ページ6に含まれる内容の要旨
Overview of the system ab cd e tsrq po nm lk jihf g uv a f MP3-LINK • Unlock the front panel. • Connect to the audio output socket (usually the headphone socket) of an b external device. • For .wma and .mp3 tracks, press to select the previous folder. g • Press and hold to access the system • Start, pause, or resume the play of menu. tracks. • Press to select a tuner band. • In radio mode, press to select the preset radio station of No. 6. c • In radio mode, press and hold to store
ページ7に含まれる内容の要旨
h m /DSP • In radio mode, press to select the • Press repeatedly to display available preset radio station of No. 5. information about the current track. • In radio mode, press and hold to store the • Press repeatedly to display available current radio station at channel No. 5. RDS information. • Press and hold to display the set clock. i • In radio mode, press to select the n AS/SOURCE preset radio station of No. 4. • Press repeatedly to select a source. • In radio mode, press and hold to s
ページ8に含まれる内容の要旨
t BAND • Press repeatedly to select a tuner band. u Slot for SD/SDHC card • Insert an SD/SDHC card. v RESET • Press to reset the system to factory default settings. 6 EN
ページ9に含まれる内容の要旨
3 Install the car Connect wires audio system Note • Make sure that all loose leads are insulated with electrical tape. Caution • Consult a professional to connect wires as instructed below. • Use the controls only as stated in this user manual. 1 Check the car's wiring carefully and Always follow the instructions in this chapter in connect them to the the ISO male sequence. connectors. These instructions are for a typical installation. However, if your car has different requirements, mak
ページ10に含まれる内容の要旨
183 mm ISO male Connect to Mount into the dashboard connectors i Yellow strip To the +12V car • If the car does not have an on-board drive battery which is or navigation computer, disconnect the energized at all times negative terminal of the car battery. • If the car battery is not disconnected, to 2 Connect the antenna and amplifier as avoid short-circuit, make sure that the bare illustrated, if applicable. wires do not touch each other. 1 Make sure that the car dashboard opening is w
ページ11に含まれる内容の要旨
53.5 mm 183 mm 3 Install the sleeve into the dashboard and 5 Attach the trim plate. bend the tabs outward to fix the sleeve. 6 Reconnect the negative terminal of the car battery. 4 Slide the unit into the dashboard until you hear a "click". Attach the front panel 1 Insert the notch on the front panel to the chassis on the main unit. 2 Press the left end of the front panel inwards until it is securely locked with a "click". EN 9
ページ12に含まれる内容の要旨
Detach the front panel Note • Before you insert an SD/SDHC card or reset the system, detach the front panel. • Before you detach the front panel, make sure that the system is turned off. 1 Press to release the front panel. 2 Pull the front panel outwards to remove it. 10 EN
ページ13に含まれる内容の要旨
4 Get started Set the clock 1 Press and hold to access the system menu. 2 Press / repeatedly until [CLK] is For the first time use displayed with time digits blinking. 3 Rotate anti-clockwise to set the hour. 1 Press to turn on the system. 4 Rotate clockwise to set the minute. » [PHILIPS] is displayed and then [SELECT OPERATING REGION] (select a radio region) scrolls. Display the clock 2 When one of the following options is Press and hold /DISP until [CLK] and the set displayed, rot
ページ14に含まれる内容の要旨
Mute the button beep The beep sound of buttons is enabled by default. 1 Press and hold to access the system menu. 2 Press / repeatedly until [BEEP ON] or [BEEP OFF] is displayed. • [BEEP ON]: Enable the beep sound of buttons. • [BEEP OFF]: Mute the beep sound of buttons. 3 Rotate to change the setting. 12 EN
ページ15に含まれる内容の要旨
5 Listen to radio Search for a radio station Search for a radio station automatically Select a tuner region Press or to search for the previous or next radio station with strong signals. You can select a radio region that matches your location. 1 In radio mode, press and hold to access Search for a radio station manually the system menu. 1 Press and hold or until [M] blinks. 2 Press / repeatedly until one of the 2 Press or repeatedly until the following options is displayed. targe
ページ16に含まれる内容の要旨
2 Press / repeatedly until [PTY] is Store radio stations manually displayed. 1 Press BAND, , or repeatedly to 3 Press to access the list of program select a tuner band. types. 2 Tune to the radio station that you want to 4 Rotate to select a program type, and store. then press to confirm. 3 Press and hold , , , , Item Program Description , or to store the radio station at the type selected channel. 1 NEWS News services • To select a stored radio station, press 2 AFFAIRS Politics
ページ17に含まれる内容の要旨
Item Program Description 3 Rotate to select a setting. type • [TA ON]: When a traffic announcement is on air, the system 30 TEST Alarm Test automatically switches to the tuner 31 ALARM Alarm mode and begins to broadcast the traffic announcement. When the traffic announcement is over, the system Use alternate frequencies returns to the previous mode. If the signal of an RDS station is poor, enable • [TA OFF]: Traffic announcement does the AF (Alternate Frequency) function to search not cu
ページ18に含まれる内容の要旨
6 Play from a Control play storage device Button Function Press repeatedly to select a folder. / Pause or resume play. / Press to play the previous or next track. / Press and hold to rewind a track or search forward fast. Press repeatedly to display /DISP available information about the current track. Press repeatedly to select a repeat mode: • [REP ONE]: repeat the current track, • [RPT FLD]: repeat all tracks in the current folder, or • [RPT ALL]: repeat all tracks in the st
ページ19に含まれる内容の要旨
Switch tracks During play, you can switch tracks or folders quickly. Switch tracks directly 1 Press to access the track list. » The file name of current track scrolls. 2 Rotate to toggle through tracks. 3 Press to play the selected track. Switch folders for a track 1 Press to access the folder list. » The name of current folder scrolls. 2 Rotate to toggle through folders. 3 Press to select the folder. » The system starts playing the first track under the folder. EN 17
ページ20に含まれる内容の要旨
7 Listen to an external device You can use the system to amplify the audio input from an external device, for example, MP3 player. MP3-LINK 1 Switch the source to [MP3--LINK]. 2 Connect an MP3 link cable to • the MP3-LINK socket on the system, and • the audio output socket (usually the headphone socket) on the external device. 3 Play the external device. 18 EN
ページ1に含まれる内容の要旨
Always there to help you
Register your product and get support at
www.philips.com/welcome
CE132
Question?
Contact
Philips
User manual
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
Contents Contents 1 Safety 2 10 Product Information 21 2 Your car audio system 3 11 Troubleshooting 22 Introduction 3 What's in the box 3 12 Notice 23 Overview of the system 4 Care of the environment 23 Trademark notice 23 3 Install the car audio system 7Copyright 23 Connect wires 7 Mount into the dashboard 8 13 Glossary 24 Attach the front panel 9 4 Get started 11 For the first time use 11 Set the time format 11 Set the clock 11 Select a source 11 Select a listening zone 11 Mute the button beep
ページ4に含まれる内容の要旨
1 Safety Read and understand all instructions before you use this device. If damage is caused by failure to follow instructions, the warranty does not apply. • Modification of the product could result in hazardous radiation of EMC or other unsafe operation. • The device is designed for negative ground (earth) 12 V DC operation only. • To ensure safe driving, adjust the volume to a safe and comfortable level. • Improper fuses can cause damage or fire. When you need to change the fuse, con
ページ5に含まれる内容の要旨
• ID3 tag V2.0 or later 2 Your car audio • Unsupported files: AAC, WAV, and PCM files system DRM protected WMA files (.wav, .m4a, .m4p, .mp4, and .aac) WMA files in lossless format Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product What's in the box at www.philips.com/welcome. Check and identify the contents of the package: Introduction ab c With this system, you can: • enjoy audio from USB storage devices,
