ページ1に含まれる内容の要旨
GE Appliances
Safety Information . . . . . . . . . 3
Owner’s Manual
and Installation
Operating/Care and
Instructions
Cleaning Instructions
Charcoal Filters . . . . . . . . . . . . .5
JV535
Grease Filters . . . . . . . . . . . . . . .4
JV536
Hood Lights . . . . . . . . . . . . . . . .5
Hood Surfaces . . . . . . . . . . . . . .5
JV565
Stainless Steel Surfaces . . . . . . .5
JV566
Vent Controls . . . . . . . . . . . . . . .4
JV635
JV636
Installation
JV665
Instructions . . . . . . . . . . . .6–14
ページ2に含まれる内容の要旨
GE & You, A Service Partnership. IMPORTANT! Fill out the Consumer Product Registration Card. Two easy ways to register your appliance! n Through the internet at www.geappliances.com n Complete and mail the enclosed Product Registration Card FOR YOUR RECORDS Write the model and serial numbers here: # # You can find them on a label on the back wall of the hood. Staple sales slip or cancelled check here. Proof of the original purchase date is needed to obtain service under the warranty. READ THIS
ページ3に含まれる内容の要旨
Safety Instructions Operating Instructions Installation Instructions Customer Service IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING. SAFETY PRECAUTIONS WARNING – TO REDUCE THE RISK OF WARNING – TO REDUCE THE RISK OF A FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS, RANGE TOP GREASE FIRE: OBSERVE THE FOLLOWING: A. Never leave surface units unattended at high A. Use this unit only in the manner intended settings. Boilovers cause smoking and greasy by the manufacturer. If you have que
ページ4に含まれる内容の要旨
Using the hood controls. Throughout this manual, features and appearance may vary from your model. Your model will have one of the above type of controls. FAN Control LIGHT Control Turn or press (according to your model) the FAN Turn or press (according to your model) the LIGHT speed control to LO, MED, HI or BOOST, as needed. control to BRIGHT for bright light while cooking. Turn or press to NITE for use as a night light. Continuous use of the fan system while cooking helps keep the kitchen co
ページ5に含まれる内容の要旨
Safety Instructions Operating Instructions Installation Instructions Customer Service Charcoal Filters (on some models) If the model is not vented The charcoal filters The charcoal filters to the outside, the air will should be replaced when cannot be cleaned. They must be replaced. be recirculated through they are noticeably dirty disposable charcoal or discolored (usually For 30† hood models, order filters that help remove after 6 to 12 months, Kit no. WB02X10707. smoke and odors. depending o
ページ6に含まれる内容の要旨
Range Hood Installation Models JV535 JV635 JV536 JV636 Instructions JV565 JV665 JV566 JV666 Questions? Visit our Website at: www.geappliances.com or Call GE Answer Center at 800.626.2000 DUCTWORK REQUIREMENTS BEFORE YOU BEGIN NOTE: Read the ductwork sections only if you do not Read these instructions completely and carefully. have existing ductwork. If you have existing ductwork, • skip to the “Damage” section and proceed. IMPORTANT Save these – instructions for local inspector’s use. The v
ページ7に含まれる内容の要旨
Installation Instructions Follow the guidelines for proper duct sizing in the ducting charts. DUCTING CHART–JV5 Series Models Equivalent Length in Feet 0 25 50 75 100 125 150 250 • • • 200 • • 7† Round • • 150 • • 1 3 ⁄4† x 10† • Rectangular 100 1 3 ⁄4† x 10† Rectangular Transition to 6† Round = 4.5 ft. 7† Round 90° Elbow = 8 ft. 7† Roof Cap = 30 ft. DUCTING CHART–JV6 Series Models Equivalent Length in Feet 0 25 50 75 100 125 150 400 • 350 • 7† Round • • • 300 • • • 250 • 1 3 ⁄4† x 10† • Rectang
ページ8に含まれる内容の要旨
Installation Instructions WORKSHEET – CALCULATE TOTAL EQUIVALENT DUCTWORK LENGTH DUCT EQUIVALENT NUMBER DUCT EQUIVALENT NUMBER PIECES LENGTH x USED = TOTAL PIECES LENGTH x USED = TOTAL 1 3 ⁄4† x 10† 1 Ft. x ( ) = Ft. 6† Round 34 Ft. x ( ) = Ft. Rect., wall cap (6 ft. w/o straight with damper) x ( ) = Ft. damper 7† Round, 1 Ft. x ( ) = Ft. straight 6† Round 30 Ft. x ( ) = Ft. roof cap 6† Round, 1 Ft. x ( ) = Ft. straight 6† Round 5.5 Ft. x ( ) = Ft. to
ページ9に含まれる内容の要旨
Installation Instructions DAMAGE – SHIPMENT/INSTALLATION TOOLS YOU WILL NEED • If the unit is damaged in shipment, return the unit to the store in which it was bought for repair or replacement. • If the unit is damaged by the customer, repair or Flat blade and Phillips Pencil replacement is the responsibility of the customer. screwdrivers Duct tape • If the unit is damaged by the installer (if other than the customer), repair or replacement must be made by arrangement between customer and instal
ページ10に含まれる内容の要旨
Installation Instructions 1 CHOOSE VENT OPTION Outside rear exhaust C The outside vent exhaust option that your installation 1 (Horizontal duct–3 ⁄4† x 10† requires will determine the hood knockouts that you Rectangular) will use. If the hood is to be installed in a recirculating, non- vented ductless manner, do not knock out any vent openings in the hood. Only an electrical access hole will be knocked out of the hood. NOTE: Only JV5 Series models may be recirculated. We do not recommend the r
ページ11に含まれる内容の要旨
Installation Instructions 2 REMOVE EXHAUST ADAPTOR 5 REMOVE OTHER EXHAUST ADAPTOR Remove the 7† round exhaust adaptor from the top of 1 Remove the 3 ⁄4† x 10† rectangular exhaust adaptor the hood. Set it aside along with its mounting screws. from inside the hood. Set it aside along with its mounting screws and parts bag. Depending on the model, the exhaust adaptor will be located on the left or right side. 7† round exhaust adaptor 1 1 3 ⁄4† x 10† 3 ⁄4† x 10† rectangular rectangular exhaust ada
ページ12に含まれる内容の要旨
Installation Instructions 1 10 8 FOR 3 ⁄4† X 10† RECTANGULAR REMOVE DUCT KNOCKOUT(S) If recirculating, non-vented ductless (optional for DUCTED DISCHARGE JV5 Series models only), see note below and skip to INSTALLATIONS ONLY: Step 12 D and proceed. We do not recommend the Attach exhaust adaptor/damper over knockout recirculated configuration for JV6 Series models. opening with two exhaust adaptor screws. Make sure Using a flat blade screwdriver, remove the appropriate damper pivot is nearest t
ページ13に含まれる内容の要旨
Installation Instructions D.Recirculating (non-vented ductless– 12 MARK HOLES Available on JV5 Series models only) Select the vent option that your installation will require and proceed to that section: • Use the hood as a template and mark the locations on the cabinet for the electrical wiring and keyhole screw slots. A.Outside top exhaust 1 (Vertical duct–3 ⁄4† x 10† Rectangular) • Since the hood is to be recirculated (not to be vented outside), do not cut out any vent openings in the wall •
ページ14に含まれる内容の要旨
Installation Instructions 22 CONNECT WIRING 18 SECURE HOOD Connect house black to hood black wire, house Slide the hood back against the wall. Tighten white to hood white wire, and house ground under the mounting screws. Be sure the screw heads green ground screw. Securely tighten the strain are in the narrow neck of the keyhole slot. relief clamp onto the house wiring. Green ground screw Mounting screw (4) Keyhole (4) NOTE: DO NOT PUSH ON FAN BLADE. Pushing 23 REPLACE WIRING COVER on the blade
ページ15に含まれる内容の要旨
Safety Instructions Operating Instructions Installation Instructions Customer Service GE Range Hood Warranty All warranty service provided by our Factory Service Centers ® or an authorized Customer Care technician. For service, call 800-GE-CARES. For The Period Of: GE Will Replace: One Year Any part of the range hood which fails due to a defect in materials or workmanship. From the date of the During this full one-year warranty, GE will also provide, free of charge, all labor and original pur
ページ16に含まれる内容の要旨
Service Telephone Numbers. ® GE Answer Center 800.626.2000 The GE Answer Center® is open 24 hours a day, 7 days a week. OR Visit our Website at: www.geappliances.com In-Home Repair Service 800-GE-CARES (800-432-2737) Expert GE repair service is only a phone call away. Special Needs Service 800.626.2000 800-TDD-GEAC (800-833-4322) GE offers, free of charge, a brochure to assist in planning a barrier-free kitchen for persons with limited mobility. Service Contracts 800-626-2224 Purchase a GE se
