ページ1に含まれる内容の要旨
MP6512i
Installation and Operation Manual
MP6512i
Loudness
TUNE / TRACK
/
EQ PTY
RADIO
READY
CH/CAT
S S SA A AT T T SCAN AS
MENU/ENTER-PRESS
iPod
LOUD LO/DX
3
1 2 INT RPT 4 RDM 5 DN 6 UP
Menu
Watts Peak
Watts en Crête
Vatios el Máximo
60W x 4
240
D
N
A
B
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
MP6512i TABLE OF CONTENTS Introduction ..............................................................................................1 Installation ................................................................................................2 Wiring .......................................................................................................5 Front Panel Release ................................................................................6 Operation ..............................
ページ4に含まれる内容の要旨
MP6512i ii
ページ5に含まれる内容の要旨
MP6512i INTRODUCTION Congratulations on your purchase of the Jensen MP6512i Mobile Receiver. • SD Card - Playback of MP3 and WMA files It’s a good idea to read all of the instructions before beginning the • 3.5mm Audio Only Input installation. We recommend having your Jensen MP6512i installed by a Chassis reputable installation shop. • Detachable Faceplate Features • 1.0 DIN (Import / ISO-DIN Mountable) • 8 Character / Segment Type LCD Display CD / MP3 / WMA General • ID3 Tag Compatible • Last
ページ6に含まれる内容の要旨
MP6512i UNIVERSALSERIALBUS / SAT READY CH/CA CH/CAT T MP6512i INSTALLATION This unit is designed for installation in cars, trucks and vans with an existing 2. Remove Transport Screws radio opening. In many cases, a special installation kit will be required to mount the radio to the dashboard. These kits are available at electronics TRANSPORT SCREWS supply stores and car stereo specialty shops. Always check the kit HALF application before purchasing to make sure the kit works with your veh
ページ7に含まれる内容の要旨
MP6512i Kit Installation CAUTION: For proper operation of the CD player, the chassis must be If your vehicle requires the use of an installation kit to mount this radio, mounted within 20° of horizontal. Make sure the unit is mounted within follow the instructions included with the installation kit to attach the radio to this limitation. the mounting plate supplied with the kit. 1. Wire and test the radio as outlined in the Mounting Sleeve Installation 4. Place the radio in front of the das
ページ8に含まれる内容の要旨
MP6512i Removing the Radio To remove the radio after installation, remove the trim ring by lifting in the center and pulling it off from either side. Insert the removal keys straight back until they lock, then pull the radio out. If removal keys are inserted at an angle, they will not lock properly and will not release the unit. Technical Assistance If you require assistance, contact Technical Support at 1-800-323-4815 from 8:30am to 7:00pm EST Monday through Friday and from 9:00am to 5
ページ9に含まれる内容の要旨
MP6512i WIRING NOTE: The amplifier in this radio is only designed for use with four speakers. Never combine (bridge) outputs for use with two speakers. Never ground negative speaker leads to chassis ground. Failure to wire exactly as shown may cause electrical damage to DATA BUS the radio. NOTE: Only connect speakers with a nominal impedance of 4 DATA BUS ohms. Speakers with a load impedance less than 4 ohms could damage the unit. SAT L SAT R SAT R (Red) Rear Line out Gray L (White) F
ページ10に含まれる内容の要旨
MP6512i FRONT PANEL RELEASE The open button (1) releases the mechanism that holds the front panel to the chassis. Detaching the Front Panel To detach the front panel: 1. Press and hold the power button (2) to turn the unit off. 2. Press and hold the open button (1). The panel will slide down. 3. Pull to release the right side of the panel. 4. Pull the left side of the panel to remove it. 5. After removing the front panel, store it in the supplied carrying case and take it with you when you le
ページ11に含まれる内容の要旨
MP6512i OPERATION Power Press the power button (2) to turn the unit on. Press and hold the power MP6512i button again to turn the unit off. UNIVERSALSERIALBUS / SAT NOTE: LCD panels may take longer to respond when subjected to cold READY temperatures for an extended period of time. In addition, the visibility of the numbers on the LCD may decrease slightly. The LCD display will return to normal when the temperature increases to a normal range. Source Press the SRC button (7) to select a di
ページ12に含まれる内容の要旨
MP6512i Mid-Range Balance To adjust Mid-Range options, press the MENU button (22) to access the To adjust the balance from “12L” (full left) to ”12R” (full right), press the audio menu. Turn the rotary encoder until “MID” appears in the display. MENU button (22) to access the audio menu. Turn the rotary encoder until Press the MENU button repeatedly to access the following Mid-Range “BAL” appears in the display. Press the MENU button once to select “BAL” settings: and then turn the rotary enc
ページ13に含まれる内容の要旨
MP6512i select “OFF”, “LOW”, “MID” or “HIGH”. When activated, “LOUDNESS” Brightness Adjustment appears on the display panel. This option allows you to adjust the brightness of the LCD screen. Turn the rotary encoder to select a brightness level between “1” and “8”, with “8” Local/Distant Reception (LO/DX) being the brightest. When the Local function is on, only radio stations with a strong signal are played. To activate Local reception mode, press the LO/DX button (6). Clock Set 1. Press and
ページ14に含まれる内容の要旨
MP6512i TUNER OPERATION The MP6512i allows you to receive channels in U.S.A. or EUROPE mode. Preview Scan See “Frequency Spacing (AREA SET)” on page 9 to learn how to change Press the SCAN button (16) to scan all strong stations in the current band. the tuner options. The unit will stop at each station for five seconds before continuing to the next station. Press SCAN again to stop scanning and listen to the current station. Automatic Store (AS) MP6512i UNIVERSALSERIALBUS Select six strong s
ページ15に含まれる内容の要旨
MP6512i • Language • Religious Music • Religious Talk • Personality • Public • College • Weather • Emergency Test • Emergency To search for stations in a PTY category: 1. Press the PTY button (17) to view the current PTY category. 2. Use the TUNE/TRACK >>| or |<< buttons (19) to move through the list of available categories. 3. After 2 seconds of inactivity, the radio will automatically scan and play the first station it locates in the selected category. NOTE: PTY is a new broadcast technolog
ページ16に含まれる内容の要旨
MP6512i CD PLAYER OPERATION Insert CD Intro Scan (INT) 1. Press the OPEN/EJECT button (1) and the motorized front panel will During disc play, press the INT button (9) to select “INT ON” and play the slide down automatically to display the disc slot. first 10 seconds of each track on the disc. When the desired track is • If a disc is already present, it will be ejected. Remove the ejected reached, press INT again to end the scan and play the selected track. disc before proceeding. Repeat (RPT)
ページ17に含まれる内容の要旨
MP6512i MP3/WMA OPERATION MP3 and WMA (Windows Media Audio) music files are digital audio files MP3/WMA Encoder and CD Writer Settings that are compressed to allow more files on a single CD. This unit can play Use the following settings when compressing audio data with the MP3 MP3/WMA directly from files contained on a CD-R/RW, SD card or USB encoder. device using the buttons on the receiver (or optional remote control) as • Transfer bit rate: 8 - 320 kbps described below. Many types of soft
ページ18に含まれる内容の要旨
MP6512i Bit Rates Loading an SD Card Insert the SD card, label side down, into the SD slot on the front of the The unit supports bit rates from 32 - 320 kbps. 2 MediaLink . The unit will read the files on the card automatically. The “SD” MP3 Playing Order card icon flashes when an SD card is being read. When selected for play, files and folders (Folder Search, File Search or Folder Select) are accessed in the order they were written by the CD writer. 3.5mm As a result, the order in which the
ページ19に含まれる内容の要旨
MP6512i Track Select Press the TUNE/TRACK >>| or |<< buttons (19) for less than one second to MP6512i UNIVERSALSERIALBUS advance to the next track on the source, or for more than one second to fast forward or fast reverse through the track. Playback begins when the button / SAT is released. READY Navigating Folders Press the folder UP (13) button (also the “5” button) to advance 10 songs. Press the folder DN (12) button (also the “6” button) to move 10 songs in reverse. Press and hold the f
ページ20に含まれる内容の要旨
MP6512i MP3/WMA File or Folder Search The unit offers three methods of searching for files or folders on a disc. Direct Track Search 1. Press the AS button (15) to activate the Track Search function. The LCD will display "TRK SCH". 2. Press the MENU (Enter) button (22) to confirm. 3. Turn the rotary encoder (22) to select the third digit. 4. Press MENU to confirm and move to the second digit position. 5. Turn the rotary encoder to select the second digit. 6. Press MENU to confirm and move t