ページ1に含まれる内容の要旨
CT-X408 n
STEI?EO CAR CASSETTE RECEIVER
RADIO-CASSETTE ESTEREOFONICO PARA AUTOMOVIL
OWNER’S RECORD
For your convenience, record the model number and
serial number (you will find them on the right side of
yourset) inthespace provided below. Please referto
them when you contact your AIWA dealer in case of
difficulty.
Model NO. ICT-X40B
Serinl No. ~
ページ2に含まれる内容の要旨
NOTE Welcome This equipment has been tested and found to Thank you for your purchasing thisAIWA product. comply with the timits for a Class B digital device, To optimize the performance of this unit, please pursuant to Part 15 of the FCC Rules. These read through this manual carefully. limits are designed to provide reasonable protection against harmful interference in a In addition to this operating instructions manual, residential installation. be sure to refer to the separate installation and
ページ3に含まれる内容の要旨
TABLE OF CONTENTS FRONT PANEL ................................................................................................................................... 3 DETACHING AND AITACHING THE FRONT PANEL ...................................................................... 4 SETTING THE BEEP TONE ............................................................................................................... 5 SETTING THE CLOCK .....................................................................
ページ4に含まれる内容の要旨
FRONTPANEL Display window @ DISP (display) button @H-BASS button @LO (local/DX) button @ PWR (power on/off) button @CD IN button @ SEL (select) button @Band indicator @ +/- (audio control) button @Main display section @EJECT = button @H BASS indicator @ Caaaette compartment @ST (stereo) indicator @DIRECTION 4+/- button @ CRP (CD changer ready position) @BAND button indicator @ CRP (CD changer ready position) button @LO (local) indicator @& (release) button @AM/PM indicator @TUNE Y/A buttons @Aud
ページ5に含まれる内容の要旨
Attaching the front pansl DETACHING AND / ATTACHING THE FRONT PANEL 2 1 You can detach the front panel from the unit and SecurilyLamp carry it with you when you leave your car When the front panel is detached, you can find an unattended. LED lamp on the front side of the unit. This lamp When you carry the front panel out of your car, is designed to deter theft, and continues to flash use the supplied earring case. when the car’s ignition is turned off with the front Before detaching the front pa
ページ6に含まれる内容の要旨
SETTING THE CLOCK SETTING THE BEEP TONE The unit is preset at the factory to beep each time 1 3 you press any button on the front panel except OPEN. You can stop beeping by following the procedure below. 2;4 1 Press PWR. [@cl -i EKIl 2 Press and hold down DISP for more than 1.5 seconds until the clock 1 With the unit off, press 1 and 4 at the indication flashes. same time. ● If you do not proceed with step 3 within 5 The “BEEP indication appears. seconds, the clock indication disappears. Each ti
ページ7に含まれる内容の要旨
PWR TUNE VIA RADIO OPERATION 1 32 LO LO (local/DX) button You can use Local mode when you wish to tune in only strong stations during seek tuning. In Radio mode, press LO to select Local mode. The 4 “LO” indicator lights up. ● Press LO to deactivate Local mode and switch 1 Press PWR to turn the unit on. to DX (distance) mode. The radio frequency appears. ● The “ST” (stereo) indicator lights up when the 2 Press BAND to select the band from tuned-in station is broadcasting in stereo and among FM1,
ページ8に含まれる内容の要旨
PRESETTING STATIONS hT 1 Press BAND to select the band from among FM1, FM2, FM3 and AM. 2 Tune in the station that you wish to Press BAND to selects desired bend preset with TUNE Y or TUNE A. from among FMI, FM2, FM3 and AM. 3 Press one of the preset station buttons FM 1 1 to 6 for approximately 1.5 seconds. I r-l /“”-/ / The number of the pressed preset station / /.../ /.../. / I I button appears next to the frequency indication. Press and hold A.ME for more than 1.5 seconds to activate the aut
ページ9に含まれる内容の要旨
TAPE PLAYBACK 1 2 I Irreert a caasette to start playback. 1 Press BAND to selects desired band Playbackstartsinthe directionthatthe unit from among FM1, FM2, FM3 and AM. playedbackpreviously. Press thedeeired txeaet station button. 2 The number of the-pressed preset station button is displayed next to the frequency indication. z Adjust the volume with +/-. Activetuningreceptioncontrol(ATRC) This unit automatically suppresses FM noise Press the following buttons to operate tape caused by varying
ページ10に含まれる内容の要旨
TAPE PLAYBACK SOUNDADJUSTMENTS Auto reversefunction 12 When the end of the tape is reached during playbackor fast tape transport,the directionof thetapeisautomatically reversed,andplayback startsagain. Tapadirectionindications MUTE 1 Press SEL to select the mode that You wish to adjust from: VOL (volume), BAS w 8 , (bass), TRE (trebie), BAL (baiance) and Lower side FAD (fader). + 24” The followingindicationsappear in cyclic ‘f \\’ order, Beforeturningthe ignitionoff pwlblh’ +; RMWL!.+F7WJ Be sur
ページ11に含まれる内容の要旨
MUTEbutton Pressthisbuttontotemporarily Iowerthevolume. CRP (CD changer ready Pressit againto restorethe previousvolume. oosition) You can enjoy CD changer play in combination You can enjoy music with strong bass sound. with your RF-CD-changer system with easy operation. H-BASS 24 1 Press H-BASS to obtain powerful bass. The “H BASS” indicator lights up. Each time you press H-BASS, this function turns on or off. \ / , 3 1 Press PWR to turn the unit on. The radio frequency indication appears. 2 Pr
ページ12に含まれる内容の要旨
CRP (CD changer ready position) CONNECTING A PORTABLE CD PLAYER OR OTHER EQUIPMENT 14 2 This unit is equipped with the line-level input (CD IN) jack enabling high quality of the sound. 31 (1 I 11 ~ 1 Press PWR to turn the unit on. If a cassette is inserted, remove it to prevent possible damage to the unit. z Press CRP to switch the unit to CRP mode. 2 4 The “CRP” indicator lights up. s PlayaCDwith yourCDchangersyatem. 1 ff a csssette ie inserted, remove it to prevent poesibfe dsmage to the unit.
ページ13に含まれる内容の要旨
MAINTENANCE SPECIFICATIONS Cleaningthefrontpanel RADIO SECTfON When thefrontpanelissoiled,wipethe surface (FM) of the panelwitha dryand softcloth. FrequencyRange: S7.5 MHz–108 MHz (100-kHz steps) Cleaningthetapehead 87.5 MHz–108 MHz Use a cleaningcassetteto clean the playback $50& steps) headandcapstansapproximately oncea month. Usable Sensitivity 50 dB Quieting Sensitivity Ifthe playbackheadisdirty,the hightonesmay 17.2 dBf notbe reproducedproperly. IF Rejection: 80 dB Frequency Response 30 Hz–
ページ14に含まれる内容の要旨
ページ15に含まれる内容の要旨
ページ16に含まれる内容の要旨
88-KTD-903-01 9801 O9BTM-O)( AIWA CO.,LTD.
