGER” ap- Yo
ページ18に含まれる内容の要旨
CD-CHANGER MODE Cancelling REPEAT Configuring the display To stop the current track or current CD There are five display options availa- from being repeated, ble for CD-changer mode: Track number and playing time ➮ briefly press the 4 RPT button :. (“TRCK-TIME”) “RPT OFF” appears and RPT disap- Track number and clock time pears from the display. (“TRCK-CLK”) Random track play (MIX) CD number and track number To play the tracks on the current CD in (“CD-TRCK”) random order, CD number and
ページ19に含まれる内容の要旨
CD-CHANGER MODE CLOCK TIME Cancelling SCAN CLOCK time To stop scanning, Displaying the clock time ➮ briefly press the MENU button 8. To display the clock time briefly, The currently scanned track will then ➮ Press and hold down the SRC continue to be played normally. button 2 until the clock time ap- Note: pears in the display. You can set the scanning time. Setting the clock time For further details, please read the section entitled “Setting the scan- To set the clock time, ning time” in the
ページ20に含まれる内容の要旨
CLOCK TIME SOUND When you have finished adjusting the Sound setting, You can adjust the sound settings ➮ press the MENU button 8. (bass and treble) separately for each source (radio, CD and CD changer / Displaying the time AUX). continuously when the device is The volume distribution settings (bal- off and the ignition is on ance and fader) apply to all the audio To display the time when the device is sources (except for traffic announce- off and the vehicle ignition is on, ments). ➮ press the M
